Gene-Expression Programming Approach for Development of a Mathematical Model of Energy Dissipation on Block Ramps
Publication: Journal of Irrigation and Drainage Engineering
Volume 146, Issue 2
Abstract
A block ramp is an environmentally friendly stream restoration structure consisting of a base material of stone with minimal negative environmental impact. This not only decreases riverbed shear stress but also increases the flow resistance, thus reducing excess kinetic energy of the flow. This study used two mathematical models that were developed in a dimensionless form for smooth and rough-bed ramps. The models were calibrated and validated by two sets of experimental tests. A total of 308 experimental runs were done with eight different ramp slopes and six different gravel material sizes. The experimental results indicated that an increase in the relative roughness enhances energy dissipation. Additionally, energy dissipation increases along with an increase of ramp slope. Using a gene-expression programming soft computing model, two mathematical models were developed to estimate energy dissipation on smooth and rough-bed ramps. Additionally, the energy-loss performance of two configurations of interlocked and dumped blocks ramps was compared.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the Vice Chancellor for Research of Shahid Chamran University of Ahvaz for providing financial support to conduct this study (Grant No. 95/3/2/62356).
References
Ahmad, A., and D. Srisvastava. 2014. “Energy dissipation on block ramp with large scale roughness.” In Proc., 5th Int. Symp. on Hydraulic Structures: Hydraulic Structures and Society-Engineering Challenges and Extremes. Barton, Australia: Engineers Australia.
Ahmad, Z., N. M. Pentappa, and B. Westrich. 2009. “Energy dissipation on block ramps with staggered boulders.” J. Hydraul. Eng. 135 (6): 522–526. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000039.
Azamathulla, H. M., C. K. Chang, A. A. Ghani, J. Ariffin, N. A. Zakaria, and Z. Abu Hasan. 2009. “An ANFIS-based approach for predicting the bed load for moderately sized rivers.” J. Hydro-Environ. Res. 3 (1): 35–44. https://doi.org/10.1016/j.jher.2008.10.003.
Azamathulla, H. M., and A. A. Ghani. 2010. “Genetic programming to predict river pipeline scour.” J. Pipeline Syst. Eng. Pract. 1 (3): 127–132. https://doi.org/10.1061/(ASCE)PS.1949-1204.0000060.
Barenblatt, G. I. 1987. Dimensional analysis. Amsterdam, Netherlands: Gordon & Breach Science.
Bathurst, J. C. 1978. “Flow resistance of large-scale roughness.” J. Hydraul. Div. 104 (12): 1587–1603.
Bathurst, J. C., R. M. Li, and D. B. Simons. 1981. “Resistance equation for large scale roughness.” J. Hydraul. Div. 107 (12): 1593–1613.
Fathi-Moghaddam, M., M. Tavakol Sadrabadi, and M. Rahmanshahi. 2018. “Numerical simulation of the hydraulic performance of triangular and trapezoidal gabion weirs in free flow condition.” Flow Meas. Instrum. 62 (Aug): 93–104. https://doi.org/10.1016/j.flowmeasinst.2018.05.005.
Felder, S., and H. Chanson. 2016. “Simple design criterion for residual energy on embankment dam stepped spillways.” J. Hydraul. Eng. 142 (4): 1–11. https://doi.org/10.1061/(ASCE)HY.1943-7900.0001107.
Ferreira, C. 2001a. “Gene expression programming: A new adaptive algorithm for solving problems.” Complex Syst. 13 (2): 87–129.
Ferreira, C. 2001b. “Gene expression programming in problem solving.” In Proc., 6th Online World Conf. on Soft Computing in Industrial Applications, 635–653. London: Springer.
Ferro, V. 1999. “Evaluating friction factor for gravel bed channel with high boulder concentration.” J. Hydraul. Eng. 125 (7): 771–778. https://doi.org/10.1061/(ASCE)0733-9429(1999)125:7(771).
Ghare, A. D., R. N. Ingle, P. D. Porey, and S. S. Gokhale. 2010. “Block ramp design for efficient energy dissipation.” J. Energy Eng. 136 (1): 1–5. https://doi.org/10.1061/(ASCE)0733-9402(2010)136:1(1).
Giustolisi, O., A. Doglioni, D. A. Savic, and B. W. Webb. 2007. “A multi-model approach to analysis of environmental phenomena.” Environ. Modell. Software 22 (5): 674–682. https://doi.org/10.1016/j.envsoft.2005.12.026.
Horton, R. E. 1907. “Weir experiments, coefficients, and formulas.” In Proc., US Geological Survey Water Supply. Washington, DC: Government Printing Office.
Lawrence, D. S. L. 1997. “Macroscale surface roughness and frictional resistance in overland flow.” Earth Surf. Processes Landforms 22 (4): 365–382. https://doi.org/10.1002/(SICI)1096-9837(199704)22:4%3C365::AID-ESP693%3E3.0.CO;2-6.
Mohamed, H. 2010. “Flow over gabion weirs.” J. Irrig. Drain. Eng. 136 (8): 573–577. https://doi.org/10.1061/(ASCE)IR.1943-4774.0000215.
Novak, P., and J. Cabelka. 1981. Models in hydraulic engineering. London: Pitman.
