Influence of Fly Ash on Slump Loss and Strength of Concrete Fully Incorporating Recycled Concrete Aggregates
Publication: Journal of Materials in Civil Engineering
Volume 25, Issue 2
Abstract
This paper investigates the effects of fineness and replacement of fly ash on the fresh and hardened properties of recycled aggregate concrete. Two groups of recycled aggregate concretes were studied and compared with that of conventional concrete (CON) in which crushed limestone and local river sand were used as aggregates. The first group was prepared using 100% coarse recycled concrete aggregate and local river sand. For the second group, crushed limestone and local river sand were fully replaced by both coarse and fine recycled concrete aggregates. The results indicate that the slump loss of the recycled aggregate concrete with fly ash was reduced to lower than that of the recycled aggregate concrete without fly ash when the fineness of the fly ash was increased, which increased the slump loss of the fresh concrete. Fly ash can be used to increase the compressive strength of recycled aggregate concrete, depending on its fineness and the degree of fly ash replacement. The addition of fly ash with different fineness in recycled aggregate concrete had no significant effect on the splitting tensile strength and the modulus of elasticity of the recycled aggregate concrete, which are related to its compressive strength.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge financial support from the Thailand Research Fund (TRF), the Commission on Higher Education (CHE), Ministry of Education, and King Mongkut’s University of Technology Thonburi under the TRF-CHE Research Grant for New Scholars, Grant No. MRG5480180, from the Thailand Research Fund under the TRF Senior Research Scholar, Grant No. RTA5380002, and from King Mongkut’s University of Technology Thonburi under the National Research University (NRU).
References
Ajdukiewicz, A., and Kliszczewicz, A. (2002). “Influence of recycled aggregates on mechanical properties of HS/HPC.” Cem. Concr. Compos., 24(2), 269–279.
ASTM. (2001a). “Standard specification for concrete aggregates.” ASTM C33, American Society for Testing and Materials, West Conshohocken, PA.
ASTM. (2001b). “Standard test metc cylindrical concrete specimens.” ASTM C39, American Society for Testing and Materials, West Conshohocken, PA.
ASTM. (2001c). “Standard test method for slump of hydraulic-cement concrete.” ASTM C143, American Society for Testing and Materials, West Conshohocken, PA.
ASTM. (2001d). “Standard test method for splitting tensile strength of cylindrical concrete.” ASTM C496, American Society for Testing and Materials, West Conshohocken, PA.
ASTM. (2001e). “Standard test method for static modulus of elasticity and Poisson’s ratio of concrete in compression.” ASTM C469, American Society for Testing and Materials, West Conshohocken, PA.
Barra de Oliveira, M., and Vazquez, E. (1996). “The influence of retained moisture aggregates from recycling on the properties of new hardened concrete.” Waste Manage., 16(1–3), 113–117.
Building Contractors Society of Japan (BCSJ). (1978). “Committee on disposal and reuse of concrete construction waste.” Summ. Concr. J. Jpn., 16(7), 18–31 (in Japanese).
Cetin, A., and Carrasquillo, R. L. (1998). “High-performance concrete: Influence of coarse aggregate on mechanical properties.” ACI Mater. J., 95(3), 252–261.
Chen, H. J., Ten, T., and Chen, K. U. (2003). “Use of building rubbles as recycled aggregates.” Cem. Concr. Res., 33(1), 125–132.
Corinaldesi, V., and Moriconi, G. (2009). “Behaviour of cementitious mortars containing different kinds of recycled aggregate.” Constr. Build. Mater., 23(1), 289–294.
Dept. of Primary Industry and Mines. (2010). “Mineral statistics of Thailand 2004–2008.” Ministry of Industry, Bangkok, Thailand, 9(1), 1–28.
Erdogdu, K., and Turker, P. (1998). “Effects of fly ash particle size on strength of portland cement fly ash mortars.” Cem. Concr. Res., 28(9), 335–343.
Evangelista, L., and Brito, J. (2007). “Mechanical behaviour of concrete made with fine recycled concrete aggregates.” Cem. Concr. Compos., 29(5), 397–401.
Gerardu, J. J. A., and Hendriks, C. F. (1985). “Recycled of road pavement materials in the Netherlands.” Rijkswaterstaat communications, Rijkswaterstaat, Hague, The Netherlands.
