Operation of Cap Orifice in a Rain Garden
Publication: Journal of Hydrologic Engineering
Volume 20, Issue 10
Abstract
The rain garden is one of the most commonly used, low-impact development (LID) devices. Rain gardens are designed to reduce runoff volume, delay peak flow, and improve water quality in stormwater. A rain garden consists of surface and subsurface components: The surface component is a storage basin that stores the water quality capture volume (WQCV), whereas the subsurface structure is formed with a two-layered filtering medium. The drain time is the most important design parameter for the rain garden’s operation. A short drain time will lead to an inadequate residence time for the sedimentation process, whereas a long drain time will result in potential hazards to the public. A new rain garden usually has a high infiltration capacity through its filtering layers. Over years of service, the clogging effect will slow down its infiltration rate. To improve the performance of a rain garden through its life cycle, it is recommended that a cap orifice be installed at the outlet of the perforated underdrain pipe. Such a cap orifice can be adjusted to achieve the targeted flow release, according to the stage of rain garden’s life cycle. This paper presents a numerical algorithm that predicts the infiltrating process through the unsaturated and saturated sand-mix zones underneath a rain garden. With field data, the calibration parameters for the numerical model are identified to be hydraulic conductivity and initial soil moisture content. The numerical procedure developed in this paper provides a quantifiable guidance on how to turn the cap orifice up and down to satisfy the design condition. This numerical procedure can be further incorporated into a web-based remote control system that can assist the engineer to operate a rain garden at a distance.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ames, B. C., Emily, L. L., Lonna, M. F., and William, B. R. (2001). “Preliminary assessment of infiltration rates and effects on water quality of selected infiltration media for use in highway runoff retention basins in Wasington State.”, Dept. of Transportation, Olympia, WA.
Davis, A. P. (2008). “Field performance of bioretention: Hydrology impacts.” J. Hydrol. Eng., 90–95.
Davis, A. P., Shokouhian, M., Sharma, H., and Minami, C. (2001). “Laboratory study of biological retention for urban stormwater management.” Water Environ. Res., 73(1), 5–14.
Davis, A. P., Shokouhian, M., Sharma, H., Minami, C., and Winogradoff, D. (2003). “Water quality improvement through bioretention: Lead, copper, and zinc removal.” Water Environ. Res., 75(1), 73–82.
EPA (Environmental Protection Agency). (1983). “Results of the nationwide urban runoff program.” Final Rep., U.S. EPA, Washington, DC.
Guo, J. C. (2012). “Cap-orifice as a flow regulator for rain garden design.” J. Irrig. Drain. Eng., 198–202.
Guo, J. C., Shauna, K. M., and Anu, R. (2009). “Design of two-layered porous landscaping detention basin.” J. Environ. Eng., 1268–1274.
Guo, J. C., and Urbonas, B. (2002). “Runoff capture and delivery curves for storm-water quality control designs.” J. Water Resour. Plann. Manage., 208–215.
Hsieh, C.-H., and Davis, A. P. (2005). “Evaluation and optimization of bioretention media for treatment of urban storm water runoff.” J. Environ. Eng., 1521–1531.
Li, H., and Davis, A. P. (2008a). “Urban particle capture in bioretention media. I: Laboratory and field studies.” J. Environ. Eng., 409–418.
Li, H., and Davis, A. P. (2008b). “Urban particle capture in bioretention media. II: Theory and model development.” J. Environ. Eng., 419–432.
Li, H., Sharkey, L. J., Hunt, W. F., and Davis, A. P. (2009). “Mitigation of impervious surface hydrology using bioretention in North Carolina and Maryland.” J. Hydrol. Eng., 407–415.
Mays, D. C., and Hunt, J. R. (2005). “Hydrodynamic aspects of particle clogging in porous media.” Environ. Sci. Technol., 39(2), 577–584.
Roy-Poirier, A., Champagne, P., and Filion, Y. (2010). “Review of bioretention system research and design: Past, present, and future.” J. Environ. Eng., 878–889.
Scheffer, F. (2002). Lehrbuch der Bodenkunde, Scheffer/Schachtschabel, 15, Aufl. Spektrum Akademischer, Heidelberg.
UDFCD (Urban Drainage and Flood Control District). (2012). Rain garden at West 21st Avenue and Iris Street, Lakewood, CO.
UDFCD (Urban Drainage and Flood Control District). (2013). Rain garden at West 21st Avenue and Iris Street, Lakewood, CO.
Urbonas, B., Guo, J. C., and Tucker, L. S. (1989). “Sizing a capture volume for stormwater quality enhancement.” Urban Drainage and Flood Control District, Denver.
USEPA (U.S. Environmental Protection Agency). (1999). “Stormwater technology fact sheet bioretention.”, Office of Water, Washington, DC.
USWDCM (Urban Storm Water Drainage Criteria Manual). (2010). Best management practices, Urban Drainage and Flood Control District, Denver.
Warrick, A. W., Zerihun, D., Sanchez, C. A., and Furman, A. (2005). “Infiltration under variable ponding depths of water.” J. Irrig. Drain. Eng., 358–363.
Information & Authors
Information
Published In
Journal of Hydrologic Engineering
Volume 20 • Issue 10 • October 2015
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Oct 22, 2014
Accepted: Jan 14, 2015
Published online: Feb 23, 2015
Discussion open until: Jul 23, 2015
Published in print: Oct 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.