Poromechanical Damping of Cementitious Materials
Publication: Journal of Materials in Civil Engineering
Volume 24, Issue 2
Abstract
Other than through the creation of fracture surfaces, cementitious materials do not generally contribute significantly to strain energy dissipation or damping during dynamic loading of civil infrastructure. In this paper, the potential to increase damping of cementitious materials through utilization of poromechanical effects is evaluated. Pervious cement paste and mortar specimens were fabricated and their uniaxial damping measured at loading frequencies ranging from 0.01–25 Hz. To evaluate the poromechanical effect, the damping of specimens with water, glycerol, and glycerol/water blends constituting the pore fluid was measured, and the results were compared with the measured damping of dried specimens. It was found that significant poromechanical damping can be generated in cementitious materials, and the frequency at which the damping is maximized can be controlled by changing material properties that dictate the hydrodynamic relaxation time. It was also discovered that poromechanical modeling under predicts the measured damping increase induced by saturating porous concrete, indicating that the degree of saturation influences the inherent viscoelastic damping of cementitious materials.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank US Silica, BASF, and Grace Construction Products for providing materials for this research. This research was supported by the National Science Foundation under Grant No. NSFCMMI-0727143. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the authors and do not necessarily reflect the views of the National Science Foundation.
References
Bentur, A., Milestone, N. B., and Young, J. F. (1978). “Creep and drying shrinkage of calcium silicate pastes. II: Induced microstructural and chemical changes.” Cem. Concr. Res., 8(6), 721–732.
Brodt, M., Cook, L. S., and Lakes, R. S. (1995). “Apparatus for measuring viscoelastic properties over ten decades: Refinements.” Rev. Sci. Instrum., 66(11), 5292–5297.
Cheng, N.-S. (2008). “Formula for the viscosity of a glycerol—Water mixture.” Ind. Eng. Chem. Res., 47(9), 3285–3288.
Coussy, O. (2004). Poromechanics, Wiley, West Sussex, UK.
Coussy, O., and Monteiro, P. J. M. (2008). “Poroelastic model for concrete exposed to freezing temperatures.” Cem. Concr. Res., 38(1), 40–48.
Delatte, N., Mrkajic, A., and Miller, D. I. (2009). “Field and laboratory evaluation of pervious concrete pavements.” Transportation Research Record 2113, Transportation Research Board, Washington, DC, 132–139.
Grasley, Z. C., and Leung, C. K. (2011). “Quasi-static axial damping of poroviscoelastic cylinders.” J. Eng. Mech., 137(8), 561–570.
Grasley, Z. C., Scherer, G. W., Lange, D. A., and Valenza, J. J. (2007). “Dynamic pressurization method for measuring permeability and modulus: II. Cementitious materials.” Mater. Struct., 40(7), 711–721.
Haecker, C. J., et al. (2005). “Modeling the linear elastic properties of Portland cement paste.” Cem. Concr. Res., 35(10), 1948–1960.
Hashin, Z., and Shtrikman, S. (1963). “Variational approach to theory of elastic behaviour of multiphase materials.” J. Mech. Phys. Solids, 11(2), 127–140.
Jones, C. A., and Grasley, Z. C. (2009a). “Correlation of hollow and solid cylinder dynamic pressurization tests for measuring permeability.” Cem. Concr. Res., 39(4), 345–352.
Jones, C. A., and Grasley, Z. C. (2009b). “Correlation of radial flow-through and hollow cylinder dynamic pressurization test for measuring permeability.” J. Mater. Civ. Eng., 21(10), 594–600.
Jones, C. A., and Grasley, Z. C. (2009c). “Novel and flexible dual permeability measurement device for cementitious materials.” ACI Mater. J., 106(2), 192–197.
Klink, S. A. (1985). “Actual Poisson ratio of concrete.” J. Am. Concr. Inst., 82(6), 813–817.
Klink, S. A. (1992). “Cement and the elastic-constants of concrete.” Cem. Concr. Res., 22(5), 761–768.
Lakes, R. S. (2004). “Viscoelastic measurement techniques.” Rev. Sci. Instrum., 75(4), 797–810.
Mavko, G., Mukerji, T., and Dvorkin, J. (1998). The rock physics handbook: Tools for Seismic analysis of porous media, Cambridge University Press, Cambridge, UK.
Neville, A. M. (1996). Properties of concrete, Wiley, New York.
Oehlert, G. W. (1992). “A note on the delta method.” Am. Stat., 46(1), 27–29.
Persson, B. (1999). “Poisson’s ratio of high-performance concrete.” Cem. Concr. Res., 29(10), 1647–1653.
Scherer, G. W. (2004). “Characterization of saturated porous bodies.” Mater. Struct, 37(265), 21–30.
Scherer, G. W. (2006). “Dynamic pressurization method for measuring permeability and modulus: I. Theory.” Mater. Struct., 39(10), 1041–1057.
Thomas, J. J., Allen, A. J., and Jennings, H. M. (2008). “Structural changes to the calcium-silicate-hydrate gel phase of hydrated cement with age, drying, and resaturation.” J. Am. Ceram. Soc., 91(10), 3362–3369.
Ulm, F. J., Constantinides, G., and Heukamp, F. H. (2004). “Is concrete a poromechanics material?—A multiscale investigation of poroelastic properties.” Mater. Struct., 37(265), 43–58.
Vichit-Vadakan, W., and Scherer, G. W. (2002). “Measuring permeability of rigid materials by a beam-bending method: III, Cement paste.” J. Am. Ceram. Soc., 85(6), 1537–1544.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Mar 15, 2011
Accepted: Jul 20, 2011
Published online: Jul 22, 2011
Published in print: Feb 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.