Municipal Solid Waste Slope Stability Modeling: A Probabilistic Approach
This article has been corrected.
VIEW CORRECTIONPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 143, Issue 8
Abstract
The geotechnical properties (e.g., density, friction angle, and cohesion) of waste material in landfills and dumpsites vary significantly, depending on the waste composition and compaction practices. This variability results in a major source of uncertainty in slope stability analysis for municipal solid waste (MSW) disposal sites. This study presents a novel probabilistic approach for slope stability analysis by backcalculation, assigning probability distributions to waste material properties. Using backanalysis of historical, well-documented failed waste slopes, probability distributions for the density, friction angle, and cohesion of MSW are assigned based on the disposal method (landfill or dumpsite) and waste material composition (fibrous or food waste materials). MSW with (1) major food waste contents has lower shear strength (friction angle = 22.2° and cohesion = 19.2 kPa) in comparison with MSW with major fibrous waste contents (friction angle = 34° and cohesion = 14 kPa) and (2) compaction practices in landfills compared to dumpsites result in 20% higher shear-strength properties for the waste material. The application of this new approach and its advantages is demonstrated/validated using four case studies (Rumpke, Durban, Istanbul, and Sarajevo).
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was made possible by funding from the Natural Sciences and Engineering Research Council of Canada.
References
Athanasopoulos, G., Grizi, A., Zekkos, D., Founta, P., and Zisimatou, E. (2008). “Municipal solid waste as a reinforced soil: Investigation using synthetic waste.” ASCE-Geoinstitute Geocongress, ASCE, Reston, VA, 168–175.
Babu, G. L. S., Asce, M., Reddy, K. R., Asce, F., Srivastava, A., and Asce, A. M. (2014). “Influence of spatially variable geotechnical properties of MSW on stability of landfill slopes.” J. Hazard. Toxic Radioactive Waste, 27–37.
Bareither, C. A., Benson, C. H., and Edil, T. B. (2012). “Effects of waste composition and decomposition on the shear strength of municipal solid waste.” J. Geotech. Geoenviron. Eng., 1161–1174.
Blight, G. (2008). “Slope failures in municipal solid waste dumps and landfills: A review.” Waste Manage. Res., 26(5), 448–463.
Bray, J., and Zekkos, D. (2009). “Shear strength of municipal solid waste.” J. Geotech. Geoenvioron. Eng., 709–722.
Bray, J. D., and Zekkos, D. (2008). “Research needs in solid waste mechanics.” Int. Symp. on Waste Mechanics Geotechnical Characterization, Field Measurement, and Laboratory Testing of Municipal Solid Waste, ASCE, Reston, VA, 195–205.
Chen, Y. M., Ke, H., Fredlund, D. G., Zhan, L. T., and Xie, Y. (2010). “Secondary compression of municipal solid wastes and a compression model for predicting settlement of municipal solid waste landfills.” J. Geotech. Geoenviron. Eng., 706–717.
Cho, Y. M., Ko, J. H., Chi, L., and Townsend, T. G. (2011a). “Food waste impact on municipal solid waste angle of internal friction.” Waste Manage., 31(1), 26–32.
Christian, J. T., Ladd, C. C., and Baecher, G. B. (1994). “Reliability applied to slope stability analysis.” J. Geotech. Eng., 2180–2207.
De Stefano, M., Gharabaghi, B., Clemmer, R., and Jahanfar, M. (2016). “Berm design to reduce risks of catastrophic slope failures at solid waste disposal sites.” Waste Manage. Res., 34(11), 1117–1125.
Dixon, N., Langer, U., and Gotteland, P. (2008). “Classification and mechanical behavior relationships for municipal solid waste: Study using synthetic wastes.” J. Geotech. Geoenviron. Eng., 79–90.
Duncan, J. M. (2000). “Factors of safety and reliability in geotechnical engineering.” J. Geotech. Geoenviron. Eng., 307–316.
Eid, B. H. T., Stark, T. D., Evans, W. D., and Sherry, P. E. (2000). “Municipal solid waste slope failure. I: Waste and foundation soil properties.” J. Geotech. Geoenviron. Eng., 397–407.
Eid, H. T., Stark, T. D., Evans, W. D., and Sherry, P. E. (2000). “Municipal solid waste slope failure. II: Stability analyses.” J. Geotech. Geoenviron. Eng., 408–419.
El-Ramly, H., Morgenstern, N. R., and Cruden, D. M. (2002). “Probabilistic slope stability analysis for practice.” Can. Geotech. J., 39(3), 665–683.
Ering, P., and Babu, G. S. (2016). “Probabilistic back analysis of rainfall induced landslide: A case study of Malin landslide, India.” Eng. Geol., 208, 154–164.
Fowmes, G. J., Jones, D. R. V., and Dixon, N. (2006). “Interface shear strength variability and its use in reliability-based landfill stability analysis.” Geosynthetics Int., 13(1), 1–14.
Gharabaghi, B., Singh, M. K., Inkratas, C., Fleming, I. R., and McBean, E. A. (2008). “Comparison of slope stability in two Brazilian municipal landfills.” Waste Manage., 28(9), 1509–1517.
Hanson, J. L., Yesiller, N., Von Stockhausen, S. a., and Wong, W. W. (2010). “Compaction characteristics of municipal solid waste.” J. Geotech. Geoenviron. Eng., 1095–1102.
Hossain, M. S., and Haque, M. a. (2009). “The effects of daily cover soils on shear strength of municipal solid waste in bioreactor landfills.” Waste Manage., 29(5), 1568–1576.
