Modeling Flow Exchanges between a Street and an Underground Drainage Pipe during Urban Floods
Publication: Journal of Hydraulic Engineering
Volume 140, Issue 10
Abstract
Modelling floods in urban areas generally requires the modelling of both surface and subsurface flows, along with the exchange discharges between these flows. These latter exchanges are studied on an experimental facility at the Ujigawa Open Laboratory of Kyoto University representing a typical urban drainage system with a single street connected through inlets to a drainage pipe located underneath. An exchange model is developed for the cases in which exchange flows are pressurized, applying a head balance between the surface and subsurface layers and using common head loss formulae. Results of the exchange model agree with experimental measurements and show that, for this experimental setup, the exchanges cannot be modelled by fitting a simple and commonly used orifice-type equation. A hydrodynamic model coupling the one-dimensional (1D) and two-dimensional (2D) shallow water equations for, respectively, the pipe and the street flows and including the analytical exchange model is used to simulate the experimental flows. The numerical model can simulate the global characteristics of both street and pipe flows but shows some discrepancies concerning local perturbations of street flow because of the exchange processes.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Experiments were carried out during a stay of the first author at the Ujigawa Open Laboratory of the Disaster Prevention Research Institute, Kyoto University, with a support of the Japanese Society for the Promotion of Science (Postdoctoral Fellowship for Foreign Researchers, grant number PE12501) and the French region Rhône-Alpes under the ExploraDoc program (grant number 11-015439-01).
References
Aricò, C., Sinagra, M., Begnudelli, L., and Tucciarelli, T. (2011). “MAST-2D diffusive model for flood prediction on domains with triangular Delaunay unstructured meshes.” Adv. Water Resour., 34(11), 1427–1449.
Despotovic, J., Plavsic, J., Stefanovic, N., and Pavlovic, D. (2005). “Inefficiency of storm water inlets as a source of urban floods.” Water Sci. Technol., 51(2), 139–145.
Djordjevic, S., et al. (2013). “Experimental and numerical investigation of interactions between above and below ground drainage systems.” Water Sci. Technol., 67(3), 535–542.
Djordjevic, S., Prodanovic, D., Maksimovic, C., Ivetic, M., and Savic, D. (2005). “SIPSON—Simulation of interaction between pipe flow and surface overland flow in networks.” Water Sci. Technol., 52(5), 275–283.
El Kadi Abderrezzak, K., and Paquier, A. (2011). “Applicability of sediment transport capacity formulas to dam-break flows over movable beds.” J. Hydraul. Eng., 209–221.
Ettrich, N., Steiner, K., Thomas, M., and Rothe, R. (2005). “Surface models for coupled modelling of runoff and sewer flow in urban areas.” Water Sci. Technol., 52(5), 25–33.
Fang, X., and Su, D. H. (2006). “An integrated one-dimensional and two-dimensional urban stormwater flood simulation model.” J. Am. Water Resour. Assoc., 42(3), 713–724.
Gallegos, H. A., Schubert, J. E., and Sanders, B. F. (2009). “Two-dimensional, high-resolution modeling of urban dam-break flooding: A case study of Baldwin Hills, California.” Adv. Water Resour., 32(8), 1323–1335.
Gomez, M., Macchione, F., and Russo, B. (2011). “Methodologies to study the surface hydraulic behaviour of urban catchments during storm events.” Water Sci. Technol., 63(11), 2666–2673.
Gomez, M., and Russo, B. (2009). “Hydraulic efficiency of continuous transverse grates for paved areas.” J. Irrig. Drain. Eng., 225–230.
Hilden, M. (2005). “Simulation of floods caused by overloaded sewer systems: Extensions of shallow-water equations.” Hydrol. Processes, 19(5), 1037–1053.
Idelchik, I. E., and Steinberg, O. (1996). Handbook of hydraulic resistance, Begell House, New York.
Kawaike, K., Nakagawa, H., Baba, Y., and Shimizu, A. (2011). “Experimental study on validation of stormwater interaction model between the ground surface and sewerage system.” Proc., Conf. on Hydraulics in Water Engineering (10th), Engineers Australia, Barton, Australia, 1889–1896.
Leandro, J., Chen, A. S., Djordjevic, S., and Savic, D. A. (2009). “Comparison of 1D/1D and 1D/2D coupled (sewer/surface) hydraulic models for urban flood simulation.” J. Hydraul. Eng., 495–504.
Leandro, J., Djordjevic, S., Chen, A., and Savic, D. (2007). “The use of multiple-linking-element for connecting sewer and surface drainage networks.” Proc., 32nd Congress of IAHR-Harmonizing the Demands of Art and Nature in Hydraulics.
Leandro, J., Djordjevic, S., Chen, A. S., Savic, D. A., and Stanic, M. (2011). “Calibration of a 1D/1D urban flood model using 1D/2D model results in the absence of field data.” Water Sci. Technol., 64(5), 1016–1024.
Lipeme Kouyi, G., Fraisse, D., Rivière, N., Guinot, V., and Chocat, B. (2009). “One-dimensional modelling of the interactions between heavy rainfall-runoff in an urban area and flooding flows from sewer networks and rivers.” Water Sci. Technol., 60(4), 927–934.
Mark, O., Weesakul, S., Apirumanekul, C., Aroonnet, S. B., and Djordjevic, S. (2004). “Potential and limitations of 1D modelling of urban flooding.” J. Hydrol., 299(3–4), 284–299.
Mignot, E., Paquier, A., and Haider, S. (2006). “Modeling floods in a dense urban area using 2D shallow water equations.” J. Hydrol., 327(1–2), 186–199.
Mignot, E., Paquier, A., and Riviere, N. (2008). “Experimental and numerical modeling of symmetrical four-branch supercritical cross junction flow.” J. Hydraul. Res., 46(6), 723–738.
Miller, D. S. (1978). Internal flow systems, BHRA Fluid Engineering, Cranfield, Bedfordshire, U.K.
Nasello, C., and Tucciarelli, T. (2005). “Dual multilevel urban drainage model.” J. Hydraul. Eng., 748–754.
Schmitt, T. G., Thomas, M., and Ettrich, N. (2004). “Analysis and modeling of flooding in urban drainage systems.” J. Hydrol., 299(3–4), 300–311.
Serre, M., Odgaard, A. J., and Elder, R. A. (1994). “Energy loss at combining pipe junction.” J. Hydraul. Eng., 808–830.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Oct 23, 2013
Accepted: May 5, 2014
Published online: Jul 7, 2014
Published in print: Oct 1, 2014
Discussion open until: Dec 7, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.