Numerical Modeling of an Embankment over Soft Ground Improved with Deep Cement Mixed Columns: Case History
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 140, Issue 11
Abstract
This paper describes a case history of a deep cement mixed (DCM) column–supported embankment that is part of the Ballina Bypass section of the Pacific Highway Upgrade project in Australia. Measured settlements during and after construction of the embankment were significantly greater than the predicted settlements and suggested that the DCM columns were yielded. The case history was analyzed using a finite-element model based on the coupled theory of nonlinear porous media. Two cases were analyzed: with and without the strain-softening behavior of DCM columns caused by breakage of the soil-cement structure. The computed settlements, excess pore-water pressures, and lateral deformations were compared with field measurements. Results show that there was good agreement between the measured and the computed parameters when the strain-softening behavior of the columns was included. These results clearly show that consideration of the strain softening of DCM columns in the analysis is important if yielding occurs during or after embankment construction.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge the financial support for this research provided by the Australian Research Council and Coffey Geotechnics Pty Ltd. under the Linkage project LP0990581. In addition, the Roads and Traffic Authority of New South Wales, Australia, is greatly acknowledged for permission to publish data from the Ballina Bypass.
References
ABAQUS 6.11 [Computer software]. Waltham, MA, Dassault Systèmes.
Ariyarathne, P., Liyanapathirana, D. S., and Leo, C. J. (2013). “Comparison of different two-dimensional idealizations for a geosynthetic-reinforced pile-supported embankment.” Int. J. Geomech., 754–768.
Axelsson, M., and Rehnman, S. E. (1999). “Field methods for quality control at the dry jet mixing method.” Proc., Int. Conf. on Dry Mix Methods for Deep Soil Stabilization, H. Brendenberg, G. Holm, and B. B. Broms, eds., Balkema, Rotterdam, Netherlands, 303–310.
Bergado, D. T., Ruenkrairergsa, T., Taesiri, Y., and Balasubramaniam, A. S. (1999). “Deep soil mixing used to reduce embankment settlement.” Proc. Inst. Civ. Eng. Ground Improv., 3(4), 145–162.
Borges, J. L., and Marques, D. O. (2011). “Geosynthetic-reinforced and jet grout column-supported embankments on soft soils: Numerical analysis and parametric study.” Comput. Geotech., 38(7), 883–896.
Bruce, D. A. (2001). “An introduction to the deep mixing methods as used in geotechnical applications, Volume 3: The verification and properties of treated ground.” Rep. No. FHWA-RD-99-167, Federal Highway Administration, Washington, DC.
Carlsten, P., and Ekstrom, J. (1997). “Lime and lime cement columns: Guide for project planning, construction and inspection.” SGF Rep. 4:95E, Swedish Geotechnical Society, Linköping, Sweden.
Chai, J.-C., Miura, N., and Shen, S.-L. (2002). “Performance of embankments with and without reinforcement on soft subsoil.” Can. Geotech. J., 39(4), 838–848.
Chan, K., and Poon, B. (2012). “Designing stone columns using 2D FEA with equivalent strips.” Proc., Int. Conf. on Ground Improvement and Ground Control, B. Indraratna, C. Rujikiatkamjorn, and J. Vinod, eds., Vol. 2, Centre for Geomechanics and Railway Engineering, Univ. of Wollongong, Wollongong, Australia, 609–620.
EuroSoilStab. (2002). “Development of design and construction methods to stabilise soft organic soils: Design guide soft soil stabilisation.” CT97–0351, Project No. BE 96–3177, BREPress, Watford, U.K.
Filz, G. M., and Navin, M. P. (2006). “Stability of column-supported embankments.” Rep. No. VTRC 06-CR13, Virginia Transportation Research Council, Charlottesville, VA.
Horpibulsuk, S., Liu, M. D., Liyanapathirana, D. S., and Suebsuk, J. (2010). “Behaviour of cemented clay simulated via the theoretical framework of the Structured Cam Clay model.” Comput. Geotech., 37(1–2), 1–9.
Huang, J., and Han, J. (2009). “3D coupled mechanical and hydraulic modeling of a geosynthetic-reinforced deep mixed column-supported embankment.” J. Geotextile Geomembr., 27(4), 272–280.
