Impact of Lime, Cement, and Clay Treatments on the Internal Erosion of Compacted Soils
Publication: Journal of Materials in Civil Engineering
Volume 28, Issue 9
Abstract
The aim of this paper is to study the impact of certain soil treatments on the internal erosion characteristics of treated compacted silt. The experiments measured the internal erosion using the hole erosion test (HET). This study aims to describe the effects of clay, lime and cement soil treatments on the internal erosion, specifically with regard to the amount of treatment used and the curing time. A new enhanced HET was developed to apply a high inlet pressure up to 650 kPa and thus generate a hydraulic shear stress up to 10,000 Pa. The internal erosion resistance was quantified by the coefficient of soil erosion and the critical shear stress. The results demonstrated that clay treatment could reduce the coefficient of soil erosion depending on the nature and percentage of clay added to the soil. The results also showed that lime and cement treatment primarily increased the critical shear stress of the tested silt. This increase was higher with cement treatment and was dependent on the amount of the added product. The impact of the curing time (up to 30 days) on the evolution of the erosion characteristics was not relevant for the lime-treated silt, whereas that of the cement-treated silt was dependent on the amount of cement added to the soil.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank S. Bonne, E. Lavallée and T. Le Borgne from DTP—Bouygues Construction—France for their valuable support of this study.
References
Al-Amoudi, O. S. B. (2002). “Characterization and chemical stabilization of Al-Qurayyah sabkha soil.” J. Mater. Civ. Eng., 478–484.
ASTM. (1998a). “Standard test method for identification and classification of dispersive clay soils by the pinhole test.” ASTM D4647-98, West Conshohocken, PA, 11.
ASTM. (1998b). “Standard test method for laboratory compaction characteristics of soil using standard effort.” ASTM D698-98, West Conshohocken, PA, 8.
Attom, M. (2012). “The effect of compaction condition and initial water content on soil erosion.” Int. Conf. Scour Erosion, ICSE6, Societe Hydrotechnique de France, Paris, 49–56.
Bell, F. G. (1996). “Lime stabilization of clay minerals and soils.” Eng. Geol., 42(4), 223–237.
Bellezza, I., and Fratalochi, E. (2006). “Effectiveness of cement on hydraulic conductivity of compacted soil-cement mixtures.” Ground Improv., 10(2), 77–90.
Benahmed, N., and Bonelli, S. (2007). “Etude expérimentale de l’érosion interne d’une kaolinite.” 25e Rencontres de l’AUGC 2007, AUGC, Bordeaux, France, 8.
Benahmed, N., and Bonelli, S. (2012). “Investigation concentrated leak erosion behaviour of cohesive soils by performing hole erosion tests.” Eur. J. Environ. Civ. Eng., 16(1), 43–58.
Bennabi, A., Karoui, T., Benamar, A., and Wang, H. Q. (2012). “Some elements of comparison between two laboratory devices for soil erosion testing.” Int. Conf. on Scour and Erosion, ICSE6, Societe Hydrotechnique de France, Paris, 1089–1096.
Benson, C. H., and Daniel, D. E. (1990). “Influence of clods on hydraulic conductivity of compacted clay.” J. Geotech. Eng., 1231–1248.
Brandl, H. (1981). “Alteration of soil parameters by stabilization with lime.” Proc., 10th Int. Conf. on Soil Mechanics and foundation Engineering, Vol. 3, Swedish National Road and Transport Research Institute, Sweden, 587–594.
Chapuis, R. P. (2002). “The 2000 R. M. Hardy lecture: Full-scale hydraulic performance of soil-bentonite and compacted clay liners.” Can. Geotech. J., 39(2), 417–439.
Chevalier, C., Haghighi, I., and Herrier, G. (2012). “Resistance to erosion of lime treated soils: A complete parametric study in laboratory.” Int. Conf. on Scour and Erosion, ICSE6, Societe Hydrotechnique de France, Paris, Paris, 1065–1072.
Consoli, N. C., Lopes, L. D. S., Prietto, P. D. M., Festugato, L., and Cruz, R. C. (2011). “Variables controlling stiffness and strength of lime-stabilized soils.” J. Geotech. Geoenviron. Eng., 628–632.
Cuisinier, O., Auriol, J. C., Le Borgne, T., and Denelle, D. (2011). “Microstructure and hydraulic conductivity of a compacted lime-treated soil.” Eng. Geol., 123(3), 187–193.
Eades, J. L., and Grim, R. E. (1966). “A quick test to determine lime requirements for lime stabilization.” Highway Res. Board Bull., 139, 61–72.
Farrar, J. A., Torres, R. L., and Erdogan, Z. (2007). “Bureau of reclamation erosion testing for evaluating piping and internal erosion of dams.” Geotech. Spec. Publ., 167(3), 22–31.
Fell, R., Wan, C. F., Cyganiewicz, J., and Foster, M. (2003). “Time for development of internal erosion and piping in embankment dams.” J. Geotech. Geoenviron. Eng., 307–314.
Haghighi, I. (2012). “Characterization of erosion phenomena and dispersion of soils: Tests development and practical applications.” Ph.D. thesis, Ecole Nationale des Ponts et Chaussées, Paris (in French).
Haghighi, I., Chevalier, C., Duc, M., Guédon, S., and Reiffsteck, P. (2013). “Improvement of hole erosion test and results on reference soils.” J. Geotech. Geoenviron. Eng., 330–339.
