Detection of Localized Deterioration Distributed along Single Pipelines by Reconstructive MOC Analysis
Publication: Journal of Hydraulic Engineering
Volume 140, Issue 2
Abstract
The detection of localized deterioration that is distributed along pipelines, including wall thickness reduction caused by large scale corrosion, is essential for targeted pipeline maintenance and the prevention of pipe failure. This paper proposes a novel technique for the detection of distributed deterioration along a pipeline by estimating the distribution of pipeline properties using a measured pressure transient trace. The proposed technique is referred to as reconstructive method of characteristics (MOC) analysis, and it is an inverse process of the traditional forward MOC calculation. The reconstructive MOC analysis reconstructs the MOC grid and estimates the pipe parameters, such as impedance and wave speed, reach by reach from downstream to upstream. Numerical simulations are performed on a pipeline with three pipe sections of impedance changes. These deteriorated sections are accurately detected and located by using the new technique. Experimental verification is also performed by successfully detecting a section of pipe with a thinner wall thickness in a single pipeline.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research presented in this paper has been supported by the Australia Research Council through the Discovery Project Grant DP1095270.
References
Brunone, B. (1999). “Transient test-based technique for leak detection in outfall pipes.” J. Water Resour. Plann. Manage., 302–306.
Brunone, B., and Morelli, L. (1999). “Automatic control valve-induced transients in operative pipe system.” J. Hydraul. Eng., 534–542.
Chaudhry, M. H. (1987). Applied hydraulic transients, Van Nostrand Reinhold, New York.
Covas, D., and Ramos, H. (2010). “Case studies of leak detection and location in water pipe systems by inverse transient analysis.” J. Water Resour. Plann. Manage., 248–257.
Covas, D., Ramos, H., and Betamio de Almeida, A. (2005). “Standing wave difference method for leak detection in pipeline systems.” J. Hydraul. Eng., 1106–1116.
Duan, H.-F., Lee, P. J., Ghidaoui, M. S., and Tung, Y.-K. (2012). “Extended blockage detection in pipelines by using the system frequency response analysis.” J. Water Resour. Plann. Manage., 55–62.
Ferrante, M., and Brunone, B. (2003). “Pipe system diagnosis and leak detection by unsteady-state tests. 1. Harmonic analysis.” Adv. Water Resour., 26(1), 95–105.
Gong, J., Lambert, M. F., Simpson, A. R., and Zecchin, A. C. (2013a). “Single event leak detection in a pipeline using first three resonant responses.” J. Hydraul. Eng., 645–655.
Gong, J., Simpson, A. R., Lambert, M. F., Zecchin, A. C., Kim, Y., and Tijsseling, A. S. (2013b). “Detection of distributed deterioration in single pipes using transient reflections.” J. Pipeline Syst. Eng. Pract., 32–40.
Hachem, F. E., and Schleiss, A. J. (2012). “Detection of local wall stiffness drop in steel-lined pressure tunnels and shafts of hydroelectric power plants using steep pressure wave excitation and wavelet decomposition.” J. Hydraul. Eng., 35–45.
Haghighi, A., Covas, D., and Ramos, H. (2012). “Direct backward transient analysis for leak detection in pressurized pipelines: From theory to real application.” J. Water Supply: Res. Technol.—AQUA, 61(3), 189–200.
Jönsson, L., and Larson, M. (1992). “Leak detection through hydraulic transient analysis.” Pipeline systems, B. Coulbeck and E. P. Evans, eds., Kluwer Academic, Dordrecht, The Netherlands, 273–286.
Lee, P. J., Lambert, M. F., Simpson, A. R., Vítkovský, J. P., and Liggett, J. A. (2006). “Experimental verification of the frequency response method for pipeline leak detection.” J. Hydraul. Res., 44(5), 693–707.
Lee, P. J., Lambert, M. F., Simpson, A. R., Vítkovský, J. P., and Misiunas, D. (2007a). “Leak location in single pipelines using transient reflections.” Aust. J. Water Resour., 11(1), 53–65.
Lee, P. J., Vítkovský, J. P., Lambert, M. F., and Simpson, A. R. (2008b). “Valve design for extracting response functions from hydraulic systems using pseudorandom binary signals.” J. Hydraul. Eng., 858–864.
Lee, P. J., Vítkovský, J. P., Lambert, M. F., Simpson, A. R., and Liggett, J. A. (2005). “Frequency domain analysis for detecting pipeline leaks.” J. Hydraul. Eng., 596–604.
Lee, P. J., Vítkovský, J. P., Lambert, M. F., Simpson, A. R., and Liggett, J. A. (2007b). “Leak location in pipelines using the impulse response function.” J. Hydraul. Res., 45(5), 643–652.
Lee, P. J., Vítkovský, J. P., Lambert, M. F., Simpson, A. R., and Liggett, J. A. (2008a). “Discrete blockage detection in pipelines using the frequency response diagram: Numerical study.” J. Hydraul. Eng., 658–663.
Liggett, J. A., and Chen, L.-C. (1994). “Inverse transient analysis in pipe networks.” J. Hydraul. Eng., 934–955.
Ljung, L. (1999). System identification: Theory for the user, Prentice-Hall, Upper Saddle River, NJ.
MATLAB Version 7.10.0.499 [Computer software]. The MathWorks, Natick, MA.
Pudar, R. S., and Liggett, J. A. (1992). “Leaks in pipe networks.” J. Hydraul. Eng., 1031–1046.
Sattar, A. M., Chaudhry, M. H., and Kassem, A. A. (2008). “Partial blockage detection in pipelines by frequency response method.” J. Hydraul. Eng., 76–89.
Shamloo, H., and Haghighi, A. (2009). “Leak detection in pipelines by inverse backward transient analysis.” J. Hydraul. Res., 47(3), 311–318.
Stephens, M. L., Lambert, M. F., and Simpson, A. R. (2013). “Determining the internal wall condition of a water pipeline in the field using an inverse transient model.” J. Hydraul. Eng., 310–324.
Stephens, M. L., Simpson, A. R., and Lambert, M. F. (2008). “Internal wall condition assessment for water pipelines using inverse transient analysis.” Proc., 10th Annual Symp. on Water Distribution Systems Analysis, ASCE, Reston, VA.
Tran, D. H., Perera, B. J. C., and Ng, A. W. M. (2010). “Hydraulic deterioration models for storm-water drainage pipes: Ordered probit versus probabilistic neural network.” J. Comput. Civ. Eng., 140–150.
Vítkovský, J. P., Simpson, A. R., and Lambert, M. F. (2000). “Leak detection and calibration using transients and genetic algorithms.” J. Water Resour. Plann. Manage., 262–265.
Vreeburg, I. J. H. G., and Boxall, D. J. B. (2007). “Discolouration in potable water distribution systems: A review.” Water Res., 41(3), 519–529.
Wang, X. J., Lambert, M. F., and Simpson, A. R. (2005). “Detection and location of a partial blockage in a pipeline using damping of fluid transients.” J. Water Resour. Plann. Manage., 244–249.
Wylie, E. B., and Streeter, V. L. (1993). Fluid transients in systems, Prentice Hall, Englewood Cliffs, NJ.
Zamanzadeh, M., Kirkwood, G. C., Scheinman, S., and Bayer, G. T. (2007). “Corrosion sensors for detecting graphitization of cast iron in water mains.” Proc., Corrosion Conf. and Expo 2007, Curran Associates, Red Hook, NY.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 22, 2012
Accepted: Jul 17, 2013
Published online: Jan 15, 2014
Published in print: Feb 1, 2014
Discussion open until: Jun 15, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.