Modeling Surface Soil Erosion and Sediment Transport Processes in the Upper North Bosque River Watershed, Texas
Publication: Journal of Hydrologic Engineering
Volume 20, Issue 12
Abstract
A sediment transport module added to the Hydrologic Engineering Center’s Hydrologic Modeling System (HEC–HMS) Version 4.0 computes surface erosion, reach routing, and reservoir trap efficiency. The HEC–HMS sediment transport module was applied to the Upper North Bosque River Watershed (UNBRW) in central Texas, a well-instrumented watershed with good parameterization and calibration data, to test model robustness. The UNBRW is 98% rural including rangeland, forage, and dairy waste application fields. Simulation results were compared to observed average daily total suspended solid (TSS) data at five gauge locations. The HEC–HMS results matched observed TSS across the UNBRW ( error at all gauges) during model calibration and maintained modest residuals ( to 12% error) during the validation period. The HEC–HMS also performed well compared to published results through two other commonly used models.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Ann McFarland of the Texas Institute for Applied Environmental Research, Tarleton State University, is thanked for data support. The development of STM in HEC–HMS 4.0 was funded by the System Wide Water Resources Program (SWWRP) and Flood and Coastal Storm Damage Reduction Research and Development (RD) program of the U.S. Army Corps of Engineers.
References
Ackers, P., and White, W. R. (1973). “Sediment transport: New approach and analysis.” J. Hydraul. Div., 99(11), 2041–2060.
Bellocchi, G., Rivington, M., Donatrlli, M., and Matthews, K. (2009). “Validation of biophysical models: Issues and methodologies.” Agron. Sustain. Dev., 30(1), 109–130.
Beven, K. J., and Freer, J. (2001). “Equifinality, data assimilation, and uncertainty estimation in mechanistic modelling of complex environmental systems.” J. Hydrol., 249(1–4), 11–29.
Bicknell, B., Imhoff, J., Kittle, J., Jobes, T., and Donigian, A. (2001). Hydrological simulation program—Fortran version 12: User’s manual, Aqua Treea Consultants, Mountain View, CA.
Biemans, H., Hutjes, R. W. A., Kabat, P., Strengers, B. J., Gerten, D., and Rost, S. (2009). “Effects of precipitation uncertainty on discharge calculations for main river basins.” J. Hydrometeorol., 10(4), 1011–1025.
Chen, C. (1975). “Design of sediment retention basins.” Proc., National Symp. on Urban Hydrology and Sediment Control, Univ. of Kentucky, Lexington, KY, 285–298.
Englund, F., and Hansen, E. (1967). A monograph on sediment transport in alluvial streams, Teknisk, Copenhagen, Denmark.
Foster, G., Yoder, D., Weesies, G., McCool, D., McGregor, K., and Bingner, R. (2003). “Draft user’s guide RUSLE2 version 2.” 〈http://fargo.nserl.purdue.edu/rusle2_dataweb/RUSLE2_Technology.htm〉 (Dec. 4, 2007).
Gibson, S., Brunner, G., Piper, S., and Jensen, M. (2006). “Sediment transport computations in HEC-RAS.” Proc., Eighth Federal Interagency Sedimentation Conf. (FISC), Subcommittee on Sedimentation [a subcommittee of the Advisory Committee on Water Information (AWCI)], 57–64.
Gibson, S., and Piper, S. (2007). “Sensitivity and applicability of bed mixing algorithms.” Proc., World Environmental and Water Resources Congress, ASCE, Reston, VA, 1–12.
Gupta, H. V., Sorooshian, S., and Yapo, P. O. (1999). “Status of automatic calibration for hydrologic models: Comparison with multilevel expert calibration.” J. Hydrol. Eng., 135–143.
Haan, C. T., Barfirld, B. J., and Hayes, J. C. (1994). Design hydrology and sedimentology for small catchments, Academic, San Diego.
HEC–HMS (Hydrologic Engineering Center–Hydrologic Modeling System) 4.0 [Computer software]. Davis, CA, U.S. Army Corps of Engineers.
Huber, W. C., and Dickinson, R. E. (1988). “Storm water management model, version 4; user’s manual.” U.S. EPA, Athens, GA.
Keplinger, K., and Hauck, L. (2002). “Modeling phosphorus control dairy BMPs for the north Bosque River.”, Texas Institute for Applied Environmental Research, Tareleton State Univ., Stephenville, TX.
Laursen, E. M. (1958). “Total sediment load of streams.” J. Hydraul. Div., 84(1), 1–36.
Leavesley, G., Lichty, R., Troutman, B., and Saindon, L. (1983). Precipitation-runoff modeling system: User’s manual, USGS, Denver.
Legates, D. R., and McCabe, G. J., Jr. (1999). “Evaluating the use of ‘goodness-of-fit’ measures in hydrologic and hydroclimatic model validation.” Water Resour. Res., 35(1), 233–241.
McFarland, A., and Hauck, L. (1999). “Relating agricultural land uses to in-stream stormwater quality.” J. Environ. Qual., 28(3), 836–844.
Meehl, G. A., Covey, C., McAvaney, B., Latif, M., and Stouffer, R. J. (2005). “Overview of the coupled model intercomparison project.” Bull. Am. Meteorol. Soc., 86(1), 89–93.
Meyer-Peter, B., and Muller, T. (1948). “Formulas for bed load transport.” Int. Association for Hydraulics Research, Madrid, Spain, 39–64.
Moriasi, D. N., Arnold, J. G., Van Liew, M. W., Bingner, R. L., Harmel, R. D., and Veith, T. L. (2007). “Model evaluation guidelines for systematic quantification of accuracy in watershed simulations.” Trans. ASABE, 50(3), 885–900.