Herrier, G., Chevalier, C., Froumentin, M., Cuisinier, O., Bonelli, S., and Fry, J. J. (2012). “Lime treated soil as an erosion-resistant material for hydraulic earthen structures.” Int. Conf. on Scour and Erosion, ICSE6, Societe Hydrotechnique de France, Paris, 585–592.
Indraratna, B., Muttuvel, T., and Khabbaz, H. (2009). “Modelling the erosion rate of chemically stabilized soil incorporating tensile force-deformation characteristics.” Can. Geotech. J., 46(1), 57–68.
Lefebvre, G., Rohan, K., and Douville, S. (1985). “Erosivity of natural intact structured clay: Evaluation.” Can. Geotech. J., 22(4), 508–517.
Le Runigo, B., Cuisinier, O., Cui, Y.-J., Ferber, V., and Deneele, D. (2009). “Impact of initial state on the fabric and permeability of a lime-treated silt under long-term leaching.” Can. Geotech. J., 46(11), 1243–1257.
Lim, S. S. (2006). “Experimental investigation of erosion in variably saturated clay soils.” Ph.D. thesis, Univ. of New South Wales, Australia, 171.
Luthi, M., Fannin, R. J., and Milar, R. G. (2012). “A modified hole erosion test (HET-P) device.” Geotech. Test. J., 35(4), 660–664.
McCallister, L. D., and Petry, T. M. (1991). “Physical property changes in a lime-treated expansive clay caused by leaching.” Transp. Res. Rec., 1295, 37–44.
Mitchell, J. K., Hooper, D. R., and Campanella, R. G. (1965). “Permeability of compacted clays.” J. Soil Mech. Found. Div., 91, 41–65.
Muttuvel, T. (2008). “Erosion rate of chemically stabilized soils incorporating tensile stress-deformation behaviour.” Ph.D. thesis, Univ. of Wollongong, Wollongong, Australia, 202.
Oliveira, V. P., Correia, A., and Garcia, M. (2013). “Effect of stress and binder composition on secondary compression of an artificially stabilized soil.” J. Geotech. Geoenviron. Eng., 810–820.
Pedarla, A., Chittoori, S., Puppala, A., Hoyos, L., and Saride, S. (2010). “Influence of lime dosage on stabilization effectiveness of montmorillonite dominant clays.” GeoFlorida 2010: Advances in Analysis, Modeling & Design, ASCE, Reston, VA, 767–776.
Pham, T. L. (2008). “Erosion and dispersion of clay soils par a fluid.” Ph.D. thesis, Ecole Nationale des Ponts et Chaussées, Paris (in French).
Reddi, L. N., Lee, I. M., and Bonala, M. V. S. (2000). “Comparison of internal and surface erosion using flow pump tests on a sand-kaolinte mixture.” Geotech. Test. J., 23(1), 116–122.
Robin, V., Javadi, A. A., Cuisinier, O., and Masrouri, F. (2015). “An effective constitutive model for lime treated soils.” Comput. Geotech., 66, 189–202.
Rogers, C., Boardman, D., and Papadimitriou, G. (2006). “Stress path testing of realistically cured lime and lime/cement stabilized clay.” J. Mater. Civ. Eng., 259–266.
Rohan, K., Lefebvre, G., Douville, S., and Milette, J. P. (1986). “A new technique to evaluate erosivity of cohesive material.” Geotech. Test. J., 9(2), 87–92.
Russo, G., and Modoni, G. (2013). “Fabric changes induced by lime addition on a compacted alluvial soil.” Géotech. Lett., 3(2), 93–97.
Sariosseiri, F., and Muhunthan, B. (2009). “Effect of cement treatment on geotechnical properties of some Washington state soils.” Eng. Geol., 104(1–2), 119–125.
SETRA-LCPC. (2000). “Soils treatments with lime and and/or hydraulic binders (GTS)—Applications to the realization of embankments and capping layers.” France (in French).
Sherard, J. L., Dunnigan, L. P., Decker, R. S., and Steele, E. F. (1976). “Pinhole test for identifying dispersive soils.” J. Geotech. Eng. Div., 102(GT1), 69–85.
Sivapillaiah, P. V., Sridharan, A., and Stalin, V. K. (2000). “Hydraulic conductivity of bentonite-sand mixtures.” Can. Geotech. J., 37(2), 406–413.
Wahl, T. (2010). “A comparison of the hole erosion test and jet erosion test.” Joint Federal Interagency Conf. on Sedimentation and Hydrologic Modeling, Federal Interagency Subcommittees on Hydrology (SOH) and Sedimentation (SOS), Advisory Committee on Water Information (ACWI).
Wan, C. F., and Fell, R. (2002). “Investigation of internal erosion and piping of soils in embankment dams by the slot erosion test and the hole erosion test.”, Univ. of New South Wales, Australia.
Wan, C. F., and Fell, R. (2004). “Investigation of rate of erosion of soils in embankment dams.” J. Geotech. Geoenviron. Eng., 373–380.
Watabe, Y., Leroueil, S., and Le Bihan, J-P. (2000). “Influence of compaction conditions on pore-size distribution and saturated hydraulic conductivity of a glacial till.” Can. Geotech. J., 37(6), 1184–1194.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Aug 27, 2014
Accepted: Dec 16, 2015
Published online: Mar 24, 2016
Discussion open until: Aug 24, 2016
Published in print: Sep 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.