Neural Networks Modeling of Stress Growth in Asphalt Overlays due to Load and Thermal Effects during Reflection Cracking
Publication: Journal of Materials in Civil Engineering
Volume 23, Issue 3
Abstract
Although several techniques have been introduced to reduce reflective cracking, one of the primary forms of distress in hot-mix asphalt (HMA) overlays of flexible and rigid pavements, the underlying mechanism and causes of reflective cracking are not yet well understood. Fracture mechanics is used to understand the stable and progressive crack growth that often occurs in engineering components under varying applied stress. The stress intensity factor (SIF) is its basis and describes the stress state at the crack tip. This can be used with the appropriate material properties to calculate the rate at which the crack will propagate in a linear elastic manner. Unfortunately, the SIF is difficult to compute or measure, particularly if the crack is situated in a complex three-dimensional (3D) geometry or subjected to a non-simple stress state. In this study, the neural networks (NN) methodology is successfully used to model the SIF as cracks grow upward through a HMA overlay as a result of both load and thermal effects with and without reinforcing interlayers. Nearly 100,000 runs of a finite-element program were conducted to calculate the SIFs at the tip of the reflection crack for a wide variety of crack lengths and pavement structures. The coefficient of determination () of all the developed NN models except one was above 0.99. Owing to the rapid prediction of SIFs using developed NN models, the overall computer run time for a 20-year reflection cracking prediction of a typical overlay was significantly reduced.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adeli, H. (2001). “Neural networks in civil engineering: 1989–2000.” Comput. Aided Civ. Infrastruct. Eng., 16, 126–142.
Ahlrich, R. C. (1986). “Evaluation of asphalt rubber and engineering fabrics as pavement interlayers.” Misc. Paper GL-86-34 (Untraced Series N-86), Army Engineer Waterways Experiment Station, Vicksburg, MS.
Al-Qadi, I. L., Elseifi, M. A., and Leonard, D. (2004). “Development of an overlay design model for reflective cracking with and without steel reinforcement.” J. Assoc. Asphalt Pavement Technol., 72, 388–423.
Bozkurt, D. (2003). “Three dimensional finite element analysis to evaluate reflective cracking potential in asphalt concrete overlays.” Ph.D. thesis, Univ. of Illinois, Urbana-Champaign, IL.
Broek, D. (1984). Elementary engineering fracture mechanics. Martinus Nijhoff Publishers, The Hague, The Netherlands.
Bush, A. J., and Brooks, E. W. (2007). “Geosynthetic materials in reflective crack prevention.” Final Rep. SR 537, Oregon Dept. of Transportation, Salem, OR.
Button, J. W., and Lytton, R. L. (1987). “Evaluation of fabrics, fibers, and grids in overlays.” Proc. of the 6th Int. Conf. on Structural Design of Asphalt Pavements, Univ. of Michigan, 1, 925–934.
Cleveland, G. S., Button, J. W., and Lytton, R. L. (2002). “Geosynthetics in flexible and rigid pavement overlay systems to reduce reflection cracking.” Rep. No. FHWA/TX-02/1777-1, Texas Transportation Institute (TTI), Texas A & M Univ., College Station, TX.
Dougherity, M. (1995). “A review of neural networks applied to transport.” Transp. Res. C, 3(4), 247–260.
Finn, F. N., and Monismith, C. L. (1984). NCHRP synthesis of highway practice 116: Asphalt overlay design procedures, TRB, National Research Council, Washington, DC, 66.
Flintsch, G. W. (2003). “Soft computing applications in pavement and infrastructure management: State-of-the-art.” Proc of the 82nd Annual Meeting of the Transportation Research Board (CD-ROM), National Research Council, Washington, DC.
Gopalakrishnan, K., Ceylan, H., and Attoh-Okine, N. O., eds. (2010). Intelligent and soft computing in infrastructure systems engineering: Recent advances, Springer-Verlag, Berlin.
Haykin, S. (1999). Neural networks: A comprehensive foundation, Prentice-Hall, Englewood Cliffs, NJ.
Huang, Y. H. (1993). Pavement analysis and design, Prentice-Hall, Englewood Cliffs, NJ.
Kim, J., and Buttlar, W. G. (2002). “Analysis of reflective crack control system involving reinforcing grid over base-isolating interlayer mixture.” J. Transp. Eng., 128(4), 375–384.
Loizos, A., and Scarpas, T. (2005). Verification of falling weight deflectometer backanalysis using a dynamic finite elements simulation. Int. J. Pavement Eng., 6(2), 115–123.
Lytton, R. L. (1989). “Use of geotextiles for reinforcement and strain relief in asphaltic concrete.” Geotext. Geomembr., 8, 217–237.
Lytton, R. L., Uzan, J., Fernando, E. G., Roque, R., Hiltunen, D., and Stoffels, S. M. (1993). “Development and validation of performance prediction models and specifications for asphalt binders and paving mixes.” Rep. No. SHRP-A-357. Strategic Highway Research Program, National Research Council, Washington, DC.
Meier, R., and Tutumluer, E. (1998). “Uses of artificial neural networks in the mechanistic-empirical design of flexible pavements.” Proc. of the Int. Workshop on Artificial Intelligence and Mathematical Methods in Pavement and Geomechanical Engineering Systems, Florida International Univ., Miami.
Monismith, C. L., and Coetzee, N. F. (1980). “Reflection cracking: Analysis, laboratory studies and design consideration.” Proc. of Association of Asphalt Paving Technologists, 49, 268–313.
National Asphalt Pavement Association (NAPA). (2007). “News and Information FAQ,” 〈http://www.hotmix.org/〉 (Sept. 2007).
National Cooperative Highway Research Program (NCHRP). (2004). “Guide for mechanistic-empirical design of new and rehabilitated pavement structures,” National Cooperative Highway Research Program 1-37 A, 〈http://trb.org/mepdg〉.
Paris, P. C., and Erdogan, F. A. (1963). “Critical analysis of crack propagation laws. Transactions of the ASME,” J. Basic Eng., 85-D(4).
Roberts, F. L., Kandhal, P. S., Brown, E. R., Lee, D. Y., and Kennedy, T. W. (1996). Hot mix asphalt materials, mixture design and construction, NAPA Research and Education Foundation, Lanham, MD.
Scarpas, A., Blaauwendraad, J., de Bondt, A. H., and Molenaar, A. A. A. (1993). “CAPA: A modern tool for the analysis and design of pavements.” Proc. of the 2nd Int. Conf. on Reflective Cracking in Pavements, Taylor & Francis, Abingdon, UK, 121–128.
Shackelford, J. F. (1992). Material science for engineers, 3rd Ed., Macmillan, New York, 355–357.
Tada, H., Paris, P. C., and Irwin, G. W. (2000). The stress analysis of cracks handbook, 3rd Ed., American Society of Mechanical Engineers, New York, 11–13.
Tsai, F.-L., Lytton, R. L., and Lee, S.-I. (2010). “Prediction of reflection cracking in hot mix asphalt overlays.” Proc. of 2010 Annual Meeting of the Transportation Research Board (TRB) Conf., (CD-ROM), Washington, DC.
Tsoukalas, L. H., and Uhrig, R. E. (1997). Fuzzy and neural approaches in engineering, Wiley, New York.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 23 • Issue 3 • March 2011
Pages: 221 - 229
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Feb 9, 2009
Accepted: Jun 25, 2010
Published online: Jul 29, 2010
Published in print: Mar 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.