Effect of Water Imbibition on Fracture Generation in Mancos Shale under Isotropic and Anisotropic Stress Conditions
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 144, Issue 2
Abstract
During hydraulic fracturing in shale oil and gas reservoirs, hydration swelling due to shale water imbibition is believed to create secondary fractures that improve permeability, as observed at ambient conditions. In this paper, the influence of hydration swelling on fracture generation and permeabilities in Mancos shale at different stress conditions was investigated. Hydration swelling was characterized by swelling strain tests. Generated fractures were observed by computed tomography (CT) scan tests. The permeability of the shale was measured before and after water imbibition. In shale with isotropic confining pressure increased to 2.0 MPa or more, water imbibition can cause fracture closing instead of propagation. As a result, permeability decreased significantly, up to two orders compared with that before water imbibition. On the other hand, the differential stress required to activate shear-induced fractures was greatly reduced after hydration, up to 50% in shale after water imbibition. For shale cores under higher confining pressure, with decreased hydration swelling magnitude, shear-induced fracture generation was reduced. Water permeability of shale with a shear-induced fracture was nearly 100 times higher than that of shale without a fracture. In other words, water imbibition can enhance the generation of shear-induced fractures under anisotropic stress to improve shale permeability, but it can cause fractures to close in shale under isotropic stress.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work presented in this paper is supported by the U.S. Department of Energy under Award No. DE-FE0024311.
References
Ambrose, J., Zimmerman, R. W., and Suarez-Rivera, R. (2014). “Failure of shales under triaxial compressive stress.” 48th U.S. Rock Mechanics/Geomechanics Symp., American Rock Mechanics Association, Alexandria, VA.
ASTM. (2014). Standard test method for compressive strength and elastic moduli of intact rock core specimens under varying states of stress and temperatures.” ASTM D7012, West Conshohocken, PA.
Barton, N., and de Quadros, E. F. (1997). “Joint aperture and roughness in the prediction of flow and groutability of rock masses.” Int. J. Rock Mech. Min. Sci., 34(3–4), 252.
Baud, P., Zhu, W., and Wong, T. F. (2000). “Failure mode and weakening effect of water on sandstone.” J. Geophys. Res., 105(B7), 16371–16389.
Behnsen, J., and Faulkner, D. R. (2011). “Water and argon permeability of phyllosilicate powders under medium to high pressure.” J. Geophys. Res., 116(B12), B12203.
Binazadeh, M., Xu, M., Zolfaghari, A., and Dehghanpour, H. (2016). “Effect of electrostatic interactions on water uptake of gas shales: The interplay of solution ionic strength and electrostatic double layer.” Energy Fuels, 30(2), 992–1001.
Brace, W., Walsh, J. B., and Frangos, W. T. (1968). “Permeability of granite under high pressure.” J. Geophys. Res., 73(6), 2225–2236.
Burchill, S., et al. (1983). “Smectite-polymer interactions in aqueous systems.” Clay Miner., 18(4),373–397.
Caenn, R., and Chillingar, G. V. (1996). “Drilling fluids: State of the art.” J. Pet. Sci. Eng., 14(3–4), 221–230.
Chen, Z., Narayan, S. P., Yang, Z., and Rahman, S. S. (2000). “An experimental investigation of hydraulic behaviour of fractures and joints in granitic rock.” Int. J. Rock Mech. Min. Sci., 37(7), 1061–1071.
Cheng, J., Wan, Z., Zhang, Y., Li, W., Peng, S. S., and Zhang, P. (2015). “Experimental study on anisotropic strength and deformation behavior of a coal measure shale under room dried and water saturated conditions.” Shock Vib., 2015, 1–13.
Code of China. (1995a). “Identification of interlayered illite/smectite minerals by X-ray diffraction.” SY/T 5983, China Petroleum Industry Press, Beijing.
Code of China. (1995b). “The relative amounts of sedimentary clay minerals X-ray diffraction analysis.” SY/T 5163, China Petroleum Industry Press, Beijing.
Code of China. (1996). “Quantitative analysis of total contents of clay minerals and common non-clay minerals in sedimentary rocks by X-ray diffraction.” SY/T 6210, China Petroleum Industry Press, Beijing.
Dehghanpour, H., Lan, Q., Saeed, Y., Fei, H., and Qi, Z. (2013). “Spontaneous imbibition of brine and oil in gas shales: Effect of water adsorption and resulting microfractures.” Energy Fuels, 27(6), 3039–3049.
de Souza, C. E. C., Lima, A. S., and Nascimento, R. S. V. (2010). “Hydrophobically modified poly (ethylene glycol) as reactive clays inhibitor additive in water-based drilling fluids.” J. Appl. Polym. Sci., 117(2), 857–864.
Duan, Q., and Yang, X. (2014). “Experimental studies on gas and water permeability of fault rocks from the rupture of the 2008 Wenchuan earthquake, China.” Sci. China Earth Sci., 57(11), 2825–2834.
Faulkner, D. R., and Rutter, E. H. (2000). “Comparisons of water and argon permeability in natural clay-bearing fault gouge under high pressure at 20°C.” J. Geophys. Res., 105(B7), 16415–16426.
