Investigation of the Mineral Dissolution Rate and Strength Development in Stabilized Soils Using Quantitative X-Ray Diffraction
Publication: Journal of Materials in Civil Engineering
Volume 26, Issue 2
Abstract
The design of chemical stabilization of clay soils typically relies on empirical studies that utilize 28-day strength, measured as unconfined compressive strength (UCS) or California Bearing Ratio (CBR), as the design criterion. At present, it is generally not possible to extrapolate the results of individual studies to other soils, mainly because there is no quantitative understanding of the chemical reactions that cause strength increase over time. Accordingly, the objective of this study was to investigate whether quantitative X-ray diffraction (QXRD) can be used to establish a quantitative relationship between the mineralogical (microscopic) and strength (macroscopic) properties of kaolinite clay stabilized lime, portland cement, and Class C fly ash. The UCS was observed to change linearly with dry unit weight and logarithmically with time up to 300 days of curing. The kaolinite content in the stabilized samples also decreased logarithmically with time, accompanied by a concomitant increase in the amorphous content that represents the formation of calcium silicate hydrate (CSH) and calcium aluminate hydrate (CAH). The overall result was that a highly linear relationship was observed between the UCS and the kaolinite/amorphous content as determined by QXRD. This relationship was different for each of the three stabilizers because portland cement and fly ash exhibit additional cementitious reactions in addition to the dissolution of kaolinite to form CSH/CAH. The study indicates that QXRD is a viable method to produce quantitative assessments of soil mineralogy and that it is possible to pursue the development of models that predict strength of chemically stabilized soils as a function of fundamental parameters, including soil mineralogy and dry unit weight.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This project was funded by the Center for Resilient Transportation Infrastructure–Department of Homeland Security University Programs. The author thanks Matt Rood and Celio Vasquez for assistance with the experimental testing program.
References
Åhnberg, H. (2006). “Strength of stabilized soils—A laboratory study on clays and organic soils stabilized with different types of binder.” Ph.D. thesis, Swedish Deep Stabilization Research Centre, Lund, Sweden.
Åhnberg, H., and Johansson, S. E. (2005). “Increase in strength with time in soils stabilised with different types of binder in relation to the type and amount of reaction products.” Proc., Int. Conf. on Deep Mixing, Vol. 1.1, Swedish Deep Stabilization Research Centre, Lincoping, Sweden, 195–202.
Antiohos, S., and Tsimas, S. (2004). “Activation of fly ash cementitious systems in the presence of quicklime Part I. Compressive strength and pozzolanic reaction rate.” Cem. Concr. Res., 34(5), 769–779.
ASTM. (2003). “Standard test methods for screening of pH in waste.” ASTM D4980-03, West Conshohocken, PA.
ASTM. (2007a). “Standard test methods for laboratory compaction characteristics of soil using standard effort [ ()].” ASTM D698-07, West Conshohocken, PA.
ASTM. (2007b). “Standard test methods for compressive strength of molded soil-cement cylinders.” ASTM D1633-07, West Conshohocken, PA.
ASTM. (2010). “Standard test methods for laboratory determination of water (moisture) content of soil and rock by mass.” ASTM D2216-10, West Conshohocken, PA.
ASTM. (2012). “Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete.” ASTM C618-12, West Conshohocken, PA.
Basheer, I. A. (2001). “Empirical modeling of the compaction curve of cohesive soils.” Can. Geotech. J., 38(1), 29–45.
Bell, F. G. (1996). “Lime stabilization of clay minerals and soils.” Eng. Geol., 42(4), 223–237.
Chen, J. J., Thomas, J. J., and Jennings, H. M. (2006). “Decalcification shrinkage of cement paste.” Cem. Concr. Res., 36(5), 801–809.
Choquette, M., Berube, M. -A., and Locat, J. (1987). “Mineralogical and microtextural changes associated with lime stabilization of marine clays from Eastern Canada.” Appl. Clay Sci., 2, 215–232.
Damidot, D., Lothenbach, B., Herfort, D., and Glasser, F. P. (2011). “Thermodynamics and cement science.” Cem. Concr. Res., 41(7), 679–695.
De La Torre, A. G., Bruque, S., and Aranda, M. A. G. (2001). “Rietveld quantitative amorphous content analysis.” J. Appl. Crystal., 34(2), 196–202.
Diamond, S., and Kinter, E. B. (1965). “Mechanisms of soil-lime stabilization.” Highway Res. Rec., 92, 83–102.
Elsevier, Butterworth, Heinemann (EBH). (1998). Lea’s chemistry of cement and concrete, 4th Ed., P. C. Hewlett, ed., EBH, Oxford.
Hausmann, M. R. (1990). Engineering principles of ground modification, McGraw Hill, New York.
Herzog, A., and Mitchell, J. K. (1962). “X-ray evidence for cement-clay interaction.” Nature, 195(4845), 989–990.
Herzog, A., and Mitchell, J. K. (1963). “Reactions accompanying stabilization of clay with cement.” Highway Res. Rec., 36, 146–171.
