Performance Evaluation of Asphalt Rubber in Porous Asphalt-Concrete Mixtures
Publication: Journal of Materials in Civil Engineering
Volume 23, Issue 3
Abstract
The purpose of this study was first to present the laboratory mix design results for porous asphalt concrete (PAC) mixtures blended with high-viscosity-graded cement (AR-80) and asphalt rubber (AR). In addition, the master curves of dynamic modulus were determined for both the unconfined and confined conditions to evaluate the rutting behavior of both PAC mixtures. The mix design results showed that the PAC open-graded mixture consisted of a relatively large percentage of coarse aggregate, with less than 15% of the material passing through a 2.36-mm (No. 8) sieve, which created a sufficient space for water drainage. The target air voids of approximately 20%, as well as the coefficient of permeability greater than , were established. Comparing the master curves of dynamic modulus between these two types of PAC mixtures indicated that the asphalt-rubber mixtures exhibited higher dynamic modulus at longer reduced times for both the unconfined and confined conditions. The experimental results of repeated triaxial-loaded and wheel tracking permanent deformation tests confirmed that the asphalt-rubber mixtures have superior performance against rutting. Furthermore, the high void of both PAC mixtures illustrated the validity of the principles of time-temperature superposition in the large strain of the viscoplastic stage during repeated triaxial-loaded permanent deformation tests.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported in part by the Ministry of Education, Taiwan, under the ATU Plan. The AR-80 testing cement was supplied by the Chinese Petroleum Corp., Taiwan. The writers are grateful for their assistance.
References
AASHTO. (2005a). “Standard method of test for determination of draindown characteristics in uncompacted asphalt mixtures.” T305-97, Washington, DC.
AASHTO. (2005b). “Standard method of test for resistance of compacted bituminous mixture to moisture induced damage.” T283-03, Washington, DC.
ASTM International. (1997a). “Standard specification for asphalt-rubber binder.” D6114-97, Philadelphia.
ASTM International. (1997b). “Standard specification for viscosity-graded asphalt cement.” D3381-97, Philadelphia.
ASTM International. (1997c). “Standard test method for dynamic modulus of asphalt mixtures.” D3497-79, Philadelphia.
ASTM International. (1997d). “Standard test method for permeability of granular soils (constant head).” D2434-68, Philadelphia.
Chehab, G. R., Kim, Y. R., Schapery, R. A., Witczak, M. W., and Bonaquist, R. (2002).“Time-temperature superposition principle for asphalt concrete with growing damage in tension state.” J. Assoc. Asphalt Paving Technol., 83, 559–593.
Chiu, C. T. (2008). “Use of ground rubber in asphalt pavements: Field trial and evaluation in Taiwan.” Resour. Conserv. Recycl., 52(3) 522–533.
Choubane, B., Sholar, G. A., Musselman, J. A., and Page, G. C. (1999). “Ten-year performance evaluation of asphalt-rubber surface mixes.” Transportation Research Record 1681, Transportation Research Board, Washington, DC, 10–18.
Gibson, N. H., Schwartz, C. W., Schapery, R. A., and Witczak, M. W. (2003). “Viscoelastic, viscoplastic, and damage modeling of asphalt concrete in unconfined compression.” Proc., 82nd Annual Meeting of the Transportation Research Board (CD-ROM), Transportation Research Board, Washington, DC.
Guidelines for porous asphalt pavement. (1996). Japan Road Association, Tokyo (in Japanese).
Ha, K., and Schapery, R. A. (1998). “A three-dimensional viscoelastic constitutive model for particulate composites with growing damage and its experimental verification.” Int. J. Solids Struct., 35(26-27), 3497–3517.
Molenaar, A. A. A., Meerkerk, A. J. J., Miradi, M., and van der Steen, T. (2006). “Performance of porous asphalt concrete.” 2006 Annual Meeting and Technical Session (CD-ROM), Association of Asphalt Paving Technologists, Lino Lakes, MN.
MS 2 mix design methods for asphalt concrete and other hot mix types, 6th Ed. (1993). The Asphalt Institute, Lexington, KY.
Nelson, P. M., and Abbott, P. G. (1990). “Acoustical performance of pervious macadam surfaces for high-speed roads.” Transportation Research Record 1265, Transportation Research Board, Washington, DC, 25–33.
Pellinen, T. K. (2001). “Investigation of the use of dynamic modulus as an indicator of hot-mix asphalt performance.” Ph.D. thesis, Arizona State Univ., Tempe, AZ.
Roberts, F. R., Kandhal, P. S., Brown, E. R., Lee, D. T., and Kennedy, T. W. (1996). Hot mix asphalt materials, mixture design, and construction, 2nd Ed., NAPA Education Foundation, Lanham, MD, 169–170.
Ruiz, A., Alberola, R., Perez, F., and Sanchez, B. (1990). “Porous asphalt mixtures in Spain.” Transportation Research Record 1265, Transportation Research Board, Washington, DC, 87–94.
Schapery, R. A. (1999). “Nonlinear viscoelastic and viscoplastic constitutive equations with growing damage.” Int. J. Fract., 97(1/4), 33–66.
Schwartz, C. W., Gibson, N. H., Schapery, R. A., and Witczak, M. W. (2002). “Viscoplasticity modeling of asphalt concrete behavior.” Proc., 15th ASCE Engineering Mechanics Conf. (CD-ROM), Columbia Univ., New York.
Taiwan Public Construction Commission. (2000). “Standard specification for porous asphalt concrete,” No. 0279a, Taiwan, Republic of China (in Chinese).
Van Heystraeten, G., and Moraux, C. (1990). “Ten years’ experience of porous asphalt in Belgium.” Transportation Research Record 1265, Transportation Research Board, Washington, DC, 34–40.
Watson, D. E., Moore, K. A., Williams, K., and Cooley, L. A. (2003) “Refinement of new generation open-graded friction course mix design.” Transportation Research Record 1832, Transportation Research Board, Washington, DC, 78–85.
Way, G. B. (2000). “Flagstaff I-40 overlay project nine years of success.” Transportation Research Record 1723, Transportation Research Board, Washington, DC, 45–52.
Witczak, T. W., Bari, J., and Quayum, M. (2003) “Superpave support and performance models management, field validation of the simple performance test.” National Cooperative Highway Research Program, Rep. No. 9-19, Arizona State Univ., Tempe, AZ.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Nov 8, 2008
Accepted: Sep 23, 2010
Published online: Sep 27, 2010
Published in print: Mar 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.