Stress Redistribution after Blast Densification
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 142, Issue 11
Abstract
Results of a numerical finite-element (FE) simulation are presented to evaluate stress changes that affect the results of cone penetration tests (CPT) made at a test section after blast densification. The two-dimensional (2D) FE simulation was not used to predict liquefaction, as the pore-pressure distribution immediately after each blast and the extent of liquefaction, determined from field observations of ground-surface settlements and pore-pressure measurements, were an input rather than a result. A fully coupled FE formulation was employed to compute time-dependent deformations and stress changes that result from dissipation and seepage of input excess pore pressures. Computed results indicate stress levels within the targeted loose sand decrease near the edge of the blast zone as a result of stress redistributions that take place during reconsolidation, and likely contribute to decreased penetration resistance observed near the perimeter of the zone. Outside the blast zone, computed stress levels increased in areas that did not liquefy, and likely contributed to small increases in penetration resistance measured at these locations. However, computed results suggest that stress levels near the center of the zone remain unchanged, yet penetration resistance at the test section did not increase despite significant amounts of settlement. Occluded gas bubbles in the soil matrix resulting from gas released by the explosives affect the mechanical response of the sand postblasting during the CPT. Recommendations are made concerning evaluation of ground improvement after blast densification.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Funding for this study was provided by the National Science Foundation through Grant No. CMMI 1235440. The support of Dr. Richard Fragaszy, program director at NSF, is greatly appreciated. The authors would like to thank Waste Management for allowing access to the site. In addition, the authors would like to thank Dr. Paul Sabatini, Dr. Robert Bachus, and Dr. Majdi Othman of Geosyntec Consultants for their interest and help with this work.
References
Arboleda-Monsalve, L. (2014). “Performance, instrumentation and numerical simulation of One Museum Park West excavation.” Ph.D. dissertation, Dept. of Civil Engineering, Northwestern Univ., Evanston, IL.
Ashford, S. A., Rollins, K. M., and Lane, J. D. (2004). “Blast-induced liquefaction for full-scale foundation testing.” J. Geotech. Geoenviron. Eng., 798–806.
Bauer, E. (1996). “Calibration of a comprehensive hypoplastic model for granular materials.” Soils Found., 36(1), 13–26.
Brooks, R. H., and Corey, A. T. (1966). “Properties of porous media affecting fluid flow.” J. Irrig. Drain. Div., 92(IR2), 61–88.
Camp, W. M., Mayne, P. W., and Rollins, K. M. (2008). “Cone penetration testing before, during, and after blast-induced liquefaction.” Geotechnical earthquake engineering and soil dynamics IV, ASCE, Sacramento, CA, 10.
Charlie, W. A., Rwebyogo, M. F. J., and Doehring, D. O. (1992). “Time-dependent cone penetration resistance due to blasting.” J. Geotech. Geoenviron. Eng., 1200–1215.
Dowding, C. H., and Hryciw, R. D. (1986). “A laboratory study of blast densification of saturated sand.” J. Geotech. Eng., 187–199.
Finno, R. J., Gallant, A. P., and Sabatini, P. (2016). “Evaluating ground improvement after blast densification: Performance at the Oakridge landfill.” J. Geotech. Geoenviron. Eng., 04015054.
Gallage, C., Kodikara, J., and Uchimura, T. (2013). “Laboratory measurement of hydraulic conductivity functions of two unsaturated sandy soils during drying and wetting processes.” Soils Found., 53(3), 417–430.
Gallant, A. P. (2014). “A field and numerical evaluation of blast densification at a test section.” Ph.D. dissertation, Dept. of Civil Engineering, Northwestern Univ., Evanston, IL, 395.
Gandhi, S., Dey, A., and Selvam, S. (1999). “Densification of pond ash by blasting.” J. Geotech. Geoenviron. Eng., 889–899.
Gohl, W. B., Howie, J. A., and Everard, J. (1996). “Use of explosive compaction for dam foundation preparation.” 49th Canadian Geotechnical Conf., Vol. 2, Canadian Geotechnical Society, Richmond, BC, Canada, 758–793.
Gohl, W. B., Howie, J. A., Hawson, H. H., and Diggle, D. (1994). “Field experience with blast densification.” Proc., 5th U.S. National Conf. on Earthquake Engineering, Vol. 4, Earthquake Engineering Research Institute, Oakland, CA, 221–231.
Gohl, W. B., Jefferies, M. G., Howie, J. A., and Diggles, D. (2000). “Explosive compaction: Design, implementation and effectiveness.” Geotechnique, 50(6), 657–665.
Gohl, W. B., Tsujino, S., Wu, G., Yoshida, N., Howie, J. A., and Everard, J. (1998). “Field application of explosive compaction in silty soils and numerical analysis.” Geotechnical earthquake engineering and soil dynamics III, GSP 75, ASCE, Reston, VA, 654–665.
Gudehus, G. (1996). “A comprehensive constitutive equation for granular materials.” Soils Found., 36(1), 1–12.
Handford, G. T. (1988). “Densification of an existing dam with explosives.” Hydraulic fill structures, GSP 21, ASCE, Reston, VA, 750–762.
Herle, I., and Gudehus, G. (1999). “Determination of parameters of a hypoplastic constitutive model from properties of grain assemblies.” Mech. Cohes.-Frict. Mater., 4, 461–486.
