Variation of Liquefaction Strength Induced by Monotonic and Cyclic Loading Histories
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 143, Issue 4
Abstract
Once loose sand has liquefied, it becomes denser along with water drainage after liquefaction. Therefore, liquefied sand is regarded as more robust against liquefaction. Such sand after liquefaction is expected to liquefy again only slightly. Nevertheless, examples of repeated ground liquefaction have been reported during some earthquake events. Reliquefaction characteristics of saturated sandy ground must be estimated accurately with consideration of the liquefaction history related to past earthquakes. Moreover, the stress history affecting liquefaction strength must be considered. Cyclic triaxial tests were conducted to estimate the liquefaction strength ratio during and after liquefaction using specimens with a history of overconsolidation. The shear wave velocity, which is related strongly to the soil physical properties, was also measured in the same specimen. Results show that the stress history does not affect the specimen shear wave velocity despite increased liquefaction strength. The increased liquefaction strength induced by the stress history is eliminated by the liquefaction history.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The experiments presented in this paper were assisted by former graduate students at the Geotechnical Engineering Laboratory, the Department of Civil and Environmental Engineering, Nagaoka University of Technology. The authors extend their sincere appreciation for their experimental assistance and helpful cooperation.
References
Boulanger, R. W. (2003). “Relating to relative state parameter index.” J. Geotech. Geoenviron. Eng., 1071–1082.
Cubrinovski, M., Henderson, D., and Bradley, B. A. (2012). “Liquefaction impacts in residential areas in the 2010–2011 Christchurch earthquakes.” Proc., Int. Symp. on Engineering Lessons Learned from the 2011 Great East Japan Earthquake, Japan Association for Earthquake Engineering, Tokyo, 811–824.
Finn, W. D. L., Bransby, P. L., and Pickering, D. J. (1970). “Effect of strain history on liquefaction of sand.” J. Soil Mech. Found. Div., 96(6), 1917–1934.
Harder, L. F., Jr., and Boulanger, R. W. (1997). “Application of Ks and Ka correction factors.” Proc., NCEER Workshop on Evaluation of Liquefaction Resistance of Soils, National Center for Earthquake Engineering Research, State Univ. of Buffalo New York, Buffalo, NY, 167–190.
Hashiguchi, K. (1989). “Subloading surface model in unconventional plasticity.” Int. J. Solids Struct., 25(8), 917–945.
Hatanaka, M., Uchida, A., and Suzuki, Y. (1997). “Correlation between undrained cyclic shear strength and shear wave velocity for gravelly soils.” Soils Found., 37(4), 85–92.
Ishihara, K. (1993). “Liquefaction and flow failure during earthquakes.” Géotechnique, 43(3), 351–415.
Ishihara, K., and Okada, S. (1978). “Effects of stress history on cyclic behavior of sand.” Soils Found., 18(4), 31–45.
Ishihara, K., and Okada, S. (1982). “Effects of large pre-shearing on cyclic behavior of sand.” Soils Found., 22(3), 109–125.
Jamiolkowski, M., Lancellotta, R., and Lo Presti, D. C. F. (1995). “Remarks on stiffness at small strains of six Italian clays.” Pre-failure deformation of geomaterials, A.A. Balkema, Rotterdam, Netherlands, 817–836.
Jardine, R. J. (1992). “Some observations on the kinematic nature of soil stiffness.” Soils Found., 32(2), 111–124.
Ladd, R. S. (1977). “Specimen preparation and cyclic stability of sands.” J. Geotech. Eng. Div., 103(GT6), 535–547.
Mulilis, J. P., Seed, H. B., Chan, C. K., Mitchell, J. K., and Arulanandan, K. (1977). “Effects of sample preparation on sand liquefaction.” J. Geotech. Eng. Div., 103(GT2), 91–108.
Oda, M., Kawamoto, K., Suzuki, K., Fujimori, H., and Sato, M. (2001). “Microstructural interpretation on reliquefaction of saturated granular soils under cyclic loading.” J. Geotech. Geoenviron. Eng., 416–423.
Rad, N. S., and Clough, G. W. (1984). “New procedure for saturating sand specimens.” J. Geotech. Eng., 1205–1218.
Sasaki, Y., and Taniguchi, E. (1982). “Shaking table tests on gravel drains to prevent liquefaction of sand deposits.” Soils Found., 22(3), 1–14.
Seed, H. B., Mori, K., and Chan, C. K. (1977). “Influence of seismic history on liquefaction of sands.” J. Geotech. Eng. Div., 103(GT4), 257–270.