Oertel, M., S. Peterseim, and A. Schlenkhoff. 2011. “Drag coefficients of boulders on a block ramp due to interaction processes.” J. Hydraul. Res. 49 (3): 372–377. https://doi.org/10.1080/00221686.2011.565695.
Oertel, M., and A. Schlenkhoff. 2012. “Crossbar block ramps: Flow regimes, energy dissipation, friction factors, and drag forces.” J. Hydraul. Eng. 138 (5): 440–448. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000522.
Pagliara, S. 2007. “Influence of sediment gradation on scour downstream of block ramps.” J. Hydraul. Eng. 133 (11): 1241–1248. https://doi.org/10.1061/(ASCE)0733-9429(2007)133:11(1241).
Pagliara, S., I. Carnacina, and T. Roshni. 2010a. “Air-water flows in the presence of staggered and row boulders under macroroughness conditions.” Water Resour. Res. 46 (8): 1–11. https://doi.org/10.1029/2009WR008834.
Pagliara, S., I. Carnacina, and T. Roshni. 2010b. “Self-aeration and friction over rock chutes in uniform flow condition.” J. Hdraul. Eng. 136 (11): 959–964. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000270.
Pagliara, S., I. Carnacina, and T. Roshni. 2011. “Inception point and air entrainment on flows under macroroughness conditions.” J. Environ. Eng. 137 (7): 629–638. https://doi.org/10.1061/(ASCE)EE.1943-7870.0000369.
Pagliara, S., and P. Chiavaccini. 2004. “Stability of reinforced block ramps.” In Proc., 2004 River flow Int. Conf., 1291–1295. Rotterdam, Netherlands: A.A. Balkema.
Pagliara, S., and P. Chiavaccini. 2006a. “Energy dissipation on block ramps.” J. Hydraul. Eng. 132 (1): 41–48. https://doi.org/10.1061/(ASCE)0733-9429(2006)132:1(41).
Pagliara, S., and P. Chiavaccini. 2006b. “Energy dissipation on reinforced block ramps.” J. Irrig. Drain. Eng. 132 (3): 293. https://doi.org/10.1061/(ASCE)0733-9437(2006)132:3(293).
Pagliara, S., and P. Chiavaccini. 2006c. “Flow resistance of rock chutes with protruding boulders.” J. Hydraul. Eng. 132 (6): 545–552. https://doi.org/10.1061/(ASCE)0733-9429(2006)132:6(545).
Pagliara, S., and P. Chiavaccini. 2007. “Failure mechanisms of base and reinforced block ramps.” J. Hydraul. Res. 45 (3): 407–420. https://doi.org/10.1080/00221686.2007.9521774.
Pagliara, S., R. Das, and I. Carnacina. 2008a. “Flow resistance in large-scale roughness condition.” Can. J. Civ. Eng. 35 (11): 1285–1293. https://doi.org/10.1139/L08-068.
Pagliara, S., R. Das, and M. Palermo. 2008b. “Energy dissipation on submerged block ramps.” J. Irrig. Drain. Eng. 134 (4): 527–532. https://doi.org/10.1061/(ASCE)0733-9437(2008)134:4(527).
Pagliara, S., and I. Lotti. 2009. “Surface and sub-surface flow through the block ramps.” J. Hydraul. Eng. 135 (3): 366–374. https://doi.org/10.1061/(ASCE)IR.1943-4774.0000070.
Pagliara, S., and M. Palermo. 2008. “Scour control downstream of block ramps.” J. Hydraul. Eng. 134 (9): 1376–1382. https://doi.org/10.1061/(ASCE)0733-9429(2008)134:9(1376).
Pagliara, S., and M. Palermo. 2010. “Influence of tailwater depth and pile position on scour downstream of block ramps.” J. Irrig. Drain. Eng. 1236 (2): 120–130. https://doi.org/10.1061/(ASCE)IR.1943-4774.0000132.
Rice, C. E., K. C. Kadavy, and K. M. Robinson. 1998. “Roughness of loose rock riprap on steep slopes.” J. Hydraul. Eng. 124 (2): 179–185. https://doi.org/10.1061/(ASCE)0733-9429(1998)124:2(179).
Shafai Bejestan, M., and G. Kazemi Nasaban. 2011. “Experimental study on gabion stepped spillway.” In Proc., Experimental Methods in Hydraulic Research, 267–274. Berlin: Springer.
Stephenson, D. 1979a. “Gabion energy dissipators.” In Q5R3, Proc., 13th ICOLD Congress, 33–43. Paris: Commission Internationale des Grands Barrages.
Stephenson, D. 1979b. Rock fill in hydraulic engineering. Oxford, UK: Elsevier.
Tamagni, S., V. Weitbrecht, and R. M. Boes. 2010. “Design of unstructured block ramps: A State-of-the-art review.” In Proc., River Flow 2010, edited by A. Dittrich, K. Koll, J. Aberle and P. Geisenhainer, 729–736. Karlsruhe, Germany: Bundesanstalt für Wasserbau.
Zhang, G., and H. Chanson. 2016. “Hydraulics of the developing flow region of stepped spillways, I: Physical modelling and boundary layer development.” J. Hydraul. Eng. 142 (7): 04016015. https://doi.org/10.1061/(ASCE)HY.1943-7900.0001138.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Sep 1, 2018
Accepted: Sep 11, 2019
Published online: Dec 6, 2019
Published in print: Feb 1, 2020
Discussion open until: May 6, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.