Jamiolkowski, M. B., Lo Presti, D. C. F., and Manassero, M. (2003). “Evaluation of relative density and shear strength of sands from CPT and DMT.” Soil behavior and soft ground construction, ASCE, Reston, VA, 201–238.
Kimmerling, R. E. (1994). “Blast densification for mitigation of dynamic settlement and liquefaction.”, Washington State Dept. of Transportation, Olympia, WA.
Kokusho, T. (1999). “Water film in liquefied sand and its effect on lateral spread.” J. Geotech. Geoenviron. Eng., 817–825.
Kokusho, T., and Fujita, K. (2002). “Site investigations for involvement of water films in lateral flow in liquefied ground.” J. Geotech. Geoenviron. Eng., 917–925.
Kolymbas, D. (1991). “An outline of hypoplasticity.” Arch. Appl. Mech., 61(3), 143–154.
La Fosse, U., and Rosenvinge, T. V., IV (1992). “Densification of loose sands by deep blasting.” Grouting, soil improvement and geosynthetics, GPS 30, ASCE, Reston, VA, 954–968.
LaFosse, U., and Gelormino, T. A. (1991). “Soil improvement by deep blasting—A case study.” Proc., 17th Annual Symp. on Explosives and Blasting Technique, International Society of Explosive Engineers, Cleveland, 205–213.
Liao, T., and Mayne, P. W. (2005). “Cone penetrometer measurements during Mississippi embayment seismic excitation experiment.” Earthquake Engineering and Soil Dynamics: GeoFrontiers 2005, ASCE, Reston, VA, 1–12.
Lyman, A. K. B. (1942). “Compaction of cohesionless foundation soils by explosives.” Trans. ASCE, 107, 1330–1348.
Masin, D. (2005). “A hypoplastic constitutive model for clays.” Int. J. Numer. Anal. Meth., 29(4), 311–336.
Mesri, G., Feng, T. W., and Benak, J. M. (1990). “Postdensification penetration resistance of clean sands.” J. Geotech. Eng., 1095–1115.
Mitchell, J. K., and Solymar, Z. V. (1984). “Time-dependent strength gain in freshly deposited or densified sand.” J. Geotech. Eng., 1559–1576.
Narin van Court, W. A., and Mitchell, J. K. (1994). “Soil improvement by blasting.” J. Explosive Eng., 12(3), 34–41.
Narsilio, G. A. (2006). “Spatial variability and terminal density-implications in soil behavior.” Ph.D. dissertation, Dept. of Civil Engineering, Georgia Institute of Technology, Atlanta, 230.
Narsilio, G. A., Santamarina, J. C., Hebeler, T., and Bachus, R. (2009). “Blast densification: Multi-instrumented case history.” J. Geotech. Geoenviron. Eng., 723–734.
Niemunis, A., and Herle, I. (1997). “Hypoplastic model for cohesionless soils with elastic strain range.” Mech. Cohes. Firct. Mater., 2(4), 279–299.
PLAXIS 2D [Computer software]. Plaxis, Delft, Netherlands.
Rad, N. S., Vianna, A. J. D., and Berre, T. (1994). “Gas in soil. II: Effect of gas on undrained static and cyclic strength of sand.” J. Geotech. Geoenviron. Eng., 716–736.
Raju, V. R., and Gudehus, G. (1994). “Compaction of loose sand deposits using blasting.” 13th Int. Conf. on Soil Mechanics and Foundation Engineering, ASCE, Reston, VA, 1145–1150.
Rollins, K. M., and Anderson, J. K. S. (2008). “Cone penetration resistance variation with time after blast liquefaction testing.” Geotechnical earthquake engineering and soil dynamics IV, GSP 181, ASCE, Reston, VA, 10.
Schmertmann, J. H. (1987). “Discussion of ‘Time-dependent strength gain in freshly deposited or densified sand’ by James K. Mitchell and Zoltan V. Solymar.” J. Geotech. Geoenviron. Eng., 173–175.
Solymar, Z. V. (1984). “Compaction of alluvial sands by deep blasting.” Can. Geotech. J., 21(2), 305–321.
Van Genuchten, M. T. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
Vega-Posada, C. A., Finno, R. J., and Zapata-Medina, D. G. (2014). “Effect of gas in the mechanical behavior of medium dense sands.” J. Geotech. Geoenviron. Eng., 04014063.
von Wolffersdorff, P. A. (1996). “A hypoplastic relation for granular materials with a predefined limit state surface.” Mech. Cohes-Frict Mat., 1(3), 251–271.
Weems, R. E., Lemon, E. M., Jr., and Nelson, M. S. (1997). “Geology of the Pringletown, Ridgeville, Summerville, and Summerville Northwest 7.5-minute quadrangles, Berkeley, Charleston, and Dorchester Counties, South Carolina.” USGS, I-Map, 2502, 1–9.
Wu, W., and Kolymbas, D. (1990). “Numerical testing of the stability criterion for hypoplastic constitutive equations.” Mech. Mater., 9(3), 245–253.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 142 • Issue 11 • November 2016
Copyright
© 2016 American Society of Civil Engineers.
History
Received: May 5, 2015
Accepted: Jan 8, 2016
Published online: Jul 6, 2016
Published in print: Nov 1, 2016
Discussion open until: Dec 6, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.