Overconsolidation and Stiffness of Venice Lagoon Sands and Silts from SDMT and CPTU
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 140, Issue 1
Abstract
This study is part of an extensive research program carried out at the Treporti test site (Venice, Italy), where a cylindrical trial embankment was constructed and monitored from the beginning of its construction until complete removal, 4 years later. This paper concentrates mainly on the evaluation of overconsolidation and stiffness of the Venice lagoon sands and silts. The possibility of estimating the overconsolidation ratio (OCR) in sand by the combined use of seismic dilatometer (SDMT) tests and piezocone (CPTU) tests is investigated. A tentative correlation for estimating the OCR in sand from the ratio is constructed. Field compression curves have been back-figured from 1-m field oedometer curves reconstructed from local vertical strains measured by a sliding deformeter under the embankment center. The SDMT and CPTU soundings performed before embankment application and postremoval have permitted analyzing how the OCR caused by the embankment was reflected by the before/after SDMT and CPTU results. The paper also illustrates the possible use of the SDMT to assess the in situ decay of stiffness with the strain level, by comparison with the stiffness decay curves of the elements on the centerline back-figured from the observed embankment behavior under increasing loading.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors wish to extend special thanks to the Consorzio Venezia Nuova and the Magistrato alle Acque, Venezia.
References
Baldi, G., Bellotti, R., Ghionna, V. N., Jamiolkowski, M., and Lo Presti, D. C. F. (1989). “Modulus of sands from CPT’s and DMT’s.” Proc., 12th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 1, Balkema, Rotterdam, Netherlands, 165–170.
Cola, S., and Simonini, P. (1999). “Some remarks on the behavior of Venetian silts.” Proc., 2nd Int. Symp. on Pre-Failure Behaviour of Geomaterials, Balkema, Rotterdam, Netherlands, 167–174.
Cola, S., and Simonini, P. (2002). “Mechanical behaviour of silty soils of the Venice lagoon as a function of their grading properties.” Can. Geotech. J., 39(4), 879–893.
Devincenzi, M. J., and Canicio, M. (2001). “Geotechnical characterization by in situ tests of a loess-like deposit in its natural state and after saturation.” Proc., Int. Conf. on In Situ Measurement of Soil Properties and Case Histories, P. P. Rahardjo and T. Lunne, eds., Graduate Program, Parahyangan Catholic Univ., Bandung, Indonesia, 159–166.
Gottardi, G., and Tonni, L. (2004). “Use of piezocone tests to characterize the silty soils of the Venetian lagoon (Treporti Test Site).” Proc., 2nd Int. Conf. on Site Characterization (ISC’2), Vol. 2, A. Viana da Fonseca and P. W. Mayne, eds., Millpress, Rotterdam, Netherlands, 1643–1649.
Ishihara, K. (2001). “Estimate of relative density from in-situ penetration tests.” Proc., Int. Conf. on In Situ Measurement of Soil Properties and Case Histories, P. P. Rahardjo and T. Lunne, eds., Graduate Program, Parahyangan Catholic Univ., Bandung, Indonesia, 17–26.
Jamiolkowski, M., Ghionna, V. N., Lancellotta, R., and Pasqualini, E. (1988). “New correlations of penetration tests for design practice.” Proc., 1st Int. Symp. on Penetration Testing (ISOPT-1), Vol. 1, Balkema, Rotterdam, Netherlands, 263–296.
Jendeby, L. (1992). “Deep compaction by vibrowing.” Proc., Nordic Geotechnical Meeting, Vol. 1, Danish Geotechnical Society, Lyngby, Denmark, 19–24.
Kovari, K., and Amstad, C. (1982). “A new method of measuring deformations in diaphragm walls and piles.” Geotechnique, 22(4), 402–406.
Lee, M. J., Choi, S. K., Kim, M. T., and Lee, W. (2011). “Effect of stress history on CPT and DMT results in sand.” Eng. Geol., 117(3-4), 259–265.
Marchetti, S. (1980). “In situ tests by flat dilatometer.” J. Geotech. Engrg. Div., 106(3), 299–321.
Marchetti, S. (1985). “On the field determination of in sand.” Proc., 11th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 5, Balkema, Rotterdam, Netherlands, 2667–2673.
Marchetti, S. (2010). “Sensitivity of CPT and DMT to stress history and aging in sands for liquefaction assessment.” Proc., 2nd Int. Symp. on Cone Penetration Testing (CPT’10), P. K. Robertson and P. W. Mayne, eds., Vol. 3, Paper No. 3-50. Omnipress, Madison, WI.
Marchetti, S., Monaco, P., Calabrese, M., and Totani, G. (2004). “DMT-predicted vs measured settlements under a full-scale instrumented embankment at Treporti (Venice, Italy).” Proc., 2nd Int. Conf. on Site Characterization (ISC’2), A. Viana da Fonseca and P. W. Mayne, eds., Vol. 2, Millpress, Rotterdam, Netherlands, 1511–1518.
