Simple Procedure for Determining Long-Term Chemical Shrinkage for Cementitious Systems Using Improved Standard Chemical Shrinkage Test
Publication: Journal of Materials in Civil Engineering
Volume 24, Issue 8
Abstract
In the past 10 years, renewed research interest has shown the benefits of internal curing by incorporating prewetted lightweight fine aggregate (LWFA) in high-performance concrete (HPC). To determine the optimum LWFA content, information about the propensity for shrinkage in the cement paste, specifically the chemical shrinkage value, is needed. However, information is lacking on how to determine the long-term chemical shrinkage value for HPC with supplementary cementitious materials (SCMs) and/or shrinkage-reducing admixture (SRA). The purpose of this research was to identify a simple procedure to determine long-term chemical shrinkage values for given cementitious systems with SCMs and/or SRA. Several improvement to ASTM C1608 (dilatometry procedure) were investigated. An experimental prediction model was adopted and verified to estimate long-term chemical shrinkage values for portland cement systems containing SCMs and/or SRA. A recommended procedure is proposed to determine the long-term chemical shrinkage values for HPC systems containing SCMs and/or SRA, and a modification to a commonly used LWFA proportioning equation is suggested.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank the Oregon Department of Transportation for financial support for this research effort.
References
ASTM. (2006). “Standard practice for mechanical mixing of hydraulic cement pastes and mortars of plastic consistency.” C305-06, West Conshohocken, PA.
ASTM. (2007a). “Standard practice for making and curing concrete test specimens in the laboratory.” C192-07, West Conshohocken, PA.
ASTM. (2007b). “Standard specification for Portland cement.” C150-07, West Conshohocken, PA.
ASTM. (2007c). “Standard test method for chemical shrinkage of hydraulic cement paste.” C1608-07, West Conshohocken, PA.
ASTM. (2007d). “Standard test method for density, relative density (specific gravity), and absorption of fine aggregate.” C128-07a, West Conshohocken, PA.
ASTM. (2008a). “Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete.” C618-08, West Conshohocken, PA.
ASTM. (2008b). “Standard test method for length change of hardened hydraulic-cement mortar and concrete.” C157-08, West Conshohocken, PA.
Bentz, D. P. (2007). “Internal curing of high-performance blended cement mortars.” ACI Mater. J.AMAJEF, 104(4), 408–414.
Bentz, D. P., Lura, P., and Roberts, J. W. (2005). “Mixture proportioning for internal curing.” Concr. Int.CNCIEH, 27(02), 35–40.
Bentz, D. P., and Snyder, K. A. (1999). “Protected paste volume in concrete: Extension to internal curing using saturated lightweight fine aggregate.” Cem. Concr. Res.CCNRAI, 29(11), 1863–1867.
Boivin, S., Acker, P., Rigaud, S., and Clavaud, B. (1998). “Experimental assessment of cemical shrinkage of hydrating cement paste.” Proc., Autoshrink ’98 Int. Workshop on Autogenous Shrinkage of Concrete, Lavoisier, Paris, 77–88.
Castro, J., Keiser, L., Golias, M., and Weiss, J. (2011). “Absorption and desorption properties of fine lightweight aggregate for application to internally cured concrete mixtures.” Cem. Concr. Compos.CCOCEG, 33(10), 1001–1008.
Costoya, M. (2008). “Effect of particle size on the hydration kinetics and microstructural development of tricalcium silicate.” Ph.D. thesis, No. 4102, Ecole Polytechnique Fédérale de Lausanne, Lausanne, Switzerland.
Cusson, D. (2008). “Effect of blended cements on effectiveness of internal curing of HPC.” SP-256, American Concrete Institute, Detroit, 105–120.
Cusson, D., and Hoogeveen, T. (2008). “Internal curing of high-performance concrete with pre-soaked fine lightweight aggregate for prevention of autogenous shrinkage cracking.” Cem. Concr. Res.CCNRAI, 38(6), 757–765.
Delatte, N., Crowl, D., Mack, E., and Cleary, J. (2008). “Evaluating high apsorptive materials to improve internal curing of concrete.” SP-256, American Concrete Institute, Detroit, 91–104.
Durán-Herrera, A., Aïtcin, P.-C., and Petrov, N. (2007). “Effect of saturated lightweight sand substitution on shrinkage in 0.35 concrete.” ACI Mater. J.AMAJEF, 104(1), 48–52.
Friggle, T., and Reeves, D. (2008). “Internal curing of concrete paving: Laboratory and field experience.” SP-256, American Concrete Institute, Detroit, 71–80.
