Effect of Different Inorganic Nanoparticles on Physical and Ultraviolet Aging Properties of Bitumen
Publication: Journal of Materials in Civil Engineering
Volume 27, Issue 12
Abstract
The research reported in this paper evaluates a novel bitumen modification through the use of different inorganic nanoparticles, such as nanozinc oxide, nanosilica, and nanotitanium dioxide. In order to improve the dispersion of inorganic nanoparticles in bitumen, inorganic nanoparticles were surface-modified by 3-aminopropyltriethoxysilane. The effect of surface modified inorganic nanoparticles on physical and ultraviolet (UV) aging properties of bitumen was investigated. The UV aging mechanism of the inorganic-nanoparticle-modified bitumen was characterized by using Fourier-transform infrared spectroscopy (FTIR). The results show that 3-aminopropyltriethoxysilane is successfully bound on the surface of the three inorganic nanoparticles in the form of a covalent bond according to the FTIR result. Surface-modified inorganic nanoparticles show good compatibility with bitumen on the basis of high-temperature storage stability. Compared with nanosilica and nanotitanium dioxide, nanozinc oxide shows better dispersion in bitumen. The physical properties of bitumen are slightly influenced by the addition of inorganic nanoparticles. In addition, the changes of physical properties of bitumen depend on the nature of inorganic nanoparticles. The UV aging of bitumen is a process that causes bitumen to harden as indicated by FTIR, penetration, viscosity, and softening point values. However, the viscosity aging index and softening point increment of bitumen can be effectively reduced with the introduction of inorganic nanoparticles, indicating good UV aging resistance of inorganic-nanoparticle-modified bitumen. Three inorganic nanoparticles show different influence on the UV aging resistance of bitumen. Compared with nanosilica and nanotitanium dioxide, nanozinc oxide shows the better improvement in UV aging resistance of bitumen by displaying lower viscosity aging index and softening point increment values as well as the carbonyl index.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported in this paper was supported by the National Natural Science Foundation of China (No. 51308203) and the Specialized Research Fund for the Doctoral Program of Higher Education (No. 20130161120027). The research reported in this paper was also financially supported by the Project of Young Teacher Growth of Hunan University (No. 2012-161) and the Open Fund of Key Laboratory of Special Environment Road Engineering of Hunan Province (Changsha University of Science and Technology, No. kfj120401). Their financial support is gratefully appreciated.
References
ASTM. (2007). “Standard test method for ductility of bituminous materials.” D113, West Conshohocken, PA.
ASTM. (2009). “Standard test method for effects of heat and air on asphaltic materials (thin-film oven test).” D1754, West Conshohocken, PA.
ASTM. (2012a). “Standard test method for softening point of bitumen (ring-and-ball apparatus).” D36, West Conshohocken, PA.
ASTM. (2012b). “Standard test method for viscosity determination of asphalt at elevated temperatures using a rotational viscometer.” D4402, West Conshohocken, PA.
ASTM. (2013). “Standard test method for penetration of bituminous materials.” D5, West Conshohocken, PA.
Chen, H. S., Sun, Z. Y., and Shao, J. C. (2011). “Investigation on FT-IR spectroscopy for eight different sources of .” Bull. Chin. Ceram. Soc., 30(4), 34–37 (in Chinese).
Cong, P. L., Wang, X., Xu, P. J., Liu, J. F., He, R., and Chen, S. F. (2012). “Physical and rheological properties of asphalt binders containing various antiaging agents.” Fuel, 97, 678–684.
Divya, P. S., Gideon, C. S., and Krishnan, J. M. (2013). “Influence of the type of binder and crumb rubber on the creep and recovery of crumb rubber modified bitumen.” J. Mater. Civ. Eng., 438–449.
Durrieu, F., Farcas, F., and Mouillet, V. (2007). “The influence of UV aging of a styrene/butadiene/styrene modified bitumen: Comparison between laboratory and on site aging.” Fuel, 86(10–11), 1446–1451.
Feldman, D. (2002). “Polymer weathering: Photo-oxidation.” J. Polym. Environ., 10(4), 163–173.
Feng, Z. G., Yu, J. Y., and Wu, S. P. (2012). “Rheological evaluation of bitumen containing different ultraviolet absorbers.” Constr. Build. Mater., 29(1), 591–596.
Feng, Z. G., Yu, J. Y., and Zhang, H. L. (2013). “Effect of ultraviolet aging on rheology, chemistry and morphology of ultraviolet absorber modified bitumen.” Mater. Struct., 46(7), 1123–1132.
Hossain, Z., Lewis, S., Zaman, M., Buddhala, A., and O’Rear, E. (2013). “Evaluation for warm-mix additive-modified asphalt binders using spectroscopy techniques.” J. Mater. Civ. Eng., 149–159.
Liu, G., Nielsen, E., Komacka, J., Greet, L., and van de Ven, M. (2014). “Rheological and chemical evaluation on the ageing properties of SBS polymer modified bitumen: From the laboratory to the field.” Constr. Build. Mater., 51(1), 244–248.
Lu, X. H., and Isacsson, U. (2000). “Artificial aging of polymer modified bitumens.” J. Appl. Polym. Sci., 76(12), 1811–1824.
Lu, X. H., and Isacsson, U. (2002). “Effect of ageing on bitumen chemistry and rheology.” Constr. Build. Mater., 16(1), 15–22.
Mouillet, V., Farcas, F., and Besson, S. (2008). “Ageing by UV radiation of an elastomer modified bitumen.” Fuel, 87(12), 2408–2419.
Wu, S. P., Pang, L., Liu, G., and Zhu, J. Q. (2010). “Laboratory study on ultraviolet radiation aging of bitumen.” J. Mater. Civ. Eng., 767–772.
Xiao, F. P., Newton, D., Putman, B., Punith, V. S., and Amirkhanian, S. N. (2013). “A long-term ultraviolet aging procedure on foamed WMA mixtures.” Mater. Struct., 46(12), 1987–2001.
Yamaguchi, K., Sasaki, I., and Meiarashi, S. (2004). “Mechanism of asphalt binder aging by ultraviolet irradiation and aging resistance by adding carbon black.” J. Jpn. Pet. Inst., 47(4), 266–273.
Zhang, B. C., Xi, M., Zhang, D. W., Zhang, H. X., and Zhang, B. Y. (2009). “The effect of styrene-butadiene–rubber/montmorillonite modification on the characteristics and properties of asphalt.” Constr. Build. Mater., 23(10), 3112–3117.
Zhang, H. L., Yu, J. Y., Wang, H. C., and Xue, L. H. (2011). “Investigation of microstructures and ultraviolet aging properties of organo-montmorillonite/SBS modified bitumen.” Mater. Chem. Phys., 129(3), 769–776.
Zhang, H. L., Yu, J. Y., and Wu, S. P. (2012). “Effect of montmorillonite organic modification on ultraviolet aging properties of SBS modified bitumen.” Constr. Build. Mater., 27(1), 553–559.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Nov 21, 2014
Accepted: Feb 25, 2015
Published online: Apr 16, 2015
Discussion open until: Sep 16, 2015
Published in print: Dec 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.