Performance of a Stabilized Aggregate Base Subject to Different Durability Procedures
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 5
Abstract
This study examined the effects of two freeze-thaw (FT) laboratory procedures, FT-1 and FT-2, on stabilized aggregate specimens. Cylindrical specimens were stabilized with 10% Class C fly ash (CFA) cured for selected periods and then subjected to either FT-1 or FT-2 cycles. FT-1 and FT-2 procedures consisted of freezing specimens at for 24 h and thawing them at for another 24 h with a high relative humidity; the only difference was that FT-1 required a membrane around each specimen, while FT-2 required no membranes during freezing and thawing. After being subject to freezing and thawing actions, specimens were then tested for resilient modulus and unconfined compressive strength (UCS) values. Results showed that the values of 28-day cured specimens increased as FT-1 cycles increased up to 12, beyond which a reduction in values was observed. For 3-day cured specimens the increased with FT-1 cycles up to 30. The UCS values of 28- and 3-day stabilized specimens also exhibited the same trend as the with FT-1 cycles. In addition, the specimens subject to 30 FT-2 cycles exhibited a higher reduction in values than the specimens subject to FT-1. This behavior is explained by the moisture increase in the specimens subject to FT-2 cycles which caused an ice lens formation in the fine matrix and destruction in the particle matrix. The study also showed that the -stress model recommended by the new mechanistic-empirical pavement design guide for unbound pavement materials could be a statistically good and a reliable predictor of the values of stabilized aggregate bases.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers are thankful to Mr. Charbel Khoury, Dr. Joakim Laguros, and Dr. Musharraf Zaman for their help.
References
Barbu, B. G., and Scullion, T. (2006). “Repeatability and reproducibility study for tube suction test.” Technical Rep. Submitted to Texas Dept. of Transportation, FHWA/TX–06/5/4114–01–1, FHWA, Austin, Tex.
Berg, K. C. (1998). “Durability and strength of activated reclaimed Iowa Class C fly ash aggregate in road bases.” MS thesis, Iowa State Univ., Ames, Iowa.
Bergeson, K. L., and Barnes, A. G. (1998). “Iowa thickness design and guide for low volume roads using reclaimed hydrated Class C fly ash bases.” ISU-ERI-Ames Rep. No. 98401, Iowa State Univ., Ames, Iowa.
Ferguson, G., and Levorson, S. M. (1999). Soil and pavement base stabilization with self-cementing coal fly ash, American Coal Ash Association, Alexandria, Va.
Guthrie, W. S., Roper, M. B., and Eggett, D. L. (2008). “Evaluation of laboratory durability tests for stabilized aggregate base materials.” Transportation Research Board 2008 Annual Meeting (CD-ROM), Transportation Res. Board, National Research Council, Washington, D.C.
Kalankamary, G. P., and Donald, D. T. (1963). “Development of a freeze-thaw test for design of soil-cement.” Highw. Res. Rec., 36, 77–96.
Khoury, N. N. (2001). “The effect of freeze-thaw and wet-dry cycles on resilient modulus of Class C fly ash stabilized aggregate base.” MS thesis, Univ. of Oklahoma, Norman, Okla.
Khoury, N. N. (2005). “Durability of cementitiously stabilized aggregate base for pavement application.” Ph.D. dissertation, Univ. of Oklahoma, Norman, Okla.
Khoury, N. N., and Zaman, M. (2002). “Effect of wet-dry cycles on Class C fly ash aggregate base.” Transp. Res. Rec., 1787, 13–21.
Khoury, N. N., and Zaman, M. (2007a). “Environmental effects on durability of aggregates stabilized with cementitious materials.” J. Mater. Civ. Eng., 19(1), 41–48.
Khoury, N. N., and Zaman, M. M. (2007b). “Influences of various cementitious agents on the performance of stabilized aggregate base subjected to wet-dry cycles.” Int. J. Pavement Eng., 8(4), 265–276.
Miller, A. G., Zaman, M. M., Rahman, J., and Tan, K. N. (1999). “Laboratory and field evaluation of soil stabilization using cement kiln dust.” Draft Rep. No. ORA 125-5693, Oklahoma Dept. of Transportation (ODOT), Oklahoma City, Okla.
National Cooperative Highway Research Report (NCHRP). (1976). Lime-fly ash-stabilized bases and subbases, Transportation Research Board, National Research Council, Washington, D.C.
National Cooperative Highway Research Report (NCHRP). (1997). “Laboratory determination of resilient modulus for flexible pavement design.” Final Rep. No. 1-28, National Cooperative Highway Program, Transportation Research Board, National Research Council, Washington, D.C.
National Cooperative Highway Research Report (NCHRP). (2000). “Harmonized test methods for laboratory determination of resilient modulus for flexible pavement design.” Draft Document, Prepared for National Cooperative Highway Research Program, Project Rep. No. 1-28A, Transportation Research Board, National Research Council, Washington, D.C.
Nunan, T., and Humphrey, D. (1990). “A review and experimentation of gravel stabilization methods.” Technical Services Division Technical Rep. No. 90-2, Federal Highway Administration, Washington, D.C.
Pandey, K. K. (1996). “Evaluation of resilient modulus and layer of coefficient of a coal ash stabilized marginal aggregate base for AASHTO flexible pavement design.” Ph.D. dissertation, Univ. of Oklahoma, Norman, Okla.
The Road Information Program (TRIP). (2008). “Key facts about America’s road and bridge conditions and federal funding.” ⟨http://www.tripnet.org⟩ (March 2008).
Sobhan, K., and Krizek, R. (1998). “Resilient properties and fatigue damage in stabilized recycled aggregate base course material.” Transp. Res. Rec., 1611, 28–37.
Syed, I., Scullion, T., and Randolph, R. (2000). “Tube suction test for evaluating aggregate base materials in frost- and moisture-susceptibility environments.” Transp. Res. Rec., 1709, 78–90.
Thompson, M. R., and Smith, K. L. (1990). “Repeated triaxial characterization of granular bases.” Transp. Res., 1278, 7–17.
Zaman, M. M., Zhu, J., and Laguros, J. G. (1999). “Durability effects on resilient moduli of stabilized aggregate base.” Transportation Research Record. 1687, TRB, National Research Council, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Sep 4, 2008
Accepted: Oct 22, 2009
Published online: Oct 24, 2009
Published in print: May 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.