Structure of a Horizontal Sediment-Laden Momentum Jet
Publication: Journal of Hydraulic Engineering
Volume 139, Issue 2
Abstract
Partially treated wastewater discharge from marine outfall diffusers often contains inorganic and organic solids that may settle close to the source and give rise to sludge banks that affect benthic ecology. An experimental and theoretical investigation of the structure and settling mechanisms of a horizontal sediment momentum jet in stagnant ambient has been carried out. The cross-sectional particle concentration distribution of a horizontal sediment jet is measured for the first time. Bottom deposition measurements are made for a total of 41 experiments of momentum jets laden with sand particles or synthetic spherical glass particles. The sediment jet can be characterised by a sedimentation length scale defined by the jet momentum flux and particle settling velocity. The measured longitudinal sediment deposition rate can be described by a semiempirical log-normal distribution based on . In the instantaneous particle distribution, the sediment fallout is concentrated in a central region and settles in a zig-zag trajectory. The time-mean transverse particle concentration shows that the upper half of sediment jet behaves like a pure jet with concentric contours for . For , the sediment cloud starts to depart from the water jet; for , the particle cloud separates significantly from the water jet. For , the maximum particle concentration is located within the jet region and the decay of closely follows the classical jet theory. For , is significantly less than that given by the jet theory. The time-mean particle concentration distribution across the jet is horseshoe-shaped, with an open end at the bottom due to sedimentation. The concentration distribution is elongated in the vertical direction and shaped like an ellipse. A two-layer Lagrangian jet model is developed to predict the mixing of dilute horizontal sediment jets. The predictions are in excellent agreement with the layer-averaged particle concentrations and bottom deposition rate measurement.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is supported by a grant from the Hong Kong Research Grants Council (RGC HKU719408) and in part by a grant from the University Grants Committee of the Hong Kong Special Administrative Region, China (Project No. AoE/P-04/04) to the Area of Excellence (AoE) in Marine Environment Research and Innovative Technology (MERIT). The experiments were performed in the Croucher Laboratory of Environmental Hydraulics, The University of Hong Kong.
References
Adrian, R. J. (1991). “Particle-imaging techniques for experimental fluid mechanics.” Annu. Rev. Fluid Mech., 23, 261–304.
Bleninger, T., Carmer, C. V., Jirka, G., and Neves, M. (2002). “Sedimentation from low concentration particle-laden jets.” Proc. 2nd Int. Conf. Marine Waste Water Discharges, International Association for Hydro-Environment Engineering and Research (IAHR) and International Water Association (IWA), Istanbul, Turkey.
Bush, J. W. M., Thurber, B. A., and Blanchette, F. (2003). “Particle clouds in homogeneous and stratified environments.” J. Fluid Mech., 489, 29–54.
Cardoso, S. S. S., and Zarrebini, M. (2002). “Sedimentation from surface currents generated by particle-laden jets.” Chem. Eng. Sci., 57(8), 1425–1437.
Carey, S. N., Sigurdsson, H., and Sparks, R. S. J. (1988). “Experimental studies of particle-laden plumes.” J. Geophys. Res., 93(B12), 15314–15328.
Chu, P. C. K. (1996). “Mixing of turbulent advected line puffs.” Ph.D. thesis, The Univ. of Hong Kong, Hong Kong.
Chu, P. C. K., Lee, J. H., and Chu, V. H. (1999). “Spreading of turbulent round jet in coflow.” J. Hydraul. Eng., 125(2), 193–204.
Crocker, J. C., and Grier, D. G. (1996). “Methods of digital video microscopy for colloidal studies.” J. Colloid Interface Sci., 179(1), 298–310.
Cuthbertson, A. J. S., Apsley, D. D., Davies, P. A., Lipari, G., and Stansby, P. K. (2008). “Deposition from particle-laden, plane, turbulent, buoyant jets.” J. Hydraul. Eng., 134(8), 1110–1122.
Cuthbertson, A. J. S., and Davies, P. A. (2008). “Deposition from particle-laden, round, turbulent, horizontal, buoyant jets in stationary and coflowing receiving fluids.” J. Hydraul. Eng., 134(4), 390–402.