Huang, J., Han, J., and Oztoprak, S. (2009). “Coupled mechanical and hydraulic modeling of geosynthetic-reinforced column-supported embankments.” J. Geotech. Geoenviron. Eng., 1011–1021.
Jiang, Y., Han, J., and Zheng, G. (2014). “Influence of column yielding on degree of consolidation of soft foundations improved by deep mixed columns.” Geomech. Eng., 6(2), 179–194.
Kelly, R., Pineda, J. A., and Mayne, P. (2013). “In-situ and laboratory testing of soft clays.” Aust. Geomech. J., 48(3), 61–72.
Kelly, R. B., and Wong, P. (2011). “Lessons learnt from design and construction of dry soil mix columns.” Proc., Int. Conf. on Advances in Geotechnical Engineering, M. Shahin and H. R. Nikraz, eds., Australian Geomechanics Society, Perth, Australia, 525–530.
Kim, Y. T., and Leroueil, S. (2001). “Modeling the viscoplastic behaviour of clays during consolidation: Application to Berthierville clay in both laboratory and field conditions.” Can. Geotech. J., 38(3), 484–497.
Lai, Y. P., Bergado, D. T., Lorenzo, G. A., and Duangchan, T. (2006). “Full-scale reinforced embankment on deep jet mixing improved ground.” Proc. Inst. Civ. Eng. Ground Improv., 10(4), 153–164.
Larsson, S. (2005). “State of practice report: Execution, monitoring and quality control.” Proc., Int. Conf. on Deep Mixing Best Practice and Recent Advances, Vol. 2, Swedish Deep Stabilization Research Centre, Linköping, Sweden, 732–786.
Lee, K., Chan, D., and Lam, K. (2004). “Constitutive model for cement treated clay in a critical state frame work.” Soils Found., 44(3), 69–77.
Liu, H. L., Ng, C. W. W., and Fei, K. (2007). “Performance of a geogrid-reinforced and pile-supported highway embankment over soft clay: Case study.” J. Geotech. Geoenviron. Eng., 1483–1493.
Liu, S.-Y., Du, Y.-J., Yi, Y.-L., and Puppala, A. J. (2012). “Field investigations on performance of T-shaped deep mixed soil cement column–supported embankments over soft ground.” J. Geotech. Geoenviron. Eng., 718–727.
Liyanapathirana, D. S., Carter, J. P., and Airey, D. W. (2005). “Numerical modeling of nonhomogeneous behavior of structured soils during triaxial tests.” Int. J. Geomech., 10–23.
Liyanapathirana, D. S., and Kelly, R. B. (2011). “Interpretation of the lime column penetration test.” Comput. Geotech., 38(1), 69–79.
Oztoprak, S., and Cinicioglu, S. F. (2005). “Soil behaviour through field instrumentation.” Can. Geotech. J., 42(2), 475–490.
Porbaha, A. (2002). “State of the art in quality assessment of deep mixing technology.” Proc. Inst. Civ. Eng. Ground Improv., 6(3), 95–120.
Porbaha, A., Shibuya, S., and Kishida, T. (2000). “State of the art in deep mixing technology. Part III: Geomaterial characterization.” Proc. Inst. Civ. Eng. Ground Improv., 4(3), 91–110.
Tavenas, F., and Leroueil, S. (1980). “The behaviour of embankments on clay foundations.” Can. Geotech. J., 17(2), 236–260.
Yapage, N. N. S., and Liyanapathirana, D. S. (2012). “Implementation of an elasto-plastic constitutive model for cemented clay in a non-linear finite element analysis.” Eng. Comput., 30(1), 74–96.
Yapage, N. N. S., Liyanapathirana, D. S., Poulos, H. G., Kelly, R. B., and Leo, C. J. (2013). “Numerical modeling of geotextile-reinforced embankments over deep cement mixed columns incorporating strain-softening behavior of columns.” Int. J. Geomech., 04014047.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jul 1, 2013
Accepted: Jul 1, 2014
Published online: Jul 29, 2014
Published in print: Nov 1, 2014
Discussion open until: Dec 29, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.