High-Calcium Bottom Ash Geopolymer: Sorptivity, Pore Size, and Resistance to Sodium Sulfate Attack
Publication: Journal of Materials in Civil Engineering
Volume 25, Issue 1
Abstract
The resistance to sulfate attack, compressive strength, sorptivity, and pore size of high-calcium bottom ash geopolymer mortars were studied. Ground lignite bottom ashes (BAs) with median particle sizes of 16, 25, and 32 μm were used. NaOH, sodium silicate, and temperature curing were used to activate the geopolymerization. Results showed that relatively high strengths of 40.0–54.5 MPa were obtained for the high-calcium bottom ash geopolymer mortars. The use of fine BA improved the strength and resistance to sulfate attack of mortars. The good performances were attributable to the high degree of reaction of fine BA and the associated low amount of large pores (0.05–100 μm) compared with those of coarse BA. The incorporation of water improved the workability of mixes, and the compressive strength, sorptivity, and resistance to sulfate attack decreased due to the increase in large pores.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was financially supported by the Higher Education Research Promotion and National Research University Project of Thailand, Office of the Higher Education Commission, through the Advanced Functional Materials Cluster of Khon Kaen University and the Thailand Research Fund (TRF) under the TRF Senior Research Scholar, Grant No. RTA5480004.
References
ASTM. (2002). “Standard test method of compressive strength of hydrualic cement mortars (using 2-in. or [50 mm] cube speciments).” C109, West Conshohocken, PA.
ASTM. (2010). “Standard test method for length change of hydraulic-cement mortars exposed to a sulfate solution.” C1012, West Conshohocken, PA.
ASTM. (2011). “Standard test method for measurement of rate of absorption of water by hydraulic-cement concretes.” C1585, West Conshohocken, PA.
Atahan, H. N., and Dikme, D. (2011). “Use of mineral admixtures for enhanced resistance against sulfate attack.” Constr. Build. Mater., 25(8), 3450–3457.
Bakharev, T. (2005). “Durability of geopolymer materials in sodium and magnesium sulfate solutions.” Cem. Concr. Res., 35(6), 1233–1246.
Bakharev, T., Sanjayan, J. G., and Cheng, Y. B. (2003). “Resistance of alkali-activated slag concrete to acid attack.” Cem. Concr. Res., 33(10), 1607–1611.
Bonakdar, A., and Mobasher, B. (2010). “Multi-parameter study of external sulfate attack in blended cement materials.” Constr. Build. Mater., 24(1), 61–70.
Cheriaf, M., Rocha, J. C., and Péra, J. (1999). “Pozzolanic properties of pulverized coal combustion bottom ash.” Cem. Concr. Res., 29(9), 1387–1391.
Chindaprasirt, P., Chareerat, T., and Sirivivatnanon, V. (2007a). “Workability and strength of coarse high calcium fly ash geopolymer.” Cem. Concr. Compos., 29(3), 224–229.
Chindaprasirt, P., Jaturapitakkul, C., Chalee, W., and Rattanasak, U. (2009). “Comparative study on the characteristics of fly ash and bottom ash geopolymers.” Waste Manage., 29(2), 539–543.
Chindaprasirt, P., Jaturapitakkul, C., and Sinsiri, T. (2007b). “Effect of fly ash fineness on microstructure of blended cement paste.” Constr. Build. Mater., 21(7), 1534–1541.
Chindaprasirt, P., Kanchanda, P., Sathonsaowaphak, A., and Cao, H. T. (2007c). “Sulfate resistance of blended cements containing fly ash and rice husk ash.” Constr. Build. Mater., 21(6), 1356–1361.
Davidovits, J. (1999). “Chemistry of geopolymeric systems, terminology.” Proc., Geopolymer Second Int. Conf., Géopolymère’99, Davidovits, J., Davidovits, R., and James, C., eds., Geopolymer Institute, Saint-Quentin, France, 9–39.
Detphan, S., and Chindaprasirt, P. (2009). “Preparation of fly ash and rice husk ash geopolymer.” Int. J. Miner. Metall, Mater., 16(6), 720–726.
Duxson, P., Provis, J. L., Lukey, G. C., and van Deventer, J. S. J. (2007). “The role of inorganic polymer technology in the development of ‘green concrete.” Cem. Concr. Res., 37(12), 1590–1597.
Fernandez-Jimenez, A., García-Lodeiro, I., and Palomo, A. (2007). “Durability of alkali-activated fly ash cementitious materials.” J. Mater. Sci., 42(9), 3055–3065.
Ghrici, M., Kenai, S., and Said-Mansour, M. (2007). “Mechanical properties and durability of mortar and concrete containing natural pozzolana and limestone blended cements.” Cem. Concr. Compos., 29(7), 542–549.
Gonen, T., and Yazicioglu, S. (2007). “The influence of compaction pores on sorptivity and carbonation of concrete.” Constr. Build. Mater., 21(5), 1040–1045.
