Rocking Effect of a Mat Foundation on the Earthquake Response of Structures
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 141, Issue 1
Abstract
To evaluate the effect of soil-foundation interaction on the earthquake response of structures, centrifuge tests were performed using an in-flight earthquake simulator. The test specimen was composed of a single-degree-of-freedom structure model, a shallow foundation, and subsoil deposits in a centrifuge container. The test parameters were the dynamic period of the structure model, the centrifugal acceleration level, and the type and level of input earthquake accelerations. The test results showed that the lateral forces of the structures were limited by the soil-bearing strength (i.e., ultimate moment capacity of the foundation) and the damping effect owing to the rocking motion of the foundation. Thus, even when the periods of the structures were close to the site periods, the lateral forces did not significantly increase. However, it should be noted that, because of the damping effect of the foundation, the maximum seismic lateral load of the structures exceeded the load statically determined by the soil-bearing strength. This issue should be addressed for the safe design of structures and members. In this test, the maximum damping ratio for rocking due to the rocking motion was estimated to be 0.31.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Research Foundation of Korea (NRF) grant (2010-0027593) funded by the Korean government’s Ministry of Education, Science and Technology.
References
AISC. (2005). “Seismic provisions for structural steel buildings.” ANSI/AISC 341-05, Chicago.
Anastasopoulos, I., Gelagoti, F., Spyridaki, A., Sideri, J., and Gazetas, G. (2014). “Seismic rocking isolation of an asymmetric frame on spread footings.” J. Geotech. Geoenviron. Eng., 133–151.
Applied Technology Council (ATC). (1996). “Seismic evaluation and retrofit of concrete buildings.” ATC-40, Redwood City, CA.
Chopra, A. K. (2007). Dynamics of structures, Prentice Hall, Upper Saddle River, NJ.
Das, B. M. (2007). Principles of foundation engineering, Nelson Education, Toronto.
Deng, L., and Kutter, B. L. (2012). “Characterization of rocking shallow foundations using centrifuge model tests.” Earthquake Eng. Struct. Dynam., 41(5), 1043–1060.
Deng, L., Kutter, B. L., and Kunnath, S. K. (2012). “Centrifuge modeling of bridge systems designed for rocking foundations.” J. Geotech. Geoenviron. Eng., 335–344.
Drosos, V., Georgarakos, T., Loli, M., Anastasopoulos, I., Zarzouras, O., and Gazetas, G. (2012). “Soil-foundation-structure interaction with mobilization of bearing capacity: Experimental study on sand.” J. Geotech. Geoenviron. Eng., 1369–1386.
FEMA. (1997a). “NEHRP commentary on the seismic rehabilitation of buildings.” FEMA 274, Washington, DC.
FEMA. (1997b). “NEHRP guidelines for the seismic rehabilitation of buildings.” FEMA 273, Washington, DC.
FEMA. (2000). “Prestandard and commentary for the seismic rehabilitation of buildings.” FEMA 356, Washington, DC.
FEMA. (2004). “Improvement of nonlinear static seismic analysis procedures.” FEMA 440, Washington, DC.
Figini, R., Paolucci, R., and Chatzigogos, C. T. (2012). “A macro-element model for non-linear soil–shallow foundation–structure interaction under seismic loads: Theoretical development and experimental validation on large scale tests.” Earthquake Eng. Struct. Dynam., 41(3), 475–493.
Gajan, S., and Kutter, B. L. (2008). “Capacity, settlement, and energy dissipation of shallow footings subjected to rocking.” J. Geotech. Geoenviron. Eng., 1129–1141.
Gajan, S., and Kutter, B. L. (2009). “Contact interface model for shallow foundations subjected to combined cyclic loading.” J. Geotech. Geoenviron. Eng., 407–419.
Gajan, S., Kutter, B. L., Phalen, J. D., Hutchinson, T. C., and Martin, G. R. (2005). “Centrifuge modeling of load-deformation behavior of rocking shallow foundations.” Soil. Dyn. Earthquake Eng., 25(7–10), 773–783.
Gazetas, G. (2013). “Soil-foundation-structure systems beyond conventional seismic failure thresholds.” Proc., 18th Int. Conf. on Soil Mechanics and Geotechnical Engineering: Challenges and Innovations in Geotechnics, P. Delage, J. Desrues, R. Frank, A. Puech, and F. Schlosser, eds., French Society for Soil Mechanics and Geotechnical Engineering (CFMS), Rueil Malmaison, France.
Gelagoti, F., Kourkoulis, R., Anastasopoulos, I., and Gazetas, G. (2012). “Rocking isolation of low-rise frame structures founded on isolated footings.” Earthquake Eng. Struct. Dynam., 41(7), 1177–1197.
Kim, D.-S., Lee, S.-H., Choo, Y. W., and Perdriat, J. (2013). “Self-balanced earthquake simulator on centrifuge and dynamic performance verification.” KSCE J. Civ. Eng., 17(4), 651–661.
Lee, S.-H., Choo, Y.-W., and Kim, D.-S. (2013). “Performance of an equivalent shear beam (ESB) model container for dynamic geotechnical centrifuge tests.” Soil. Dyn. Earthquake Eng., 44(Jan), 102–114.
Paolucci, R., Shirato, M., and Yilmaz, M. T. (2008). “Seismic behaviour of shallow foundations: Shaking table experiments vs numerical modelling.” Earthquake Eng. Struct. Dynam., 37(4), 577–595.
Pecker, A. (1999). “Capacity design principles for shallow foundations in seismic areas.” Proc., 11th European Conf. on Earthquake Engineering, P. Bisch, P. Labbe, and A. Pecker, eds., Balkema, Rotterdam, Netherlands, 303–316.
Pecker, A. (2005). “Design and construction of the foundations of the Rion Antirion bridge.” Proc., 1st Greece-Japan Workshop on Seismic Design, Observation, Retrofit of Foundations, Laboratory of Soil Mechanics, National Technical Univ. of Athens, Athens, Greece, 119–130.
Schofield, A. N. (1980). “Cambridge geotechnical centrifuge operations.” Géotechnique, 30(3), 227–268.
Standards New Zealand Technical Committee. (2004). “Structural design actions—Part 5: Earthquake actions.” BD-006, Wellington, New Zealand.
Tileylioglu, S., Stewart, J. P., and Nigbor, R. L. (2011). “Dynamic stiffness and damping of a shallow foundation from forced vibration of a field test structure.” J. Geotech. Geoenviron. Eng., 344–353.
Zeng, X., and Schofield, A. N. (1996). “Design and performance of an equivalent-shear-beam container for earthquake centrifuge modeling.” Géotechnique, 46(1), 83–102.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 24, 2013
Accepted: Sep 2, 2014
Published online: Sep 25, 2014
Published in print: Jan 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.