Hydrodynamic Structure and Turbulent Characteristics of Low-Slope Bedrock Bend Reach with Constant Curvature
Publication: Journal of Hydraulic Engineering
Volume 148, Issue 9
Abstract
Recent studies have indicated that low-slope bedrock reaches are more common in nature (the bedrock surface slope is slightly lower than 0.005). This paper focuses on the hydrodynamic structure and turbulent characteristics of low-slope and critically sharp bedrock bends under flood conditions. Three experiments under different flood frequencies were conducted to investigate the influence of the ratio of centerline curvature radius to depth () on the distribution and characteristics of the secondary flow, turbulence, and momentum transport measured by acoustic Doppler velocimeter (ADV). The results were then compared with the flow structure of a sharp bend. Our results indicated that the distribution area and the intensity of the secondary flow decreased with , especially in the outer-bank cell and the center-region cell. The lower was, the more obvious the flow separation at the inner bank was. The core area of the turbulent kinetic energy moved upstream gradually, and its intensity increased with . The friction factor increased in the upstream bend and did not move further upstream when was below 13.6. The intensity of the transverse bed shear stress decreased with in a critically sharp bend, and the maximum value near the upstream centerline implied the potential erosion in the bedrock bend. These experimental results are conducive to understanding the flow process of erosion and deposition in the bedrock bend reach.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data that support the findings of this study are available from Bin Li at [email protected] upon request.
Acknowledgments
This study was funded by the National Natural Science Foundation of China (Grant Nos. 51979185 and 51879182). Yiyao Zhou is acknowledged for assisting in this research.
References
Blanckaert, K. 2009. “Saturation of curvature-induced secondary flow, energy losses, and turbulence in sharp open-channel bends: Laboratory experiments, analysis, and modeling.” J. Geophys. Res. 114 (F03015): 15. https://doi.org/10.1029/2008JF001137.
Blanckaert, K. 2011. “Hydrodynamic processes in sharp meander bends and their morphological implications.” J. Geophys. Res. Earth Surf. 116 (F01003): 10. https://doi.org/10.1029/2010JF001806.
Blanckaert, K. 2015. “Flow separation at convex banks in open channels.” J. Fluid Mech. 779 (Sep): 432–467. https://doi.org/10.1017/jfm.2015.397.
Blanckaert, K., A. Duarte, Q. Chen, and A. J. Schleiss. 2012. “Flow processes near smooth and rough (concave) outer banks in curved open channels.” J. Geophys. Res. Earth Surf. 117 (4): 1–17. https://doi.org/10.1029/2012JF002414.
Deng, S., et al. 2021. “Secondary flow and flow redistribution in two sharp bends on the middle Yangtze River.” Water Resour. Res. 57 (10): 1–12. https://doi.org/10.1029/2020WR028534.
Díaz Lozada, J. M., C. M. García, G. Scacchi, and K. A. Oberg. 2021. “Dynamic selection of exposure time for turbulent flow measurements.” J. Hydraul. Eng. 147 (10): 04021035. https://doi.org/10.1061/(ASCE)HY.1943-7900.0001922.
Ferreira Da Silva, A. M., and M. Ebrahimi. 2017. “Meandering morphodynamics: Insights from laboratory and numerical experiments and beyond.” J. Hydraul. Eng. 143 (9): 03117005. https://doi.org/10.1061/(ASCE)HY.1943-7900.0001324.
Hicks, F. E., Y. C. Jin, and P. M. Steffler. 1990. “Flow near sloped bank in curved channel.” J. Hydraul. Eng. 116 (1): 55–70. https://doi.org/10.1061/(ASCE)0733-9429(1990)116:1(55).
Hu, C., M. Yu, H. Wei, and C. Liu. 2019. “The mechanisms of energy transformation in sharp open-channel bends: Analysis based on experiments in a laboratory flume.” J. Hydrol. 571 (Sep): 723–739. https://doi.org/10.1016/j.jhydrol.2019.01.074.
Inoue, T., and J. M. Nelson. 2020. “An experimental study of longitudinal incisional grooves in a mixed bedrock–alluvial channel.” Water Resour. Res. 56 (3): 1–16. https://doi.org/10.1029/2019WR025410.
Jafarinik, S., and E. Viparelli. 2020. “Alluvial morphodynamics of low-slope bedrock reaches transporting nonuniform bed material.” Water Resour. Res. 56 (10): 1–22. https://doi.org/10.1029/2020WR027345.
Mishra, J., T. Inoue, Y. Shimizu, T. Sumner, and J. M. Nelson. 2018. “Consequences of abrading bed load on vertical and lateral bedrock erosion in a curved experimental channel.” J. Geophys. Res. Earth Surf. 123 (12): 3147–3161. https://doi.org/10.1029/2017JF004387.
Odgaard, A. J. 1984. “Flow and bed topography in alluvial channel bend.” J. Hydraul. Eng. 110 (4): 521–536. https://doi.org/10.1061/(ASCE)0733-9429(1984)110:4(521).
Russell, P., and R. Vennell. 2019. “High resolution observations of an outer-bank cell of secondary circulation in a natural river bend.” J. Hydraul. Eng. 145 (5): 04019012. https://doi.org/10.1061/(ASCE)HY.1943-7900.0001584.
Tinkler, K., and E. Wohl. 1998. A primer on bedrock channels. Washington, DC: American Geophysical Union.
Venditti, J. G., et al. 2014. “Flow in bedrock canyons.” Nature 513 (7519): 534–537. https://doi.org/10.1038/nature13779.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Aug 19, 2021
Accepted: Apr 1, 2022
Published online: Jun 24, 2022
Published in print: Sep 1, 2022
Discussion open until: Nov 24, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.