Fractional Viscoelastic Study of Low-Temperature Characteristics of Biomodified Asphalt Binders
Publication: Journal of Materials in Civil Engineering
Volume 28, Issue 9
Abstract
Low-temperature cracking in pavement is a common distress in cold regions especially in North America; such distresses are shown to be highly related to binder low-temperature properties. To reduce the low-temperature cracking, several state departments of transportation are requiring the use of polymer-modified asphalt. However, polymer modification tends to be costly and in some cases led to phase separation in asphalt. Therefore, the current paper implements a fractional viscoelastic approach to study the effectiveness of several bio-based modifiers on improving asphalt binder’s low-temperature characteristics. As such, implementing the bending beam rheometer (BBR) test, low-temperature rheological characteristics of asphalt binders, which are modified by four different bio-oils including biobinder from swine manure, corn stover, wood pellet, and miscanthus pellet are investigated. For this purpose, the BBR test was performed on asphalt binder samples containing 10% modifier at three temperatures of , , and . In order to analyze results of the BBR test, a fractional viscoelastic model is used to describe the relation of creep compliance and time. Utilizing the simple fractional model, relaxation modulus, storage modulus, and loss modulus are derived. In addition to the Superpave performance grading (PG) protocol, parameters of the simple fractional viscoelastic model are used to evaluate the performance of asphalt binders at low service temperatures through damping ratio and dissipated energy ratio. While biobinder from swine manure has the best performance by Superpave PG protocol analysis, corn stover shows the highest values for damping ratio and dissipated energy ratio among all modified asphalt samples.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is sponsored in part by the National Science Foundation Award No. 1150695. The authors would like to acknowledge the support from the Sustainable Infrastructure Material (SIM) Lab at North Carolina A&T State University, which enabled experimental tests and data analysis. The contents of this paper reflect the view of the authors, who are responsible for the facts and the accuracy of the data presented.
References
Adolfsson, K., Enelund, M., and Olsson, P. (2005). “On the fractional order model of viscoelasticity.” Mech. Time Depend. Mater., 9(1), 15–34.
Aflaki, S., and Hajikarimi, P. (2012). “Implementing viscoelastic rheological methods to evaluate low temperature performance of modified asphalt binders.” Constr. Build. Mater., 36, 110–118.
Aflaki, S., Hajikarimi, P., Fini, E., and Zada, B. (2014). “Comparing effects of biobinder with other asphalt modifiers on low-temperature characteristics of asphalt.” J. Mater. Civ. Eng., 429–439.
Alvarez, J., Lopez, G., Amutio, M., Bilbao, J., and Olazar, M. (2014). “Bio-oil production from rice husk fast pyrolysis in a conical spouted bed reactor.” Fuel, 128, 162–169.
Anderson, D. A., et al. (1994). “Binder characterization and evaluation. Volume 3: Physical characterization.”, Strategic Highway Research Program, National Research Council, Washington, DC.
ASTM. (2001). “Standard test method for determining the flexural creep stiffness of asphalt binder using the bending beam rheometer (BBR).” ASTM D6648, West Conshohocken, PA.
Bahia, H. U., Anderson, D. A., and Christensen, D. W. (1992). “The bending beam rheometer: A simple device for measuring low-temperature rheology of asphalt binders.” J. Assoc. Asphalt Paving Technol., 61, 117–153.
Brinson, H. F., and Brinson, L. C. (2008). Polymer engineering science and viscoelasticity: An introduction, Springer, New York.
Celauro, C., Fecarotti, C., Pirrotta, A., and Collop, A. C. (2012). “Experimental validation of a fractional model for creep/recovery testing of asphalt mixtures.” Constr. Build. Mater., 36, 458–466.
Demirbas, A. (2008). “Conversion of corn stover to chemicals and fuels.” Energy Sources, Part A, 30(9), 788–796.
Fini, E., et al. (2011). “Chemical characterization of biobinder from swine manure: Sustainable modifier for asphalt binder.” J. Mater. Civ. Eng., 1506–1513.
Fini, E., Oldham, D., and Abu-Lebdeh, T. (2013). “Synthesis and characterization of biomodified rubber asphalt: Sustainable waste management solution for scrap tire and swine manure.” J. Environ. Eng., 1454–1461.
Gutierrez-Lemini, D. (2014). Engineering viscoelasticity, Springer, New York.
