Laboratory Evaluation of Deformations of Steel-Reinforced High-Density Polyethylene Pipes under Static Loads
Publication: Journal of Materials in Civil Engineering
Volume 25, Issue 12
Abstract
A new product, steel-reinforced high-density polyethylene (SRHDPE) pipe, with high-strength steel reinforcing ribs wound helically and covered by corrosion-resistant high-density polyethylene (HDPE) resin inside and outside has obvious advantages. To investigate the behavior and performance of such a new pipe, three parallel plate tests were conducted in air. The deflection profiles of the pipes and the strains on both steel and polyethylene plastic were measured. No cracking was observed on the plastic during the experiment. The photogrammetry technology was effective in measuring the deflection profiles of the pipes during loading. The light detection and ranging (LiDAR) technology could obtain three-dimensional images of the pipes but was suitable for stationary targets. Strain gauge data indicated the occurrence of out of plane buckling of the steel ribs at failure and the strain incompatibility between the steel ribs and the plastic cover during loading.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This investigation was supported by Kansas Department of Transportation (KDOT) and the University of Kansas General Research Fund allocation #2301583. Contech Construction Product Inc. provided the steel-reinforced high density polyethylene (SRHDPE) pipes. The coauthor, Ryan Corey, is the Geosynthetic Institute (GSI) fellow awarded by the Geosynthetic Institute. The authors gratefully acknowledge all the support.
References
AASHTO. (2007). “Standard specification for corrugated polyethylene pipe 12 to 60 in. diameter.”, Washington, DC.
ASTM. (2002). “Standard test methods for determination of external loading characteristics of plastic type by parallel plate loading.”, West Conshohoken, PA.
ASTM. (2008). “Specification for steel reinforced thermoplastic ribbed pipe and fittings for non-pressure drainage and sewerage.”, West Conshohoken, PA.
Brachman, R. W. I., Moore, I. D., and Munro, S. M. (2008). “Compaction effects on strains in thermoplastic culverts.” Geosynth. Int., 15(2), 72–85.
Hall, and Foreman, Inc. (1993). “Corrugated polyethylene pipe.” Invest. Rep., Victorville, CA.
Johnson, L. (1993). “HDPE pipe, San Diego, California, Test Site 1.” HDPE Pipe Task Group Report for Standard Specifications for Public Works Construction, Public Works Standards, CA.
Moser, A. P. (2002). Buried pipe design, 2nd Ed., McGraw-Hill Professional, New York.
Schluter, J. C., and Shade, J. W. (1999). “Flexibility factor or pipe stiffness: Significant stiffness consideration.” Transportation Research Record 1656, Transportation Research Board, Washington, DC, 45–50.
Strand, D. (1993). “Miramar landfill, City of San Diego, California, Test 1 and 2.” HDPE Task Force for Green Book Standard Specifications for Public Works Construction, Public Works Standards, CA.
Timoshenko, S., and Gere, J. M. (1961). Theory of elastic stability, 2nd Ed., McGraw-Hill, New York.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: May 17, 2012
Accepted: Jan 9, 2013
Published online: Jan 11, 2013
Discussion open until: Jun 11, 2013
Published in print: Dec 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.