Database of Friction Angles of Sand and Consolidation Characteristics of Sand, Silt, and Clay
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 139, Issue 7
Abstract
The paper presents diagrams of the (1) drained and undrained effective stress friction angles of sand; (2) dilatancy angle of sand; (3) parameters in a nonlinear constrained modulus expression for virgin loading, unloading, and reloading on sand and silt; and (4) diagrams with the coefficient of permeability for sand, silt, and clay. The database parameters are suitable for preliminary assessments or applications when assumed parameters are acceptable. The database can also be helpful in planning and interpreting site-specific tests and in reducing the number of site-specific tests. For important projects the parameters should be determined by site-specific tests.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work to establish the diagrams in this paper is funded by the Research Council of Norway. The data used are based on information from research projects sponsored by the Research Council of Norway, joint industry sponsored projects, and consulting projects. Dr. Hans Petter Jostad and numerous other NGI colleagues have contributed to the results. This cooperation is greatly appreciated.
References
Andersen, K. H. (2009). “Bearing capacity under cyclic loading—Offshore, along the coast, and on land. The 21st Bjerrum Lecture presented in Oslo, 23 November 2007.” Can. Geotech. J., 46(5), 513–535.
Andersen, K. H., Lunne, T., Kvalstad, T. J., and Forsberg, C. F. (2008). ”Deep water geotechnical engineering.” Proc., XXIV Mexican Society Conf. on Soil Mechanics, Vol. IV, Sociedad Mexicana de Mecánica de Suelos, Mexico City.
Bjerrum, L. (1973). “Problems of soil mechanics and construction on soft clays and structurally unstable soils.” Proc., 8th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 3, 111–159, USSR National Society for Soil Mechanics and Foundation Engineering, Moscow.
Bolton, M. D. (1986). “The shear strength and dilatancy of sands.” Geotechnique, 36(1), 65–78.
British Standards Institute (BSI). (1990). “Methods of tests for soils for civil engineering purposes.” BS 1377, London.
Carrier, D. W. (2003). “Goodbye, Hazen; hello, Kozeny-Carman.” J. Geotech. Geoenviron. Eng., 129(11), 1054–1056.
Hardin, B. O., and Drnevich, V. P. (1972). “Shear modulus and damping in soils: Design equations and curves.” J. Soil Mech. and Found. Div., 98(7), 653–665.
Hazen, A. (1920). “Hydraulic-fill dams.” Trans. Am. Soc. Civ. Eng., 83(1), 1713–1745.
Janbu, N. (1963). “Soil compressibility as determined by oedometer and triaxial tests.” Proc., European Conf. on Soil Mechanics and Foundation Engineering, Vol. I, Deutsche Gesellschaft fuür Erd- und Grundbau e.V, Essen, Germany.
Kenney, T., Lau, D., and Ofoegbu, G. I. (1984). “Permeability of compacted granular material.” Can. Geotech. J., 21(4), 726–729.
Kjærnsli, B., Valstad, T., and Hoeg, K. (1992). Rockfill dams. Design and constructions, Tapir, Trondheim, Norway.
Ladd, C. C., Foot, R., Ishihara, K., Schlosser, F., and Poulos, H. G. (1977). “Stress deformation and strength characteristics.” Proc., 9th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 2, 421–494, Japanese Society of Soil Mechanics and Foundation Engineering, Tokyo.
Lambe, T. W., and Whitman, R. V. (1969). Soils mechanics, Wiley, New York.
Louden, A. G. (1952). “The computation of permeability from simple soil tests.” Geotechnique, 3(4), 165–183.
Lunne, T., and Andersen, K. H. (2007). “Soft clay shear strength parameters for deepwater geotechnical design.” Proc., 6th Int. Offshore Site Investigation and Geotechnics Conf. on Confronting New Challenges and Sharing Knowledge, 151–176. Society for Underwater Technology, London.
Mansur, C. I., and Kaufman, R. I. (1962). “Dewatering.” Foundation engineering, G. A. Leonards, ed., McGraw Hill, New York, 241–350.
Schmertmann, J. H. (1978). “Guidelines for cone penetration tests. Performance and Design.” FHWA-TS-78-209, U.S. Dept. of Transportation, Federal Highway Administration, Washington, DC.
Terzaghi, K., Peck, R. B., and Mesri, G. (1996). Soil mechanics in engineering practice, 3rd Ed., Wiley, New York.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jul 7, 2011
Accepted: Sep 17, 2012
Published online: Sep 19, 2012
Published in print: Jul 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.