Gordon, L. E., Provis, J. L., and van Deventer, J. S. J. (2011). “Non-traditional (“geopolymer”) cements and concretes for construction of large CCS equipment.” Energy Procedia, 4(0), 2058–2065.
Jaturapitakkul, C., and Cheerarot, R. (2003). “Development of bottom ash as pozzolanic material.” J. Mater. Civ. Eng., 15(1), 48–53.
Keleştemur, O., and Demirel, B. (2010). “Corrosion behavior of reinforcing steel embedded in concrete produced with finely ground pumice and silica fume.” Constr. Build. Mater., 24(10), 1898–1905.
Kong, D. L. Y., Sanjayan, J. G., and Sagoe-Crentsil, K. (2007). “Comparative performance of geopolymers made with metakaolin and fly ash after exposure to elevated temperatures.” Cem. Concr. Res., 37(12), 1583–1589.
Lee, S. T., Moon, H. Y., and Swamy, R. N. (2005). “Sulfate attack and role of silica fume in resisting strength loss.” Cem. Concr. Compos., 27(1), 65–76.
Malhotra, V. M. (2002). “Introduction: Sustainable development and concrete technology.” Concr. Int., 24, 22.
Nehdi, M., and Hayek, M. (2005). “Behavior of blended cement mortars exposed to sulfate solutions cycling in relative humidity.” Cem. Concr. Res., 35(4), 731–742.
Pacheco-Torgal, F., Abdollahnejad, Z., Camões, A. F., Jamshidi, M., and Ding, Y. (2012). “Durability of alkali-activated binders: A clear advantage over Portland cement or an unproven issue?” Constr. Build. Mater., 30(0), 400–405.
Pacheco-Torgal, F., Castro-Gomes, J., and Jalali, S. (2007). “Investigations about the effect of aggregates on strength and microstructure of geopolymeric mine waste mud binders.” Cem. Concr. Res., 37(6), 933–941.
Palomo, A., Grutzeck, M. W., and Blanco, M. T. (1999). “Alkali-activated fly ashes: A cement for the future.” Cem. Concr. Res., 29(8), 1323–1329.
Poon, C. S., Kou, S. C., and Lam, L. (2006). “Compressive strength, chloride diffusivity and pore structure of high performance metakaolin and silica fume concrete.” Constr. Build. Mater., 20(10), 858–865.
Rattanasak, U., and Chindaprasirt, P. (2009). “Influence of NaOH solution on the synthesis of fly ash geopolymer.” Miner. Eng., 22(12), 1073–1078.
Sata, V., Sathonsaowaphak, A., and Chindaprasirt, P. (2012). “Resistance of lignite bottom ash geopolymer mortar to sulfate and sulfuric acid attack.” Cem. Concr. Compos., 34(5), 700–708.
Sathonsaowaphak, A., Chindaprasirt, P., and Pimraksa, K. (2009). “Workability and strength of lignite bottom ash geopolymer mortar.” J. Hazard. Mater., 168(1), 44–50.
Skvara, F., Kopecky, L., Nemecek, J., and Bittnar, Z. (2006). “Microstructure of geopolymer materials based on fly ash.” Ceram. Silik., 50(4), 208–215.
Somna, K., Jaturapitakkul, C., Kajitvichyanukul, P., and Chindaprasirt, P. (2011). “NaOH-activated ground fly ash geopolymer cured at ambient temperature.” Fuel, 90(6), 2118–2124.
Thokchom, S., Ghosh, P., and Ghosh, S. (2010). “Performance of fly ash based geopolymer mortars in sulphate solution.” J. Eng. Sci. Technol. Rev., 3(1), 36–40.
Van Jaarsveld, J. G. S., Van Deventer, J. S. J., and Lukey, G. C. (2002). “The effect of composition and temperature on the properties of fly ash- and kaolinite-based geopolymers.” Chem. Eng. J., 89(1–3), 63–73.
Wongkeo, W., and Chaipanich, A. (2010). “Compressive strength, microstructure and thermal analysis of autoclaved and air cured structural lightweight concrete made with coal bottom ash and silica fume.” Mater. Sci. Eng. A, 527(16–17), 3676–3684.
Wongpa, J., Kiattikomol, K., Jaturapitakkul, C., and Chindaprasirt, P. (2010). “Compressive strength, modulus of elasticity, and water permeability of inorganic polymer concrete.” Mater. Des., 31(10), 4748–4754.
Zuda, L., Drchalová, J., Rovnaník, P., Bayer, P., Keršner, Z., and Černý, R. (2010). “Alkali-activated aluminosilicate composite with heat-resistant lightweight aggregates exposed to high temperatures: Mechanical and water transport properties.” Cem. Concr. Compos., 32(2), 157–163.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jan 24, 2012
Accepted: Apr 19, 2012
Published online: Apr 23, 2012
Published in print: Jan 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.