Effects of Constraints on van Genuchten Parameters for Modeling Soil-Water Characteristic Curves
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 140, Issue 12
Abstract
Water-retention data for a suite of predominantly sandy soils were analyzed to quantify the effects of two constraints commonly applied to the three-parameter model for the soil-water characteristic curve (SWCC). Systematic effects were observed. Constraining either the symmetry parameter () to or residual saturation () to zero resulted in values for the air-entry parameter that were approximately 25–30% different than if no constraints were applied. The constraint forced the pore-size distribution parameter to fall within a narrow range (), whereas values using independent and were more variable and could be as large as 35. The constraint produced best-fit residual saturation values that were approximately 0.02 higher than without the constraint. These differences are significant and should be considered when adopting existing or new pedotransfer functions for estimating water-retention behavior of unsaturated soils from more easily measured properties.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This material is based on work supported by the National Science Foundation (NSF) under Grant 1304139. Any opinions, findings, conclusions, and/or recommendations expressed in this material are those of the authors and do not necessarily reflect the views of the NSF.
References
Benson, C. H., Chiang, I., Chalermyanont, T., and Sawangsuriya, A. (2014). “Estimating van Genuchten parameters and for clean sands from particle size distribution data.” Proc., From Soil Behavior Fundamentals to Innovations in Geotechnical Engineering, M. Iskander, J. E. Garlanger, and M. H. Hussein, eds., ASCE, Reston, VA, 410–427.
Bittelli, M., and Flury, M. (2009). “Errors in water retention curves determined with pressure plates.” Soil Sci. Soc. Am. J., 73(5), 1453–1460.
Brooks, R. H., and Corey, A. T. (1964). “Hydraulic properties of porous media.” Hydrology Paper No. 3, Colorado State Univ., Fort Collins, CO.
Burdine, N. T. (1953). “Relative permeability calculations from pore size distribution data.” Trans. Am. Inst. Min. Eng, 198, 71–78.
Carsel, R. F., and Parrish, R. S. (1988). “Developing joint probability distributions of soil water retention characteristics.” Water Resour. Res., 24(5), 755–769.
Fredlund, D. G., and Xing, A. (1994). “Equations for the soil-water characteristic curve.” Can. Geotech. J., 31(4), 521–532.
Gee, G. W., Ward, A. L., Zhang, Z. F., Campbell, G. S., and Mathison, J. (2002). “The influence of hydraulic nonequilibrium on pressure plate data.” Vadose Zone J., 1(1), 172–178.
Kosugi, K., Hopmans, J. W., and Dane, J. H. (2002). “Parametric models.” Methods of soil analysis: Part 4—Physical methods, Soil Science Society of America, Madison, WI.
Leij, F. J., Alves, W. J., van Genuchten, M. Th., and Williams, J. R. (1996). “The UNSODA unsaturated soil hydraulic database: User’s manual version 1.0.” EPA/600/R-96/095, National Risk Management Research Laboratory, EPA, Cincinnati.
Leong, E. C., and Rahardjo, H. (1997). “Review of soil-water characteristic curve equations.” J. Geotech. Geoenviron. Eng., 1106–1117.
Lu, N., and Likos, W. J. (2004). Unsaturated soil mechanics, Wiley, Hoboken, NJ.
Luckner, L., van Genuchten, M. Th., and Nielsen, D. R. (1989). “A consistent set of parametric models for the two-phase flow of immiscible fluids in the subsurface.” Water Resour. Res., 25(10), 2187–2193.
Mualem, Y. (1976). “A new model for predicting the hydraulic conductivity of unsaturated porous media.” Water Resour. Res., 12(3), 513–522.
Nimmo, J. R. (1991). “Comment on the treatment of residual water content in “A consistent set of parametric models for the two-phase flow of immiscible fluids in the subsurface” by L. Luckner et al.” Water Resour. Res., 27(4), 661–662.
Rawls, W. J., and Brakensiek, D. L. (1985). “Prediction of soil water properties for hydrologic modeling.” Proc., Watershed Management in the Eighties, E. B. Jones and T. J. Ward, eds., ASCE, Reston, VA, 293–299.
Revil, A., and Lu, N. (2013). “Unified water isotherms for clayey porous materials.” Water Resour. Res., 49(9), 5685–5699.
Schaap, M. G., and Leij, F. J. (1998). “Database-related accuracy and uncertainty of pedotransfer functions.” Soil Sci., 163(10), 765–779.
Schneider, M., and Goss, K.-U. (2012). “Prediction of water retention curves for dry soils from an established pedotransfer function: Evaluation of the Webb model.” Water Resour. Res., 48(6), W06603.
Sillers, W. S., Fredlund, D. G., and Zakerzaheh, N. (2001). “Mathematical attributes of some soil–water characteristic curve models.” Geotech. Geol. Eng., 19(3–4), 243–283.
Vanapalli, S. K., Sillers, W. S., and Fredlund, M. D. (1998). “The meaning and relevance of residual state to unsaturated soils.” Proc., 51st Canadian Geotechnical Conf., Canadian Geotechnical Society, Richmond, BC, Canada.
van Genuchten, M. Th. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
van Genuchten, M. Th., Leij, F. J, and Lund, L. J., eds. (1992). “Indirect methods for estimating the hydraulic properties of unsaturated soils.” Proc., Int. Workshop on Indirect Methods for Estimating the Hydraulic Properties of Unsaturated Soils, U.S. Salinity Laboratory, USDA, and Dept. of Soil and Environmental Sciences, Univ. of California, Riverside, CA.
van Genuchten, M. Th., Leij, F. J., and Yates, S. R. (1991). “The RETC code for quantifying the hydraulic functions of unsaturated soils.” EPA/600/2-91/065, Robert S. Kerr Environmental Research Laboratory, EPA, Ada, OK.
Vereecken, H., Weynants, M., Javaux, M., Pachepsky, Y., Schaap, M. G., and van Genuchten, M. Th. (2010). “Using pedotransfer functions to estimate the van Genuchten–Mualem soil hydraulic properties: A review.” Vadose Zone J., 9(4), 795–820.
Webb, S. W. D. (2000). “A simple extension of two-phase characteristic curves to include the dry region.” Water Resour. Res., 36(6), 1425–1430.
Wösten, J. H. M., Pachepsky, Y. A., and Rawls, W. J. (2001). “Pedotransfer functions: Bridging the gap between available basic soil data and missing soil hydraulic characteristics.” J. Hydrol., 251(3–4), 123–150.
Yang, H., Rahardjo, H., Leong, E. C., and Fredlund, D. G. (2004). “Factors affecting drying and wetting soil-water characteristic curves of sandy soils.” Can. Geotech. J., 41(5), 908–920.
Zapata, C. E., Houston, W. N., Houston, S. L., and Walsh, K. D. (2000). “Soil–water characteristic curve variability.” Proc., Advances in Unsaturated Geotechnics, C. D. Shackelford, S. L. Houston, and N.-Y. Chang, eds., ASCE, Reston, VA, 84–124.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Apr 2, 2014
Accepted: Jul 1, 2014
Published online: Jul 30, 2014
Published in print: Dec 1, 2014
Discussion open until: Dec 30, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.