Gonzalez-Fonteboa, B., and Martinez-Abella, F. (2008). “Concrete with aggregates from demolition waste and silica fume: Material and mechanical properties.” Build. Environ., 43(4), 429–437.
Hansen, T. C. (1992). “Recycling of demolished concrete and masonry.” RILEM Rep. 6, E & FN Spon, London.
Hansen, T. C., and Boegh, E. (1985). “Elasticity and drying shrinkage of recycled-aggregate concrete.” ACI J., 82(5), 648–652.
Hansen, T. C, and Narud, H. (1983). “Strength of recycled concrete made from crushed concrete coarse aggregate.” Concr. Int., 5(1), 79–83.
Katz, A. (2003). “Properties of concrete made with recycled aggregate from partially hydrated old concrete.” Cem. Concr. Res., 33(5), 703–711.
Katz, A. (2004). “Treatment for the improvement of recycled aggregate.” J. Mater. Civ. Eng., 16(6), 597–603.
Kiattikomol, K., Jaturapitakkul, C., Singpiriyakij, S., and Chututim, S. (2001). “A study of ground coarse fly ashes with different finenesses from various sources as pozzolanic materials.” Cem. Concr. Compos., 23(4–5), 335–343.
Kofoworola, O. F., and Gheewala, S. H. (2009). “Estimation of construction waste generation and management in Thailand.” Waste Manage., 29(2), 731–738.
Kou, C. S., Poon, C. S., and Chan, D. (2008). “Influence of fly ash as a cement addition on the hardened properties of recycled aggregate concrete.” Mater. Struct., 41(7), 1191–1201.
Li, J., Xiao, H., and Zhou, Y. (2009). “Influence of coating recycled aggregate surface with pozzolanic powder on properties of recycled aggregate concrete.” Constr. Build. Mater., 23(3), 1287–1291.
Montgomery, D. G. (1998). “Workability and compressive strength properties of concrete containing recycled concrete aggregate.” Proc. of the Sustainable Construction: Use of Recycled Concrete Aggregate, R. K. Dhir, N. A. Henderson, and M. C. Limbachiya, eds., Thomas Telford, London, 289–296.
Neville, A. M. (1997). “Aggregate bond and modulus of elasticity of concrete.” ACI Mater. J., 94(1), 71–74.
Otsuki, N., Miyazato, S., and Yodsudjai, W. (2003). “Influence of recycled aggregate on interfacial transition zone, strength, chloride penetration and carbonation of concrete.” J. Mater. Civ. Eng., 15(5), 443–451.
Poon, C. S., Shui, Z. H., Lam, L., Fok, H., and Kou, S. C. (2004). “Influence of moisture states of natural and recycled aggregate on the slump and compressive strength of concrete.” Cem. Concr. Res., 34(1), 1–6.
Rahal, K. (2007). “Mechanical properties of concrete with recycled coarse aggregate.” Build. Environ., 42(1), 407–415.
Rao, A., Kumar, N. J., and Misra, S. (2007). “Use of aggregates from recycled construction and demolition waste in concrete.” Resour. Conserv. Recycl., 50(1), 71–81.
Ravina, D. (1984). “Slump loss of fly ash concrete.” Concr. Int., 6(4), 35–39.
Shayan, A., and Xu, A. (2003). “Performance and properties of structural concrete made with recycled concrete aggregate.” ACI Mater. J., 100(5), 371–380.
Tangchirapat, W., Buranasing, R., Jaturapitakkul, C., and Chindaprasirt, P. (2008). “Influence of rice husk-bark ash on mechanical properties of concrete containing high amount of recycled aggregates.” Constr. Build. Mater., 22(8), 1812–1819.
Topcu, I. B., and Guncan, N. F. (1995). “Using waste concrete as aggregate.” Cem. Concr. Res., 25(7), 1385–1390.
Topcu, I. B., and Sengel, S. (2004). “Properties of concrete produced with waste concrete aggregate.” Cem. Concr. Res., 34(8), 1307–1312.
Wade, M. J., Cuttell, G. D., Vandenbossche, J. M., Yu, H. T., Smith, K. D., and Snyder, M. B. (1997). “Performance of concrete pavements containing recycled concrete aggregate.” Federal Highway Administration, U.S. Dept. of Transportation, Washington, DC.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Sep 7, 2011
Accepted: May 22, 2012
Published online: May 24, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.