Heidug, W. K., and Wong, S. W. (1996). “Hydration swelling of water-absorbing rocks: A constitutive model.” Int. J. Numer. Anal. Methods Geomech., 20(6), 403–430.
Hoek, E., and Franklin, J. A. (1967). “A simple triaxial cell for field or laboratory testing of rock.” Imperial College of Science and Technology, Univ. of London, London.
Hvorslev, M. J. (1969). Physical properties of remolded cohesive soils, U.S. Army Engineer Waterways Experiment Station, Vicksburg, MS.
Jansen, T. A., Zhu, D., and Hill, A. D. (2015). “The effect of rock mechanical properties on fracture conductivity for shale formations.” SPE Hydraulic Fracturing Technology Conf., Society of Petroleum Engineers, Richardson, TX.
Ji, L., and Geehan, T. (2013). “Shale failure around hydraulic fractures in water fracturing of shale gas.” SPE Unconventional Resources Conf. Canada, Society of Petroleum Engineers, Richardson, TX.
Klinkenberg, L. J. (1941). “The permeability of porous media to liquids and gases.” Drilling and production practice, American Petroleum Institute, Washington, DC.
Li, G., Jia, F., and Yan, H. (2011). “Adaptive pseudo-color coding method base on rainbow-code for infrared measurement image.” J. Changchun Univ. Sci. Technol., 34(4), 32, 36–39.
Mao, H. J., Guo, Y. T., Wang, G. J., and Yang, C. H. (2010). “Evaluation of impact of clay mineral fabrics on hydration process.” Rock Soil Mech., 31(9), 2723–2728.
Moradian, Z., Fathi, A., and Evans, B. (2016). “Shear reactivation of natural fractures in hydraulic fracturing.” 50th U.S. Rock Mechanics/Geomechanics Symp., American Rock Mechanics Association, Alexandria, VA.
Morsy, S., and Sheng, J. J. (2014). “Effect of water salinity on shale reservoir productivity.” Adv. Pet. Explor. Dev., 8(1), 9–14.
Otsu, N. (1979). “A threshold selection method from gray-level histograms.” IEEE Trans. Syst. Manage. Cybern., 9(1), 62–66.
Pedlow, J., and Sharma, M. (2014). “Changes in shale fracture conductivity due to interactions with water-based fluids.” SPE Hydraulic Fracturing Technology Conf., Society of Petroleum Engineers, Richardson, TX.
Rosa, R. S., Rosa, A., Farias, S. B., Garcia, M. H., and Coelho, A. D. S. (2005). “A new inhibitive water-based fluid: A completely cationic system.” SPE Latin American and Caribbean Petroleum Engineering Conf., Society of Petroleum Engineers, Richardson, TX.
Roshan, H., Ehsani, S., Marjo, C. E., Andersen, M. S., and Acworth, R. I. (2015). “Mechanisms of water adsorption into partially saturated fractured shales: An experimental study.” Fuel, 159, 628–637.
Sun, Y., Bai, B., and Wei, M. (2015). “Microfracture and surfactant impact on linear cocurrent brine imbibition in gas-saturated shale.” Energy Fuels, 29(3), 1438–1446.
Talal, A. B. (2013). “A novel experimental technique to monitor the time-dependent water and ions uptake when shale interacts with aqueous solutions.” Rock Mech. Rock Eng., 46(5), 1145–1156.
Vidic, R. D., Brantley, S. L., Vandenbossche, J. M., Yoxtheimer, D., and Abad, J. D. (2013). “Impact of shale gas development on regional water quality.” Science, 340(6134), 1235009.
Weng, X., Sesetty, V., and Kresse, O. (2015). “Investigation of shear-induced permeability in unconventional reservoirs.” 49th U.S. Rock Mechanics/Geomechanics Symp., American Rock Mechanics Association, Alexandria, VA.
Wong, R. C. K. (1998). “Swelling and softening behaviour of La Biche shale.” Can. Geotech. J., 35(2), 206–221.
Zhang, S. F., Qiu, Z. S., and Huang, W. A. (2015). “Water-adsorption properties of Xiazijie montmorillonite intercalated with polyamine.” Clay Miner., 50(4), 537–548.
Zhang, S. F., Sheng, J. J., and Qiu, Z. S. (2016). “Water adsorption on kaolinite and illite after polyamine adsorption.” J. Pet. Sci. Eng., 142, 13–20.
Zoback, M. D., and Byerlee, J. D. (1975). “Permeability and effective stress: Geologic notes.” AAPG Bulletin, 59(1), 154–158.
Zoback, M. D., Kohli, A., Das, I., and Mcclure, M. W. (2012). “The importance of slow slip on faults during hydraulic fracturing stimulation of shale gas reservoirs.” SPE Americas Unconventional Resources Conf., Society of Petroleum Engineers, Richardson, TX.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Mar 28, 2017
Accepted: Aug 9, 2017
Published online: Dec 11, 2017
Published in print: Feb 1, 2018
Discussion open until: May 11, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.