Nash, J. E., and Sutcliffe, J. V. (1970). “River flow forecasting through conceptual models. Part I—A discussion of principles.” J. Hydrol., 10(3), 282–290.
Pak, J., Fleming, M., Scharffenberg, W., and Ely, P. (2008). “Soil erosion and sediment yield modeling with the hydrologic modeling system (HEC-HMS).” Proc., World Environmental and Water Resources Congress, ASCE, Reston, VA.
Pak, J., Fleming, M., Scharffenberg, W., and Ely, P. (2010). “Assessment of reservoir trap efficiency methods using the hydrologic modeling system (HEC-HMS) for the upper North Bosque River watershed in central Texas.” Proc., Joint Federal Interagency Conf., Subcommittee on Sedimentation [a subcommittee of the Advisory Committee on Water Information (AWCI)].
Pak, J., Ramos, K., Fleming, M., Scharffenberg, W., and Gibson, S. (2015). “Sensitivity analysis for sediment transport in the hydrologic modeling system (HEC-HMS).” Proc., Joint Federal Interagency Conf.
Renard, K. G., Foster, G. R., Weesies, G. A., McCool, D. A., and Yoder, D. C. (1997). “Predicting soil erosion by water: A guide to conservation planning with the revised universal soil loss equation (RUSLE).” Agricultural handbook 703, U.S. Government Print Office, Washington, DC.
Saleh, A., and Du, B. (2004). “Evaluation of SWAT and HSPF within basins program for the upper Bosque River Watershed in central Texas.” Trans. Am. Soc. Agric. Eng., 47(4), 1039–1049.
SCS (Soil Conservation Service). (1986). “Technical releases 55: Urban hydrology for small watersheds.” USDA, Washington, DC.
Slattery, M. C., and Burt, T. P. (1997). “Particles size characteristics of suspended sediment in hillslope runoff and stream flow.” Earth Surf. Process. Landforms, 22(8), 705–719.
Thomas, W. A. (1994). “Sedimentation in stream networks: HEC-6 T user’s manual.” Mobile Boundary Hydraulics Software, Clinton, MS, 5–719.
Thorne, C. R., et al. (2011). “Accounting for sediment in flood risk management.” Flood risk science and management, Pender G., and Faulkner H., eds., Wiley–Blackwell, West Chichester, U.K., 87–113.
Toffaleti, F. B. (1968). “A procedure for computation of the total river sand discharge and detailed distribution, bed to surface.”, Committee on Channel Stabilization, U.S. Army Corps of Engineers, Vicksburg, MS.
USACE (U.S. Army Corps of Engineers). (1987). “Appendix H: Monthly standard Class A pan evaporation for the continental United States.” Confined disposal of dredged material: Engineer manual 1110-2-5027, Washington, DC.
USACE (U.S. Army Corps of Engineers). (1998). Reservoir storage data: HEC-1 flood hydrograph package user’s manual, Hydrologic Engineering Center, Davis, CA.
USACE (U.S. Army Corps of Engineers). (2013). “Erosion and sediment transport.” Hydrologic modeling system HEC-HMS, Hydrologic Engineering Center, Davis, CA, 363–388.
USACE (U.S. Army Corps of Engineers). (2015). Hydrologic modeling system HEC-HMS: Application guide, Hydrologic Engineering Center, Davis, CA.
USDA. (2007). “Soil Survey Geographic (SSURGO) database.” 〈http://sdmdataaccess.nrcs.usda.gov/〉 (Jan. 31, 2007).
USEPA. (2003). “How management practices work to prevent nonpoint source pollution.” National management measures to control nonpoint pollution from agriculture, Washington, DC, 3–31.
USGS. (2007). “National elevation dataset, 1/3 arc second.” 〈http://viewer.nationalmap.gov/viewer/〉 (Jan. 31, 2007).
Van Rijn, L. C., and Leo, C. (1993). Principles of sediment transport in river, estuaries, coastal seas and oceans, Int. Institute for Infrastructural, Hydraulic, and Environmental Engineering, Delft, Netherlands.
Ward, G., Flowers, J., and Coan, T. (1992). “Final report on environmental water quality monitoring relating to nonpoint-source pollution in the upper Bosque River Watershed.” Rep. Prepared for the Texas Institute for Applied Environmental Research, Tareleton State Univ., Stepehenville, TX.
Wilcock, P. R., and Crowe, J. C. (2003). “Surfaced-based transport model for mixed-size sediment.” J. Hydraul. Eng., 120–128.
Williams, J. R. (1975). “Sediment-yield prediction with universal equation using runoff energy factor.” Proc., Sediment–Yield Workshop, Present and Prospective Technology for Predicting Sediment Yield and Sources, Sediment Laboratory, USDA, Oxford, MS, 244–252.
Wilson, J. P., Mitasova, H., and Wright, D. J. (2000). “Water resource applications of geographic information systems.” URISA J., 12(2), 61–79.
Wischmeier, W., and Smith, D. (1965). “Predicting rainfall erosion losses from cropland east of the rocky mountains.”, U.S. Government Print Office, Washington, DC.
Wischmeier, W., and Smith, D. (1978). “Predicting rainfall erosion losses—A guide to conservation planning.”, U.S. Government Print Office, Washington, DC.
Yang, C. T. (1972). “Unit stream power and sediment transport.” J. Hydraul. Div., 98(10), 1805–1826.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Nov 12, 2014
Accepted: Feb 11, 2015
Published online: May 8, 2015
Discussion open until: Oct 8, 2015
Published in print: Dec 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.