Horpibulsuk, S., Miura, N., and Nagara, T. S. (2003). “Assessment of strength development in cement-admixed high water content clays with Abrams’ law as a basis.” Géotechnique, 53(4), 439–444.
Jade Version 8.5. [Computer software]. Material’s Data Inc (MDI), Livermore, CA.
Lam, L., Wong, Y. L., and Poon, C. S. (2000). “Degree of hydration and gel-space ratio of high-volume fly ash/cement systems.” Cem. Concr. Res., 30(5), 747–756.
Little, D. (1999). “Evaluation of structural properties of lime stabilized soils and aggregates, Vol. 1: Summary of findings.” Rep. to the National Lime Association, Arlington, VA.
Little, D. N., Herbert, B., and Kunagali, S. N. (2005). “Ettringite formation in lime-treated soils: Establishing thermodynamic foundations for engineering practice.” Transport. Res. Rec., 1936(1), 51–59.
Lumley, J. S., Gollop, R. S., Moir, G. K., and Taylor, H. F. W. (1996). “Degrees of reaction of the slag in some blends with portland cements.” Cem. Concr. Res., 26(1), 139–151.
Mahlotra, V. M., and Mehta, P. K. (1996). “Pozzolanic and cementitious materials.” Advances in concrete technology, Vol. 1, Gordon and Breach Publishers, Amsterdam.
McCusker, L. B., von Dreele, R. B., Cox, D. E., Louer, D., and Scardi, P. (1999). “Rietveld refinement guidelines.” J. Appl. Cryst., 32(1), 36–50.
Misra, A. (1998). “Stabilization characteristics of clays using class C fly ash.” Transport. Res. Rec., 1611(1), 46–54.
Mitchell, J. K., and El, J. (1966). “The fabric of soil cement and its formation.” Nat. Conf. Clays Clay Minerals Proc., Pergamon Press, Oxford, 297–305.
Mitchell, J. K., and Soga, K. (2005). Fundamentals of soil behavior, 3rd Ed., Wiley, Hoboken, NJ.
Moh, Z. C. (1965). “Reaction of soil minerals with cement and chemicals.” Highway Res. Rec., 86, 39–61.
Nair, S., and Little, N. (2009). “Water as the key to expansion of ettringite in cementitious materials.” Tranport. Res. Rec., 2104(1), 55–62.
Nonat, A. (2004). “The structure and stoichiometry of C-S-H.” Cem. Concr. Res., 34(9), 1521–1528.
Penumadu, D., and Zhao, R. (1999). “Triaxial compression behavior of sand and gravel using artificial neural networks (ANN).” Comput. Geotech., 24(3), 207–230.
Petry, T. M., and Little, D. N. (2002). “Review of stabilization of clays and expansive soils in pavements and lightly loaded structures—History, practice, and future.” J. Mater. Civ. Eng., 447–460.
Porbaha, A., Shibuya, S., and Kishida, T. (2000). “State of the art in deep mixing technology. Part III geomaterial characterization.” Ground Improvement, 4(3), 91–110.
Richardson, I. G. (2008). “The calcium silicate hydrates.” Cem. Concr. Res., 38(2), 137–158.
Rietveld, H. M. (1969). “A profile refinement method for nuclear and magnetic structures.” J. Appl. Crystal., 2(2), 65–71.
Ritchie, I. M., and Bing-An, X. (1990). “The kinetics of lime slaking.” Hydrometallurgy, 23(2–3), 377–396.
Roy, D. M., and Idorn, G. M. (1993). “Concrete microstructure.”, Strategic Highway Research Program, National Research Council, Washington, DC.
Sariosseiri, F., and Muhunthan, B. (2009). “Effect of cement treatment on geotechnical properties of some Washington state soils.” Eng. Geol., 104(1–2), 119–125.
Scrivener, K. L., Füllmann, T., Gallucci, E., Walenta, D., and Bermejo, E. (2004). “Quantitative study of portland cement hydration by X-ray diffraction/Rietveld analysis and independent methods.” Cem. Concr. Res., 34(9), 1541–1547.
Scrivener, N. L., and Nonat, A. (2011). “Hydration of cementitious materials, present and future.” Cem. Concr. Res., 41(7), 651–665.
Shahin, M. A., Jaksa, M. B., and Maier, H. R. (2001). “Artificial neural network applications in geotechnical engineering.” Aust. Geomech., 36(1), 49–62.
Whitfield, P. S., and Mitchell, L. D. (2003). “Quantitative analysis of the amorphous content in cements and clinkers.” J. Mater. Sci., 38(21), 4415–4421.
Young, R. A. (1993). The Rietveld Method, Oxford University Press, New York.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 26 • Issue 2 • February 2014
Pages: 288 - 295
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Sep 27, 2012
Accepted: Mar 6, 2013
Published online: Mar 8, 2013
Discussion open until: Aug 8, 2013
Published in print: Feb 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.