Influence of Aggregate Gradation on Clogging Characteristics of Porous Asphalt Mixtures
Publication: Journal of Materials in Civil Engineering
Volume 26, Issue 7
Abstract
This research investigates the influence of aggregate gradation on the clogging characteristics of porous asphalt mixtures. Ten representative gradations used for open graded friction course (OGFC) applications from across the United States were used in this evaluation. The aggregate gradation was found to be strongly correlated to the macrotexture depth of the porous pavement and the permeability of the mixes both before and after clogging. Utilizing graded sand as the clogging material, it was also found that the operational (or secondary) clogging rate is approximately half of the measured initial clogging rate. Additionally, the operational clogging rate can be estimated from the value for the system, which is the ratio of the of the porous asphalt gradation to the of the clogging material.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors wish to acknowledge the South Carolina Department of Transportation for sponsoring this research.
References
Alvarez, A. E., Epps Martin, A., and Estakhri, C. (2009). “Effects of densification on permeable friction course mixtures.” J. Test. Eval., 37(1), 11–20.
ASTM. (2005). “Standard test method for effective porosity and effective air voids of compacted bituminous paving mixture samples.” D7063, West Conshohocken, PA.
ASTM. (2006). “Standard test method for measuring pavement macrotexture depth using a volumetric technique.” E965, West Conshohocken, PA.
ASTM. (2008). “Standard practice for open-graded friction course (OGFC) mix design.” D7064, West Conshohocken, PA.
ASTM. (2009). “Standard test method for bulk density (unit weight) and voids in aggregate.” C29, West Conshohocken, PA.
ASTM. (2012). “Standard specification for standard sand.” C778, West Conshohocken, PA.
Barrett, M. E., Kearfott, P., and Malina, J. F., Jr. (2006). “Stormwater quality benefits of a porous friction course and its effects on pollutant removal by roadside shoulders.” Water Environ. Res., 78(11), 2177–2185.
Bishop, M. C., and Oliver, M. F. (2001). “Open graded friction course pavements in British Columbia.” Proc., 46th Annual Conf. of the Canadian Technological Asphalt Association, Canadian Technical Asphalt Association, Victoria, BC, Canada.
Cabrera, J. G., and Hamzah, M. O. (1996). “Over compaction behaviour of porous asphalt.” Euro Bitume Congress, First Eurasphalt and Eurobitume Congress, European Asphalt Pavement Association, Brussels, Belgium.
Das, B. M. (2006). Principles of geotechnical engineering, 6th Ed., Thompson Learning, Toronto, ON.
Ferguson, B. K. (2005). Porous pavements, CRC Press, Boca Raton, FL.
Fwa, T. F., Tan, S. A., and Guwe, Y. K. (1999). “Laboratory evaluation of clogging potential of porous asphalt mixtures.”, Transportation Research Board, Washington, DC, 43–49.
Hamzah, M. O., Abdullah, N. H., Voskuilen, J. L. M., and von Bochove, G. (2013). “Laboratory simulation of the clogging behaviour of single-layer and two-layer porous asphalt.” Road Mater. Pavement Des., 14(1), 107–125.
Isenring, T., Köster, H., and Scazziga, I. (1990). “Experiences with porous asphalt in Switzerland.”, Transportation Research Board, Washington, DC, 41–53.
Kandhal, P. (2002). Design, construction, and maintenance of open-graded asphalt friction courses, Information Series 115, National Asphalt Pavement Association, Lanham, MD.
Long, R. P., Demars, K. R., Mankbadi, R. R., and Covo, A. (1988). “The relationship between permeability coefficients for soil obtained using liquid and gas.”, Joint Highway Research Advisory Council of the Univ. of Connecticut and the Connecticut Dept. of Transportation.
Mallick, R. B., Kandhal, P. S., Cooley, L. A., and Watson, D. E. (2000). “Design, construction, and performance of new-generation open-graded friction courses.” J. Assoc. Asphalt Paving Technol., 69, 391–423.
Mansour, T. N., and Putman, B. J. (2013). “Influence of aggregate gradation on the performance properties of porous asphalt mixtures.” J. Mater. Civ. Eng., 281–288.
Masad, E., Muhunthan, B., and Martys, N. (2000). “Simulation of fluid flow and permeability in cohesionless soils.” Water Resour. Res., 36(4), 851–864.
Nielsen, C. B. (2007). “Ravelling of porous pavements—Assessment of test section.”, Road Directorate, Danish Road Institute, Rosklide, Denmark.
Nielsen, C. B., Bendtsen, H., Andersen, B., and Larsen, H. J. E. (2005). “Noise reducing pavements in Japan—Study tour report.”, Road Directorate, Danish Road Institute, Rosklide, Denmark.
North Carolina Dept. of Transportation (NCDOT). (2009). “North Carolina test method for determining optimum asphalt content for open-graded bituminous paving mixtures.”, Raleigh, NC.
Ruiz, A., Alberola, R., Pérez, F., and Sánchez, B. (1990). “Porous asphalt mixtures in Spain.”, Transportation Research Board, Washington, DC, 87–94.
Suresha, S. N., George, V., and Ravi Shankar, A. U. (2010a). “Effect of aggregate gradations on properties of porous friction course mixes.” Mater. Struct., 43(6), 789–801.
Suresha, S. N., George, V., and Ravi Shankar, A. U. (2010b). “Laboratory and theoretical evaluation of clogging behavior of porous friction course mixes.” Int. J. Pavement Eng., 11(1), 61–70.
Tan, S. A., Fwa, T. F., and Han, C. T. (2003). “Clogging evaluation of permeable bases.” J. Transp. Eng., 309–315.
Watson, D. E., Masad, E., Moore, K. A., Williams, K., and Cooley, L. A., Jr. (2004). “Verification of voids in coarse aggregate testing: Determining stone-on-stone contact of hot-mix asphalt mixtures.”, Transportation Research Board, Washington, DC, 182–190.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Feb 19, 2013
Accepted: Nov 4, 2013
Published online: Nov 6, 2013
Published in print: Jul 1, 2014
Discussion open until: Sep 7, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.