Accuracy of Calculation of Parameters for Characterization of Emitters in Trickle Irrigation
Publication: Journal of Irrigation and Drainage Engineering
Volume 143, Issue 11
Abstract
Indoor laboratory tests were carried out to determine the accuracy with which the coefficient of manufacturing variation (), the discharge coefficient (), and the emitter discharge exponent () may be measured and calculated, and the number of significant digits to be reported in the published data. An error analysis and the propagation of the error in the formulas beginning from the experimental uncertainties of the instruments were used. Two calculation methods were used and compared to obtain and : the method of the two measurements and the data regression analysis. The results showed that, because of a calculation error of 15%, the maximum precision of the obtained in this analysis allowed the use of only one decimal of significant digits. As regards and , the method of the two measurements showed high levels of uncertainty (9% for and 3.6% for , respectively) despite the accuracy of the measurements; therefore, only two significant decimal digits for and no decimals for were indicated. The regression analysis method was more precise, with a precision of 1.7% and one decimal significant digit for and a precision of 0.5% and three decimals for . Therefore, the results showed that, when publishing the values of the parameters to characterize trickle emitters, the calculation method used should be reported along with the degree of accuracy of the measurements in order to improve the assessment of their actual characteristics, allowing a more objective comparison among similar products of different companies.
Get full access to this article
View all available purchase options and get full access to this article.
References
ASABE (American Society of Agricultural Bioengineers). (2011). Standards EP 405.1 design and installation of microirrigation systems, St. Joseph, MI, 1140–1144.
Baiamonte, G., Provenzano, G., and Rallo, G. (2015). “Analytical approach determining the optimal length of paired drip laterals in uniformly sloped fields.” J. Irrig. Drain. Eng., 04014042.
Bertolacci, M. (2000). Risultati delle prove funzionali su linee gocciolanti integrali [Results of functional tests on integral drip lines], Quaderno ARSIA 2, Regione Toscana, Italy (in Italian).
Boswell, M. J. (1984). Micro-irrigation design manual, James Hardie Irrigation, El Cajon, CA.
Bralts, V. F., Wu, I. P., and Gitlin, H. M. (1981). “Manufacturing variation and drip irrigation uniformity.” Trans. ASAE, 24(1), 113–119.
Burt, C., and Styles, S. W. (1999). Drip and micro irrigation for trees, vines, and row crops: Design and management (with special sections on SDI), Irrigation Training and Research Center, San Luis Obispo, CA.
Ella, V. B., Reyes, M. R., and Yoder, R. (2009). “Effect of hydraulic head and slope on water distribution uniformity of a low-cost drip irrigation system.” Appl. Eng. Agric., 25(3), 349–356.
Hathoot, H. M., Al-Amoud, A. I., and Mohammad, F. S. (1993). “Analysis and design of trickle-irrigation laterals.” J. Irrig. Drain. Eng., 756–767.
ISO. (2004). Agricultural irrigation equipment—Emitters and emitting pipe—Specification and test methods, Geneva.
Kang, Y., and Nishiyama, S. (1996). “Analysis and design of microirrigation laterals.” J. Irrig. Drain. Eng., 75–82.
Karmeli, D., and Keller, J. (1975). Trickle irrigation design, Rain Bird Sprinkler Manufacturing Corporation, Glendora, CA.
Keller, J., and Bliesner, R. D. (2000). Sprinkle and trickle irrigation, Blackburn Press, Caldwell, NJ.
Khemaies, Z., Moncef, H., Aws, A., and Adarrazak, S. (2013). “Design of nonzero uniformly sloping laterals in trickle irrigation systems.” J. Irrig. Drain. Eng., 419–425.
Koech, R., et al. (2015). “Intercomparison dripper testing within the INITL.” Flow Meas. Instrum., 1–11.
Lamm, F. R., Ayars, J. E., and Nakayama, F. S., eds. (2006). Microirrigation for crop production—Design, operation and management, Elsevier B.V., Amsterdam, Netherlands.
Ozekici, B., and Sneed, R. E. (1995). “Manufacturing variation for various trickle irrigation on-line emitters.” Appl. Eng. Agric., 11(2), 235–240.
Perea, H., Enciso-Medina, J., Singh, V. P., Dutta, D. P., and Lesikar, B. J. (2013). “Statistical analysis of non-pressure-compensating and pressure-compensating emitters.” J. Irrig. Drain. Eng., 986–994.
Provenzano, G., and Pumo, D. (2004). “Experimental analysis of local pressure losses for drip irrigation laterals.” J. Irrig. Drain. Eng., 318–324.
Rieul, L., and Ruelle, P. (1992). Irrigation: Guide pratique, CEMAGREF & CEP-Groupe France Agricole, Paris.
SigmaPlot [Computer software]. Systat Software, Inc., San Jose, CA.
Solomon, K. (1979). “Manufacturing variation of trickle emitters.” Trans. ASAE, 22(5), 1034–1038.
Taylor, J. (1997). An introduction to error analysis: The study of uncertainties in physical measurements, University Science Books, New York.
Thorburn, P. J., Cook, F. J., and Bristow, K. L. (2003). “Soil-dependent wetting from trickle emitters: Implications for system design and management.” Irrig. Sci., 22(3–4), 121–127.
Van der Gulik, T. W. (1999). B.C. trickle irrigation manual, British Columbia Ministry of Agriculture and Food, Vernon, BC.
Wu, I. P., and Barragan, J. (2000). “Design criteria for microirrigation systems.” Trans. ASAE, 43(5), 1145–1154.
Yıldırım, G. (2015). “Computer-based analysis of hydraulic design variables for uniformly sloping microirrigation system laterals.” J. Irrig. Drain. Eng., 04014079.
Zhangzhong, L., Yang, P., Ren, S., Liu, Y., and Li, Y. (2015). “Flow characteristics and pressure-compensating mechanism of non-pressure-compensating drip irrigation emitters.” Irrig. Drain., 64(5), 637–646.
Zhu, D., Wu, P., and Wang, J. (2011). “Effect of emitters manufacturing variation of micro-irrigation on uniformity and lateral cost.” J. Drain. Irrig. Mach. Eng., 29(2), 175–179.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Dec 14, 2016
Accepted: May 12, 2017
Published online: Aug 19, 2017
Published in print: Nov 1, 2017
Discussion open until: Jan 19, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.