Implementation of a Triaxial Dynamic Modulus Master Curve in Finite-Element Modeling of Asphalt Pavements
Publication: Journal of Materials in Civil Engineering
Volume 26, Issue 3
Abstract
The newly developed Mechanistic-Empirical Pavement Design Guide (MEPDG) uses the dynamic modulus master curve to account for the temperature and frequency dependent behavior of asphalt concrete. However, the master curve used in the MEPDG is constructed using dynamic moduli measured in uniaxial testing and the effect of confinement on the mechanical properties of asphalt concrete is disregarded. This study implemented a model of triaxial dynamic modulus master curve in finite-element (FE) modeling of asphalt pavements. The dynamic modulus distribution in asphalt layers due to the contribution of confinement was evaluated for various scenarios. The results show that when the effect of confinement is considered the dynamic modulus can be more than two times the uniaxial value at the same temperature and frequency. The effect of confinement on dynamic modulus is more evident at high temperatures and low frequencies. Various pavement responses were computed using the developed FE model and compared to those obtained using the corresponding uniaxial dynamic modulus. For the pavements analyzed in this study, the confinement has the most pronounced effect on the permanent deformation of asphalt layers. The compressive strain in asphalt layers can be reduced to about half of the value obtained using the uniaxial dynamic modulus.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (2007). “Standard method of test for determining dynamic modulus of hot-mix asphalt (HMA).”, Washington, DC.
Al-Qadi, I. L., Xie, W., and Elseifi, M. A. (2008). “Frequency determination from vehicular loading time pulse to predict appropriate complex modulus in MEPDG.” J. Assoc. Asphalt Paving Technol., 77, 739–772.
Applied Research Associates (ARA). (2004). “Guide for mechanistic-empirical design of new and rehabilitated pavement structures.” Final Rep., National Cooperative Highway Research Program (NCHRP) Project 1-37A, Albuquerque, NM.
Barksdale, R. G. (1971). “Compressive stress pulse times in flexible pavements for use in dynamic testing.”, 32–44.
Brown, S. F., and Bell, C. A. (1977). “Validity of design procedures for the permanent deformation of asphalt pavements.” Proc., 4th Int. Conf. on the Structural Design of Asphalt Pavements, Vol. 1, Dept. of Civil Engineering, Univ. of Michigan, Ann Arbor, MI, 467–482.
Chehab, G. R., Kim, Y. R., Schapery, R. A., Witczack, M., and Bonaquist, R. (2003). “Characterization of asphalt concrete in uniaxial tension using a viscoelastoplastic model.” J. Assoc. Asphalt Paving Technol., 72, 315–355.
Dongre, R. N., Myers, L. A., and D’Angelo, J. A. (2006). “Conversion of testing frequency to loading time: Impact on performance predictions obtained from the mechanistic–empirical pavement design guide.” Presented at 85th Annual Meeting of the Transportation Research Board, National Research Council, Washington, DC.
Hajj, E. Y., Ulloa, A., Siddharthan, R., and Sebaaly, P. E. (2010). “Characteristics of the loading pulse for the flow number performance.” J. Assoc. Asphalt Paving Technol., 79, 253–294.
Huang, C., Abu Al-Rub, R., Masad, E., Little, D. (2011). “Three-dimensional simulations of asphalt pavement permanent deformation using a nonlinear viscoelastic and viscoplastic model.” J. Mater. Civ. Eng., 56–68.
Kim, Y., Guddati, M., Underwood, B., Yun, T., and Savadatti, V. (2009). “Development of a multiaxial viscoelastoplastic continuum damage model for asphalt mixtures.” FHWA Publ. No. DTFH61-05-H-00019, Federal Highway Administration, McLean, VA.
Lambe, T. W., and Whitman, R. V. (1969). Soil mechanics, Wiley, New York.
Levenberg, E. (2009). “Viscoplastic response and modeling of asphalt aggregate mixes.” Mater. Struct., 42(8), 1139–1151.
Levenberg, E. (2011). “Smoothing asphalt concrete complex modulus test data.” J. Mater. Civ. Eng., 606–611.
Park, S., and Lytton, R. L. (2004). “Effect of stress-dependent modulus and Poisson’s ratio on structural responses in thin asphalt pavements.” J. Transp. Eng., 387–394.
Perkins, S. W., Christopher, B. R., Cuelho, E., Eiksund, G. R., Hoff, I., and Schwartz, C. W. (2004). “Development of design methods for geosynthetic reinforced flexible pavements.” FHWA Rep. DTFH61-01-X-00068, Montana State Univ., Bozeman, MT.
Saad, B., Mitri, H., and Poorooshasb, H. (2005). “Three-dimensional dynamic analysis of flexible conventional pavement foundation.” J. Transp. Eng., 460–469.
Schwartz, C. W. (2002). “Effect of stress-dependent base layer on the superposition of flexible pavement solutions.” Int. J. Geomech., 331–352.
Shields, D. H., Zeng, M., and Kwok, R. (1998). “Nonlinear viscoelastic behavior of asphalt concrete in stress relaxation.” J. Assoc. Asphalt Paving Technol., 67, 358–400.
Tschoegl, N. W. (1989). The phenomenological theory of linear viscoelastic behavior: An introduction, Springer, New York.
Underwood, B., Yun, T., and Kim, Y. (2011). “Experimental investigations of the viscoelastic and damage behaviors of hot-mix asphalt in compression.” J. Mater. Civ. Eng., 459–466.
Uzan, J., and Levenberg, E. (2007). “Advanced testing and characterization of asphalt concrete materials in tension.” Int. J. Geomech., 158–165.
Witczak, W. M., Kaloush, K., Pellinen, T., El-Basyouny, M., and Von Quintus, H. (2000). “Simple performance test for Superpave mix design.”, National Research Council, Transportation Research Board, Washington, DC.
Zaghloul, S. M., and White, T. D. (1993). “Use of a three-dimensional, dynamic finite element program for analysis of flexible pavement.” Transportation Res. Record No. 1388, National Research Council, Washington, DC, 60–69.
Zeiada, W., Kaloush, K., Biligiri, K., Reed, J., and Stempihar, J. (2011). “Significance of confined dynamic modulus laboratory testing for asphalt concrete: Conventional, gap-graded, and open-graded mixtures.” Transportation Res. Record No. 2210, National Research Council, Washington, DC, 9–19.
Zhao, Y., Liu, H., and Liu, W. (2013). “Characterization of linear viscoelastic properties of asphalt concrete subjected to confining pressure.” Mech. Time-dependent Mater., 17(3), 449–463.
Zhao, Y., Tang, J., and Liu, L. (2012). “Construction of triaxial dynamic modulus master curve for asphalt mixtures.” Constr. Build. Mater., 37, 21–26.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 26 • Issue 3 • March 2014
Pages: 491 - 498
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 17, 2012
Accepted: Mar 25, 2013
Published online: Apr 13, 2013
Discussion open until: Sep 13, 2013
Published in print: Mar 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.