Marchetti, S., Monaco, P., Calabrese, M., and Totani, G. (2006). “Comparison of moduli determined by DMT and backfigured from local strain measurements under a 40 m diameter circular test load in the Venice area.” Proc., 2nd Int. Conf. on the Flat Dilatometer, R. A. Failmezger and J. B. Anderson, eds., In-Situ Soil Testing, Lancaster, VA, 220–230.
Marchetti, S., Monaco, P., Totani, G., and Calabrese, M. (2001). “The flat dilatometer test (DMT) in soil investigations—A report by the ISSMGE Committee TC16.” Proc., 2nd Int. Conf. on the Flat Dilatometer, R. A. Failmezger and J. B. Anderson, eds., In-Situ Soil Testing, Lancaster, VA, 7–48.
Marchetti, S., Monaco, P., Totani, G., and Marchetti, D. (2008). “In situ tests by seismic dilatometer (SDMT).” From research to practice in geotechnical engineering, J. E. Laier, D. K. Crapps, and M. H. Hussein, eds., ASCE, Reston, VA, 292–311.
Mayne, P. W. (1991). “Tentative method for estimating from data in sands.” Proc., 1st Int. Symp. on Calibration Chamber Testing, A. B. Huang, ed., Elsevier, Potsdam, NY, 249–256.
Mayne, P. W. (2001). “Stress-strain-strength-flow parameters from enhanced in-situ tests.” Proc., Int. Conf. on In Situ Measurement of Soil Properties and Case Histories, P. P. Rahardjo and T. Lunne, eds., Graduate Program, Parahyangan Catholic Univ., Bandung, Indonesia, 27–47.
Mayne, P. W., Coop, M. R., Springmanm, S. M., Huang, A., and Zornberg, J. G. (2009). “Geomaterial behavior and testing.” Proc., 17th Int. Conf. on Soil Mechanics and Geotechnical Engineering, M. Hamza, M. Shahien, and Y. El-Mossallamy, eds., Vol. 4, IOS Press, Rotterdam, Netherlands, 2777–2872.
McGillivray, A., and Mayne, P. W. (2004). “Seismic piezocone and seismic flat dilatometer tests at Treporti.” Proc., 2nd Int. Conf. on Site Characterization (ISC’2), Vol. 2, A. Viana da Fonseca and P. W. Mayne, eds., Millpress, Rotterdam, Netherlands, 1695–1700.
Monaco, P., Marchetti, S., Totani, G., and Marchetti, D. (2009). “Interrelationship between small strain modulus and operative modulus.” Proc., Int. Conf. on Performance-Based Design in Earthquake Geotechnical Engineering, T. Kokusho, Y. Tsukamoto, and M. Yoshimine, eds., Taylor & Francis Group, London, 1315–1323.
Monaco, P., Totani, G., and Calabrese, M. (2006). “DMT-predicted vs observed settlements: a review of the available experience.” Proc., 2nd Int. Conf. on the Flat Dilatometer, R. A. Failmezger and J. B. Anderson, eds., In-Situ Soil Testing, Lancaster, VA, 244–252.
Schmertmann, J. H. (1983). “Revised procedure for calculating and OCR from DMT’s with and which incorporates the penetration force measurement to permit calculating the plane strain friction angle.” DMT Digest No. 1, GPE Inc., Gainesville, FL.
Simonini, P. (2004). “Characterization of the Venice lagoon silts from in-situ tests and the performance of a test embankment.” Proc., 2nd Int. Conf. on Site Characterization (ISC’2), Vol. 1, A. Viana da Fonseca and P. W. Mayne, eds., Millpress, Rotterdam, Netherlands, 187–207.
Simonini, P., Ricceri, G., and Cola, S. (2007). “Geotechnical characterization and properties of Venice lagoon heterogeneus silts.” Proc., 2nd Int. Workshop on Characterization and Engineering Properties of Natural Soils, Vol. 4, T. S. Tan, K. K. Phoon, D. W. Hight, and S. Leroueil, eds., Taylor & Francis Group, London, 2289–2328.
Tonni, L., and Gottardi, G. (2011). “Analysis and interpretation of piezocone data on the silty soils of the Venetian lagoon (Treporti test site).” Can. Geotech. J., 48(4), 616–633.
Tonni, L., Gottardi, G., Berengo, V., and Simonini, P. (2010). “Classification, overconsolidation and stiffness of Venice lagoon soils from CPTU.” Proc., 2nd Int. Symp. on Cone Penetration Testing (CPT’10), P. K. Robertson and P. W. Mayne, eds., Vol. 2, Omnipress, Madison, WI.
Yamashita, S., Jamiolkowski, M., and Lo Presti, D. (2000). “Stiffness nonlinearity of three sands.” J. Geotech. Geoenviron. Eng., 126(10), 929–938.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jun 27, 2012
Accepted: May 10, 2013
Published online: May 14, 2013
Published in print: Jan 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.