Ernst, G. G. J., Sparks, R. S. J., Carey, S. N., and Bursik, M. I. (1996). “Sedimentation from turbulent jets and plumes.” J. Geophys. Res. B: Solid Earth, 101(B3), 5575–5589.
Fischer, H. B., List, E. J., Koh, R. C. Y., Imberger, J., and Brooks N. H. (1979). Mixing in inland and coastal waters, Academic, New York.
Jiang, J., Law, A. W. K., and Cheng, N. S. (2005). “Two-phase analysis of vertical sediment-laden jets.” J. Eng. Mech., 131(3), 308–318.
Lane-Serff, G. F., and Moran, T. J. (2005). “Sedimentation from buoyant jets.” J. Hydraul. Eng., 131(3), 166–174.
Lee, J. H. W. (1981). “An hourglass experiment.” Int. J. Mech. Eng. Educ., 9(1), 39–46.
Lee, J. H. W., and Cheung, V. (1990). “Generalized Lagrangian model for buoyant jets in current.” J. Environ. Eng., 116(6), 1085–1106.
Lee, J. H. W., and Chu, V. H. (2003). Turbulent jets and plumes: A Lagrangian approach, Kluwer Academic, Boston.
Lee, W. Y. (2010). “Mixing of sediment-laden jet.” Ph.D. thesis, The Univ. of Hong Kong, Hong Kong.
Li, A. C. Y. (2006). “Theoretical modeling and experimental studies of particle-laden plumes from wastewater discharges.” M. Phil. thesis, The Univ. of Hong Kong, Hong Kong.
Maldonado, C., Venkatesan, M. I., Phillips, C. R., and Bayona, J. M. (2000). “Distribution of trialkylamines and coprostanol in San Pedro shelf sediments adjacent to a sewage outfall.” Mar. Pollut. Bull., 40(8), 680–687.
Muste, M., Fujita, I., and Kruger, A. (1998). “Experimental comparison of two laser-based velocimeters for flows with alluvial sand.” Exp. Fluids, 24(4), 273–284.
Neves, M. J., and Fernando, H. J. S. (1995). “Sedimentation of particles from jets discharged by ocean outfalls: a theoretical and laboratory study.” Water Sci. Technol., 32(2), 133–139.
Neves, M., Neves, A., and Bleninger, T. (2002). “Prediction on particle deposition in effluent disposal system.” Proc. 2nd Int. Conf. Marine Waste Water Discharges, International Association for Hydro-Environment Engineering and Research (IAHR) and International Water Association (IWA), Istanbul, Turkey.
Nielsen, P. (1993). “Turbulence effects on the settling of suspended particles.” J. Sediment. Petrol., 63(5), 835–838.
Papanicolaou, P. N., and List, E. J. (1988). “Investigations of round vertical turbulent buoyant jets.” J. Fluid Mech., 195, 341–391.
Parthasarathy, R. N., and Faeth, G. M. (1987). “Structure of particle-laden turbulent water jets in still water.” Int. J. Multiphase Flow, 13(5), 699–716.
Pritchard, T. (1997). “Environmental performance of Sydney’s deepwater outfalls.” Water, 24(2), 29–34.
Ruggaber, G. J. (2000). “The dynamics of particle clouds related to open-water sediment disposal.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, MIT, Cambridge, MA.
Santschi, P. H., Wen, L. S., and Guo, L. (2001). “Transport and diagenesis of trace metals and organic matter in Palos Verdes shelf sediments affected by a wastewater outfall.” Mar. Chem., 73(2), 153–171.
Singamsetti, S. (1966). “Diffusion of sediment in a submerged jet.” J. Hydraul. Div. Proc. ASCE, 92(2), 153–168.
Soulsby, R. (1997). Dynamics of marine sands: A manual for practical applications, Thomas Telford, London.
Sparks, R. S. J., Carey, S. N., and Sigurdsson, H. (1991). “Sedimentation from gravity currents generated by turbulent plumes.” Sedimentology, 38(5), 839–856.
Wygnanski, I., and Fiedler, H. (1969). “Some measurements in the self-preserving jet.” J. Fluid Mech., 38(3), 577–612.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Feb 18, 2012
Accepted: Jul 16, 2012
Published online: Jul 24, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.