High-Performance Fiber-Reinforced Concrete: Development and Evaluation as a Repairing Material
Publication: Journal of Materials in Civil Engineering
Volume 26, Issue 10
Abstract
This paper describes the development of high-performance fiber-reinforced concrete (HPFRC) with very high strength and the feasibility of using this concrete as a repairing material. Initially two HPFRC mixtures were developed and cured using four different curing conditions. Compressive strength and flexural strength were determined for those eight combinations. Compared to high-performance fiber-reinforced cement composites (HPFRCC), the increase in compressive strength was in the range of 25–105%. Flexural strength was found to be similar to that of HPFRCC. Based on these strength results, one mixture proportion and two curing conditions were further selected for three bond tests, i.e., direct shear, slant shear, and pull-off. The results showed comparable bond strength in case of direct shear, 20% increase in slant shear, and 40% increase in pull-off when compared with other similar studies.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work was performed at West Virginia University, Morgantown, WV. We wish to express our gratitude to the West Virginia EPSCoR for providing financial support. Material donations by Armstrong Cement and Supply, Arrow Concrete (WV), BASF Construction Chemicals, Bekaert, Ricci Brothers Sand Co. Inc., and US Silica Company (WV) are gratefully acknowledged. Testing facilities provided by Dr. David B. DeVallance and Dr. Brijes Mishra and his students (Mr. Diachao Nie and Mr. Priyesh Verma) of West Virginia University are highly appreciated.
References
ACI 544.1R. (1996). “Report on fiber reinforced concrete (reapproved 2009).” American Concrete Institute, Farmington Hills, MI.
Ali, M., Kurihara, S., and Matsui, S. (1998). “Bonding shear strength at the interface between old and new concrete.” Technol. Rep. Osaka Univ., 48(231937), 237–246.
Balaguru, P., and Shah, S. P. (1992). Fiber reinforced cement composites, McGraw Hill, New York.
Bentur, A., and Mindess, S. (1990). Fiber reinforced cementitious composites, Elsevier Applied Science, London.
Bissonnette, B., Vaysburd, A. M., and von Fay, K. F. (2012). “Best practices for preparing concrete surfaces prior to repairs and overlays.”, U.S. Dept. of the Interior, Bureau of Reclamation, Denver.
A. M. Brandt, V. C. Li, and I. H. Marshall, eds. (2000). “Brittle matrix composites 6, BMC-6.” Woodhead Publishing Limited, Cambridge and Warsaw.
Hannant, D. J. (1978). “Fiber cements and fiber concretes.” Wiley, New York, 215.
ICRI 03732. (2008). “Selecting and specifying concrete surface preparation for coatings, sealers, and polymer overlays.” International Concrete Repair Institute, Rosemont, IL.
Karihaloo, B. L., and Wang, J. (1997). “Micromechanical modelling of strain hardening and tension softening in cementitious composites.” J. Comput. Mech., 19(6), 453–462.
Kim, D. J. (2009). “Strain rate effect on high performance fiber reinforced cementitious composites using slip hardening high strength deformed steel fibers.” Ph.D. dissertation, Univ. of Michigan, Ann Arbor, MI.
Kim, D. J., El-Tawil, S., and Naaman, A. E. (2009). “Rate-dependent tensile behavior of high performance fiber reinforced cementitious composites.” Mater. Struct., 42(3), 399–414.
Kim, D. J., Naaman, A. E., and El-Tawil, S. (2008). “Comparative flexural behavior of four fiber reinforced cementitious composites.” Cem. Concr. Compos., 30(10), 917–928.
Kobayashi, K., Iizuka, T., Kurachi, H., and Rokugo, K. (2010). “Corrosion protection performance of high performance fiber reinforced cement composites as a repair material.” Cem. Concr. Compos., 32(6), 411–420.
Konduru, S. (2008). “Performance evaluations of latex-modified and silica fume modified concrete overlays for bridge deck.” Master’s thesis, West Virginia Univ., Morgantown, WV.
MathWorks. (2011). “Boxplot—R2011b documentation.” Natick, MA.
Muñoz, C. M. Á. (2012). “Compatibility of ultra high performance concrete as repair material: bond characterization with concrete under different loading scenarios.” Master’s thesis, Michigan Technological Univ., Houghton, MI.
Naaman, A. E. (1985). “Fiber reinforcement for concrete.” Concr. Int., 7(3), 21–25.
Naaman, A. E. (2007). “High performance fiber reinforced cement composites: Classification and applications.” CBM-CI Int. Workshop, NED University of Engineering and Technology, Karachi, Pakistan.
Naaman, A. E., and Reinhardt, H. W. (2006). “Proposed classification of HPFRC composites based on their tensile response.” Mater. Struct., 39(5), 547–555.
O’Connor, D. N., and Saiidi, M. (1993). “Compatibility of polyester-styrene polymer concrete overlays with portland cement concrete bridge decks.” ACI Mater. J., 90(1), 59–68.
Ray, I., Davalos, J. F., and Luo, S. (2005). “Interface evaluations of overlay-concrete bi-layer composites by a direct shear test method.” Cem. Concr. Compos., 27(3), 339–347.
Ray, I., Davalos, J. F., and Sun, Z. (2010). “Design of experiment and statistical analysis of bond strength test of bi-layer concrete.” Int. J. Mater. Prod. Technol., 39(3–4), 302–316.
Şahmaran, M., and Li, V. C. (2009). “Durability properties of micro-cracked ECC containing high volumes fly ash.” Cem. Concr. Res., 39(11), 1033–1043.
Sarkar, J. (2010). “Characterization of the bond strength between ultra high performance concrete bridge deck overlays and concrete substrates.” Master’s thesis, Michigan Technological Univ., Houghton, MI.
Schäfers, M., and Seim, W. (2011). “Investigation on bonding between timber and ultra-high performance concrete (UHPC).” Constr. Build. Mater., 25(7), 3078–3088.
Sirijaroonchai, K., El-Tawil, S., and Parra-Montesinos, G. (2010). “Behavior of high performance fiber reinforced cement composites under multi-axial compressive loading.” Cem. Concr. Compos., 32(1), 62–72.
Sprinkel, M. M. (1988). “High early strength latex-modified concrete overlay.” Transp. Res. Rec., 1204, 42–51.
Tayeh, B. A., Bakar, B. H. A., and Johari, M. A. M. (2013). “Characterization of the interfacial bond between old concrete substrate and ultra high performance fiber concrete repair composite.” Mater. Struct., 46(5), 743–753.
Yao, Y., Zhu, Y., and Yang, Y. (2012). “Incorporation superabsorbent polymer (SAP) particles as controlling pre-existing flaws to improve the performance of engineered cementitious composites.” Constr. Build. Mater., 28(1), 139–145.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Aug 29, 2013
Accepted: Nov 11, 2013
Published online: Nov 13, 2013
Published in print: Oct 1, 2014
Discussion open until: Oct 27, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.