Jahanfar, A., Amirmojahedi, M., Gharabaghi, B., Dubey, B., McBean, E., and Kumar, D. (2017). “A novel risk assessment method for landfill slope failure: Case study application for Bhalswa Dumpsite, India.” Waste Manage. Res., 35(3), 220–227.
Jianguo, J., Yong, Y., Shihui, Y., Bin, Y., and Chang, Z. (2010). “Effects of leachate accumulation on landfill stability in humid regions of China.” Waste Manage., 30(5), 848–855.
Koelsch, F. (2007). “Stability problems of landfills—The Payatas landslide.” Proc., 17th Int. Conf. on Solid Waste Technology and Management, Widener Univ. School of Engineering, Chester, PA, 1–7.
Machado, S., Carvalho, M., and Vilar, O. (2002). “Constitutive model for municipal solid waste.” J. Geotech. Geoenviron. Eng., 940–951.
McBean, E. a., Syed-Ritchie, S., and Rovers, F. a. (2007). “Performance results from the Tucuman solid waste bioreactor.” Waste Manage., 27(12), 1783–1791.
Mcknight, T., Cho, Y. M., Townsend, T. G., and Choate, A. (2015). “Cone penetration testing for characterizing landfilled municipal solid waste.” J. Geotech. Geoenviron. Eng., .
Merry, S. M., Kavazanjian, Jr., E., and Fritz, W. U. (2005). “Reconnaissance of the July 10, 2000, Payatas landfill failure.” J. Perform. Constr. Facil., 100–107.
Moon, S. W., and Ku, T. (2016). “Development of global correlation models between in-situ stress-normalized shear wave velocity and soil unit weight for plastic soils.” Can. Geotech. J., 53(10) 1600–1611.
Munawar, E., and Fellner, J. (2013). “Guidelines for design and operation of municipal solid waste landfills in tropical climates.” International Solid Waste Association, Vienna, Austria.
Omari, A. (2012). “Slope stability analysis of industrial solid waste landfills.” Master thesis, Luleå Univ. of Technology, Lulea, Sweden.
Onisiphorou, C., Georgiou, P., and Anastasiou, C. (2011). “Risk-based analysis of waste landfill slopes.” Protection and restoration of the environment XI environmental geotechnology, Centre for Research and Technology Hellas, Thessaloniki, Greece, 1328–1335.
Qian, X., Koerner, R. M., and Gray, D. H. (2003). “Translational failure analysis of landfills.” J. Geotech. Geoenviron. Eng., 506–519.
Ramaiah, B. J., Ramana, G. V., Kavazanjian Jr, E., Matasovic, N., and Bansal, B. K. (2016). “Empirical model for shear wave velocity of municipal solid waste in situ.” J. Geotech. Geoenviron. Eng., .
Reddy, K. R., Hettiarachchi, H., Parakalla, N. S., Gangathulasi, J., and Bogner, J. E. (2009). “Geotechnical properties of fresh municipal solid waste at Orchard Hills Landfill, USA.” Waste Manage., 29(2), 952–959.
Sabatini, P. J., Griffin, L. M., Bonaparte, R., Espinoza, R. D., and Giroud, J. P. (2002). “Reliability of state of practice for selection of shear strength parameters for waste containment system stability analyses.” Geotext. Geomembr., 20(4), 241–262.
Sharma, M., and McBean, E. (2007). “A methodology for solid waste characterization based on diminishing marginal returns.” Waste Manage., 27(3), 337–344.
Singh, M. K., Sharma, J. S., and Fleming, I. R. (2009). “Shear strength testing of intact and recompacted samples of municipal solid waste.” Can. Geotechn. J., 46(10), 1133–1145.
Srivastava, A., and Reddy, K. R. (2012). “Probabilistic design of municipal solid waste landfill slopes.” XII Int. Symp. on Environmental Geotechnology, Energy and Global Sustainable Development, Unveiling the Pathways to Global Sustainability, California State Univ., Los Angeles.
Stark, T. D., and Huvaj-Sarihan, N. (2009). “Shear strength of municipal solid waste for stability analyses.” Environ. Geol., 57(8), 1911–1923.
Wong, W. W. Y. (2009). “Investigation of the geotechnical properties of municipal solid waste as a function of placement conditions.” Master thesis, California Polytechnic State Univ., San Luis Obispo, CA.
Zekkos, D., Athanasopoulos, G. a, and Vlachakis, V. S. (2014). “The 2010 Xerolakka landfill slope instability.” Environ. Geotech., 1(1), 56–65.
Zekkos, D., Athanasopoulos, G. a., Bray, J. D., Grizi, A., and Theodoratos, A. (2010). “Large-scale direct shear testing of municipal solid waste.” Waste Manage., 30(8–9), 1544–1555.
Zekkos, D., Bray, J. D., Kavazanjian, E., Matasovic, N., Rathje, E. M., Riemer, M. F., and Stokoe, K. H. (2006). “Unit weight of municipal solid waste.” J. Geotech. Geoenviron. Eng., 1250–1261.
Zekkos, D., Bray, J. D., and Riemer, M. F. (2012). “Drained response of municipal solid waste in large-scale triaxial shear testing.” Waste Manage., 32(10), 1873–1885.
Zekkos, D., Kavazanjian, E., Bray, J. D., Matasovic, N., and Riemer, M. F. (2010). “Physical characterization of municipal solid waste for geotechnical purposes.” J. Geotech. Geoenviron. Eng., 1231–1241.
Zhang, J., Tang, W. H., and Zhang, L. M. (2010). “Efficient probabilistic back-analysis of slope stability model parameters.” J. Geotech. Geoenviron. Eng., 99–109.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Apr 13, 2016
Accepted: Jan 12, 2017
Published online: Mar 31, 2017
Published in print: Aug 1, 2017
Discussion open until: Aug 31, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.