Analytical Model for Fiber-Reinforced Granular Soils under High Confining Stresses
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 9
Abstract
This technical note proposes a simple analytical model for predicting the shear strength behavior of fiber-reinforced granular soils under high confining stresses, where it can be assumed that pullout of fibers does not take place. The model presents an analytical expression derived from the force-equilibrium consideration incorporating several significant parameters describing the characteristics of the granular soil and the fibers, such as fiber content, aspect ratio, modulus of elasticity of fibers, specific gravity of fiber material, soil-fiber friction, initial orientation with respect to shear plane, normal confining stress, specific gravity of soil particles, angle of shearing resistance of soil, and void ratio of soil. The expression shows that inclusion of fibers in the granular soil induces cohesion, may be called apparent cohesion, as well as increase in normal stress on the shear failure plane, which are proportional to the fiber content and aspect ratio, implying that increase in shear strength is also proportional to the fiber content and aspect ratio. The results based on this model are discussed for some specific range of parameters in their practical ranges. It is observed that the increase in shear strength of the granular soil due to the presence of fibers is significantly contributed by the apparent cohesion, and the contribution to the shear strength from the increase in normal stress is limited. The model shows that the increase in shear strength follows the trends of variation as reported in some previous works.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers are thankful to Dr. Anirban Dhar, postdoctoral fellow, School of Engineering, James Cook University, Townsville, Australia for his valuable discussion on some basic concepts related to mechanics. The writers would also like to thank Mr. M. Zahid, Ph.D. student, School of Engineering, Edith Cowan University, Joondalup, Perth, WA for his help during the final revision of the manuscript of the paper.
References
Bauer, G. E., and Oancea, A. (1996). “Triaxial testing of granular soils reinforced with discrete polypropylene fibres.” Proc., 1st European Geosynthetics Conf. on Geosynthetics: Applications, Design and Construction, Balkema, Rotterdam, The Netherlands, 407–410.
Consoli, N. C., Casagrande, M. D. T., and Coop, M. R. (2007). “Performance of a fibre-reinforced sand at large shear strains.” Geotechnique, 57(9), 751–756.
Consoli, N. C., Montardo, J. P., Prietto, P. D. M., and Pasa, G. S. (2002). “Engineering behaviour of a sand reinforced with plastic waste.” J. Geotech. Geoenviron. Eng., 128(6), 462–472.
Consoli, N. C., Prietto, P. D. M., and Ulbrich, L. A. (1998). “Influence of fibre and cement addition on behaviour of sandy soil.” J. Geotech. Geoenviron. Eng., 124(12), 1211–1214.
Das, B. M. (1998). Principles of geotechnical engineering, 4th Ed., PWS, Boston.
Freitag, D. R. (1986). “Soil randomly reinforced with fiber.” J. Geotech. Engrg., 112(8), 823–826.
Gray, D. H., and Al-Refeai, T. (1986). “Behaviour of fabric versus fiber reinforced sand.” J. Geotech. Engrg., 112(8), 804–820.
Gray, D. H., and Maher, M. H. (1989). “Admixture stabilization of sands with discrete, randomly distributed fibers.” Proc., 12th Int. Conf. on Soil Mechanics and Foundation Engineering, Balkema, Rotterdam, 1363–1366.
Gray, D. H., and Ohashi, H. (1983). “Mechanics of fiber reinforcement in sand.” J. Geotech. Engrg., 109(3), 335–353.
Jewell, R. A. (1980). “Some factors which influence the shear strength of reinforced sand.” CUED/D-Soils/TR85, Dept. of Engineering, Cambridge Univ., Cambridge, U.K.
Jewell, R. A. (1987). “Direct shear tests on reinforced sand.” Geotechnique, 37(1), 53–68.
Kumar, R., Kanaujia, V. K., and Chandra, D. (1999). “Engineering behaviour of fibre-reinforced pond ash and silty sand.” Geosynthet. Int., 6(6), 509–518.
Lambe, T., and Whitman, R. V. (1979). Soil mechanics, SI Version, Wiley, New York.
Maher, M. H., and Gray, D. H. (1990). “Static response of sands reinforced with randomly distributed fibres.” J. Geotech. Engrg., 116(11), 1661–1677.
Michalowski, R. L. (2008). “Limit analysis with anisotropic fibre-reinforced soil.” Geotechnique, 58(6), 489–501.
Michalowski, R. L., and Cermak, J. (2003). “Triaxial compression of sand reinforced with fibres.” J. Geotech. Geoenviron. Eng., 129(2), 125–136.
Ranjan, G., Vasan, R. M., and Charan, H. D. (1996). “Probabilistic analysis of randomly distributed fibre-reinforced soil.” J. Geotech. Engrg., 122(6), 419–426.
Shewbridge, S. E., and Sitar, N. (1989). “Deformation characteristics of reinforced sand in direct shear.” J. Geotech. Engrg., 115(8), 1134–1147.
Shewbridge, S. E., and Sitar, N. (1990). “Deformation based model for reinforced sand.” J. Geotech. Engrg., 116(7), 1153–1170.
Shukla, S. K., Sivakugan, N., Das, B. M., and Singh, A. K. (2009). “Fundamental concepts of soil reinforcement—An overview.” Intl. J. Geotech. Eng., 3(3), 329–342.
Sivakumar Babu, G. L., and Vasudevan, A. K. (2008). “Strength and stiffness response of coir fiber-reinforced tropical soil.” J. Mater. Civ. Eng., 20(9), 571–577.
Waldron, L. J. (1977). “Shear resistance of root-permeated homogeneous and stratified soil.” Proc.- Soil Sci. Soc. Am., 41(5), 843–849.
Yetimoglu, T., and Salbas, O. (2003). “A study on shear strength of sands reinforced with randomly distributed discrete fibres.” Geotext. Geomembr., 21(2), 103–110.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Aug 27, 2008
Accepted: Dec 30, 2009
Published online: Jan 5, 2010
Published in print: Sep 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.