Fu, T. (2011). “Autogenous deformation and chemical shrinkage of high performance cementitious systems.” M.S. thesis, Oregon State Univ., Corvallis, OR.
Henkensiefken, R., Castro, J., Kim, H., Bentz, D., and Weiss, J. (2009). “Internal curing improves concrete performance throughout its life.” Concr. InFocus, 8(5), 22–30.
Ideker, J. H. (2008). “Early-age behavior of calcium aluminate cement systems.” Ph.D. dissertation, Univ. of Texas, Austin, TX.
Jaouadi, I. (2008). “Etude numérique et expérimentale du retrait endogéne de la pâte de ciment au jeune âge.” Ph.D. dissertation, Ecole Polytechnique Fédérale de Lausanne, Lausanne, Switzerland.
Justnes, H., et al. (1998). “The influence of cement characteristics on chemical shrinkage.” Proc., Autoshrink ’98 Int. Workshop on Autogenous Shrinkage of Concrete, Lavoisier, Paris, 71–80.
Lura, P. (2003). “Autogenous deformation and internal curing of concrete.” Ph.D. dissertation, Science Centre, Delft Univ. of Technology, Delft, The Netherlands.
Lura, P., Jensen, O. M., and van Breugel, K. (2003). “Autogenous shrinkage in high-performance cement paste: An evaluation of basic mechanisms.” Cem. Concr. Res.CCNRAI, 33(2), 223–232.
Mounanga, P., Khelidj, A., Loukili, A., and Baroghel-Bouny, V. (2004). “Predicting content and chemical shrinkage of hydrating cement pastes using analytical approach.” Cem. Concr. Res.CCNRAI, 34(2), 255–265.
Paulini, P. (1992). “A weighing method for cement hydration.” Proc., 9th Int. Congress on the Chemistry of Cement, National Council for Cement and Building Materials, New Delhi, India, 248–254.
Sahmaran, M., Lachemi, M., Hossain, K. M. A., and Li, V. C. (2009). “Internal curing of engineered cementitious composites for prevention of early age autogenous shrinkage cracking.” Cem. Concr. Res.CCNRAI, 39(10), 893–901.
Sant, G., Bentz, D., and Weiss, J. (2011). “Capillary porosity depercolation in cement-based materials: Measurement techniques and factors which influence their interpretation.” Cem. Concr. Res.CCNRAI, 41(8), 854–864.
Sant, G., Lura, P., and Weiss, J. (2006). “Measurement of volume change in cementitious materials at early ages: Review of testing protocols and interpretation of results.” Transportation Research Record 1979, Transportation Research Board, Washington, DC, 21–29.
Schlitter, J., Henkensiefken, R., Castro, J., Raoufi, K., Weiss, J., and Nantung, T. (2010). “Development of internally cured concrete for increased service life.” INDOT Division of Research, SPR-3211, Purdue Univ., West Lafayette, IN.
Slatnick, S., Riding, K. A., Folliard, K. J., Juenger, M. C. G., and Schindler, A. K. (2011). “Evaluation of autogenous deformation of concrete at early ages.” ACI Mater. J.AMAJEF, 108(1), 21–28.
Termkhajornkit, P., Nawa, T., Nakai, M., and Saito, T. (2005). “Effect of fly ash on autogenous shrinkage.” Cem. Concr. Res.CCNRAI, 35(3), 473–482.
Trtik, P., et al. (2011). “Release of internal curing water from lightweight aggregates in cement paste investigated by neutron and X-ray tomography.” Nucl. Instrum. Methods Phys. Res., Sect. A., 651(1), 244–249.
Villarreal, V. H. (2008). “Internal curing: Real world ready mix production and applications: A practical approach to lightweight modified concrete.” SP-256, American Concrete Institute, Detroit, 45–56.
Villarreal, V. H., and Crocker, D. A. (2007). “Better pavements through internal hydration.” Concr. Int.CNCIEH, 29(02), 32–36.
Wei, Y., and Hansen, W. (2008). “Pre-soaked lightweight fine aggregates as additives for internal curing in concrerte.” SP-256, American Concrete Institute, Detroit, 35–44.
Xiao, K. T., Yang, H. Q., and Dong, Y. (2009). “Study on the influence of admixture on chemical shrinkage of cement based materials.” Key Eng. Mater.KEMAEY, 405–406, 226–233.
Yajun, J., and Cahyadi, J. (2004). “Simulation of silica fume blended cement hydration.” Mater. Struct.MASTED, 37(6), 397–404.
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Aug 7, 2011
Accepted: Jan 24, 2012
Published online: Jan 26, 2012
Published in print: Aug 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.