Hajikarimi, P., Aflaki, S., and Hoseini, A. S. (2013). “Implementing fractional viscoelastic model to evaluate low temperature characteristics of crumb rubber and gilsonite modified asphalt binders.” Constr. Build. Mater., 49, 682–687.
Halim, R., Danquah, M. K., and Webley, P. A. (2012). “Extraction of oil from microalgae for biodiesel production: A review.” Biotechnol. Adv., 30(3), 709–732.
Hill, B., Oldham, D., Behnia, B., Fini, E., Buttlar, W., and Reis, H. (2013). “Low-temperature performance characterization of biomodified asphalt mixtures that contain reclaimed asphalt pavement.” Transp. Res. Rec., 2371, 49–57.
Hosseinnezhad, S., Fini, E. H., Sharma, B. K., Basti, M., and Kunwar, B. (2015). “Physiochemical characterization of synthetic bio-oils produced from bio-mass: A sustainable source for construction bio-adhesives.” RSC Adv., 5(92), 75519–75527.
Imam, T., and Capareda, S. (2012). “Characterization of bio-oil, syn-gas and bio-char from switchgrass pyrolysis at various temperatures.” J. Anal. Appl. Pyrol., 93, 170–177.
Kennedy, T. W. (1994). “Superior performing asphalt pavements (superpave): The product of the SHRP asphalt research program.”, Strategic Highway Research Program, National Research Council, Washington, DC.
Kondamudi, N., Mohapatra, S. K., and Misra, M. (2008). “Spent coffee grounds as a versatile source of green energy.” J. Agric. Food Chem., 56(24), 11757–11760.
Liu, S., Cao, W., Shang, S., Qi, H., and Fang, J. (2010). “Analysis and application of relationships between low-temperature rheological performance parameters of asphalt binders.” Constr. Build. Mater., 24(4), 471–478.
Mohan, D., Pittman, C. U., and Steele, P. H. (2006). “Pyrolysis of wood/biomass for bio-oil: A critical review.” Energy Fuels, 20(3), 848–889.
Oldham, D. J., Fini, E. H., and Chailleux, E. (2015). “Application of a bio-binder as a rejuvenator for wet processed asphalt shingles in pavement construction.” J. Constr. Build. Mater., 86(1), 75–84.
Önal, E. P., Uzun, B. B., and Pütün, A. E. (2011). “Steam pyrolysis of an industrial waste for bio-oil production.” Fuel Process. Technol., 92(5), 879–885.
Petersen, J. C., et al. (1994). “Binder characterization and evaluation: Volume 1.”, Strategic Highway Research Program, National Research Council, Washington, DC.
Phalan, B. (2009). “The social and environmental impacts of biofuels in Asia: An overview.” Appl. Energy, 86(Suppl. 1), S21–S29.
Raouf, M. A., and Williams, R. C. (2010). “Rheology of fractionated cornstover bio-oil as a pavement material.” Int. J. Pavement., 9(1-2-3), 58–69.
Sanna, A., Li, S., Linforth, R., Smart, K. A., and Andrésen, J. M. (2011). “Bio-oil and bio-char from low temperature pyrolysis of spent grains using activated alumina.” Bioresour. Technol., 102(22), 10695–10703.
Tschoegl, N. W. (1989). The phenomenological theory of linear viscoelastic behavior, Springer, New York.
Uzun, B. B., Apaydin-Varol, E., Adeş, F., Özbay, N., and Pütün, A. E. (2010). “Synthetic fuel production from tea waste: Characterisation of bio-oil and bio-char.” Fuel, 89(1), 176–184.
Yang, X., You, Z., Dai, Q., and Mills-Beale, J. (2014). “Mechanical performance of asphalt mixtures modified by bio-oils derived from waste wood resources.” Constr. Build. Mater., 51, 424–431.
Zhao, S., Huang, B., Ye, X. P., Shu, X., and Jia, X. (2014). “Utilizing bio-char as a bio-modifier for asphalt cement: A sustainable application of bio-fuel by-product.” Fuel, 133, 52–62.
Zheng, J.-L., and Kong, Y.-P. (2010). “Spray combustion properties of fast pyrolysis bio-oil produced from rice husk.” Energy Convers. Manage., 51(1), 182–188.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Nov 26, 2014
Accepted: Nov 3, 2015
Published online: Apr 1, 2016
Published in print: Sep 1, 2016
Discussion open until: Sep 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.