Seed, R. B., and Harder, L. F., Jr. (1990). “SPT-based analysis of cyclic pore pressure generation and undrained residual strength.” Proc., Seed Memorial Symp., J. M. Duncan, ed., BiTech Publishers, Vancouver, BC, Canada, 351–376.
Seed, R. B., Lee, S. R., and Jong, H.-L. (1988). “Penetration and liquefaction resistances: Prior seismic history effects.” J. Geotech. Eng., 691–697.
Stokoe, K. H., Roberts, J. N., Hwang, S., Cox, B. R., Menq, F. Y., and Van Ballegooy, S. (2014). “Effectiveness of inhibiting liquefaction triggering by shallow ground improvement methods: Initial field shaking trials with TRex at one site in Christchurch, New Zealand.” Soil liquefaction during recent large-scale earthquakes, R. Orense, I. Towhata, and N. Chouw, eds., Taylor & Francis Group, London, 193–202.
Suzuki, T., and Toki, S. (1984). “Effects of preshearing on liquefaction characteristics of saturated sand subjected to cyclic loading.” Soils Found., 24(2), 16–28.
Tatsuoka, F., Kato, H., Kimura, M., and Pradhan, T. B. S. (1988). “Liquefaction strength of sands subjected to sustained pressure.” Soils Found., 28(1), 119–131.
Towhata, I., and Ishihara, K. (1985). “Undrained strength of sand undergoing cyclic rotation of principal stress axes.” Soils Found., 25(2), 135–147.
Toyota, H., Hara, T., Takezawa, K., Takada, S., and Susami, A. (2012). “Liquefaction damage analysis and application to emergency measures in Urayasu city using portable cone penetration test and surface wave method.” Jpn. Geotech. J., 7(1), 207–218 (in Japanese).
Toyota, H., and Takada, S. (2014). “Variation of liquefaction strength during cyclic undrained loading process.” Int. Symp. on Geohazards: Science, Engineering and Management, Nepal Geotechnical Society, Kathmandu, Nepal, 35–43.
Tsuboi, H., Takahashi, Y., Harada, K., Shinkawa, N., Ishihara, K., and Yasuda, S. (1996). “Damage by liquefaction and effect of soil improvement methods on the Hyogoken-Nambu earthquake.” Proc., Congress on Great Hanshin-Awaji Earthquake Disaster, Japan Society of Civil Engineers, Tokyo (in Japanese).
Vaid, Y. P., Stedman, J. D., and Sivathayalan, S. (2001). “Confining stress and static shear effects in cyclic liquefaction.” Can. Geotech. J., 38(3), 580–591.
Vucetic, M. (1994). “Cyclic threshold shear strains in soils.” J. Geotech. Eng., 2208–2228.
Vucetic, M., and Dobry, R. (1991). “Effect of soil plasticity on cyclic response.” J. Geotech. Eng., 89–107.
Wakamatsu, K. (2011). “Consideration of re-liquefied sites and upper bound relationship between M and R based on the latest liquefaction case histories until 2009.” Proc., 46th Japan National Conf. on Geotechnical Enginerring, Japanese Geotechnical Society, Tokyo, 1721–1722 (in Japanese).
Wichtmann, T., Niemunis, A., Triantafyllidis, T., and Poblete, M. (2005). “Correlation of cyclic preloading with the liquefaction resistance.” Soil Dyn. Earthquake Eng., 25(12), 923–932.
Yamada, S., Takamori, T., and Sato, K. (2010). “Effects on reliquefaction resistance produced by changes in anisotropy during liquefaction.” Soils Found., 50(1), 9–25.
Yamaguchi, A., Yoshida, N., and Tobita, Y. (2008). “Experimental study about reliquefaction mechanism.” J. Jpn. Assoc. Earthquake Eng., 8(3), 46–62.
Yasuda, S., Harada, K., Ishikawa, K., and Kanemaru, Y. (2012). “Characteristics of liquefaction in Tokyo Bay area by the 2011 Great East Japan earthquake.” Soils Found., 52(5), 793–810.
Yasuda, S., and Tohno, I. (1988). “Sites of reliquefaction caused by the 1983 Nihonkai-Chubu earthquake.” Soils Found., 28(2), 61–72.
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Oct 8, 2015
Accepted: Aug 23, 2016
Published online: Nov 11, 2016
Published in print: Apr 1, 2017
Discussion open until: Apr 11, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.