Nonreflective Boundary Design via Remote Sensing and Proportional-Integral-Derivative Control Valve
Publication: Journal of Hydraulic Engineering
Volume 137, Issue 11
Abstract
This paper develops the concept of a nonreflective (or semireflective) boundary condition using the combination of a remote sensor and a control system to modulate a relief valve. The essential idea is to sense the pressure change at a remote location and then to use the measured data to adjust the opening of an active control valve at the end of the line to eliminate or attenuate the wave reflections at the valve, thus controlling system transient pressures. This novel idea is shown here through numerical simulation to have considerable potential for transient protection. Using this model, wave reflections and resonance can be effectively eliminated for frictionless pipelines or initial no-flow conditions and can be better controlled in more realistic pipelines for a range of transient disturbances. In addition, the features of even-order harmonics and nonreflective boundary conditions during steady oscillation, obtained through time domain transient analysis, are verified by hydraulic impedance analysis in the frequency domain.
Get full access to this article
View all available purchase options and get full access to this article.
Disclaimer
This submission was written by the authors acting in their own independent capacity and not on behalf of UT-Battelle, LLC, or its affiliates or successors.
References
Boulos, P., Lansey, K., and Karney, B. (2006). Comprehensive water distribution systems analysis handbook for engineers and planners, 2nd Ed., Chapter 9, MWH Soft, Arcadia, CA, 9-9–9-11.
Brunone, B., and Morelli, L. (1999). “Automatic control valve-induced transients in operative pipe system.” J. Hydraul. Eng., 125(5), 534–542.
Chaudhry, M. H. (1979). Applied hydraulic transients, Van Nostrand Reinhold, New York.
Chaudhry, M. H. (1987). Applied hydraulic transients, 2nd Ed., Van Nostrand Reinhold, New York.
de Almeida, A. B., and Koelle, E. (1992). Fluid transients in pipe networks, Computational Mechanics and Elsevier Science, Southampton, UK, and London, 111–112.
Hopkins, J. P. (1988). “Valves for controlling pressure, flow and level.” Water Eng. Manage., 135(8), 42–44.
Karney, B. W., and McInnis, D. A. (1992). “Efficient calculation of transient flow in simple pipe networks.” J. Hydraul. Eng., 118(7), 1014–1030.
Karney, B., Zhang, Q., Wang, F., and Pejovic, S. (2008). “Non-reflective boundary design through remote sensing and PID control valve.” Proc., 10th Int. Conf. on Pressure Surges, BHR Group Ltd., Bedfordshire, UK, 243–256.
Kiong, T. K., Wang, Q.-G., Hang, C. C., and Hagglund, T. J. (1999). Advances in PID control, Springer-Verlag, London.
Koelle, E. (1992). “Control valves inducing oscillatory flow in hydraulic networks.” Proc., Int. Conf. on Unsteady Flow and Fluid Transients, Balkema, Rotterdam, Netherlands, 343–352.
Koelle, E., and Poll, H. (1992). “Dynamic behavior of automatic control valves (ACV) in hydraulic networks.” Proc., 16th Symp. of the IAHR—Section on Hydraulic Machinery and Cavitation, International Association for Hydro-Environment Engineering and Research, Madrid, Spain, 127–139.
Lauria, J., and Koelle, E. (1996). “Model-based analysis of active PID-control of transient flow in hydraulic networks.” Hydraulic machinery and cavitation, Kluwer Academic, Netherlands, 749–758.
Pejovic, S., and Boldy, A. P. (1992). Guidelines to hydraulic transient analysis of pumping systems, P&B, Belgrade, Serbia, 181.
Pejović-Milić, A., Pejović, S., and Karney, B. (2003). “Extreme theoretical pressure oscillations in coronary bypass.” Proc., Int. Conf. on Case Studies in Hydraulic Systems, Belgrade, Serbia.
Poll, H. (2002). “The importance of the unsteady friction term of the momentum equation for hydraulic transients.” Proc., 21st IAHR Symp. on Hydraulic Machinery and Systems, International Association for Hydro-Environment Engineering and Research, Madrid, Spain.
Suzuki, K., Taketomi, T., and Sato, S. (1991). “Improving Zielke’s method of simulating frequency-dependent friction in laminar liquid pipe flow.” J. Fluids Eng., 113(4), 569–573.
Tirkha, A. K. (1975). “An efficient method for simulating frequency-dependent friction in transient liquid flow.” J. Fluids Eng., 97(1), 97–105.
Vardy, A. E., and Brown, J. M. B. (1995). “Transient, turbulent, smooth pipe friction.” J. Hydraul. Res., 33(4), 435–456.
Vardy, A. E., and Brown, J. M. B. (2003). “Transient turbulent friction in smooth pipe flows.” J. Sound Vib., 259(5), 1011–1036.
Vardy, A. E., Hwang, K., and Brown, J. M. B. (1993). “A weighting function model of transient turbulent pipe friction.” J. Hydraul. Res., 31(4), 533–548.
Wylie, E. B., Streeter, V. L., and Suo, L. (1993). Fluid transients in systems, Prentice-Hall, Englewood Cliffs, NJ.
Zielke, W. (1968). “Frequency-dependent friction in transient pipe flow.” J. Basic Eng., 90(1), 109–115.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Jan 12, 2010
Accepted: Feb 4, 2011
Published online: Oct 14, 2011
Published in print: Nov 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.