Bootstrapping for Characterizing the Effect of Uncertainty in Sample Statistics for Braced Excavations
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 139, Issue 1
Abstract
A simple procedure for assessing the probability of serviceability failure in a braced excavation involving bootstrapping to characterize the effect of uncertainty in sample statistics is presented. Here, the failure is defined when an excavation system’s response in terms of the maximum wall deflection or ground settlement that exceeds the limiting value specified by the client or in an applicable code. The analysis for the probability of failure (or probability of exceedance) necessitates an evaluation of the means and SDs of critical soil parameters. In geotechnical practice, these means and SDs are often estimated from a very limited data set, which can lead to uncertainty in the derived sample statistics. Thus, in this study bootstrapping is used to characterize the uncertainty or variation of sample statistics and its effect on the failure probability. Through the bootstrapping analysis, the probability of exceedance can be presented as a confidence interval instead of a single, fixed probability. The information gained should enable the engineer to make a more rational assessment of the risk of serviceability failure in a braced excavation. The study points to the potential of the bootstrap method in coping with the problem of having to evaluate failure probability with uncertain sample statistics.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adèr, H. J., Mellenbergh, G. J., and Hand, D. J. (2008). Advising on research methods: A consultant’s companion, Johannes van Kessel, Huizen, Netherlands.
Ang, A. H.-S., and De Leon, D. (2005). “Modeling and analysis of uncertainties for risk-informed decisions in infrastructures engineering.” Struct. Infrastruct. Eng., 1(1), 19–31.
Ang, A. H.-S., and Tang, W. H. (2007). Probability concepts in engineering, 2nd Ed., Wiley, New York.
Christian, J. T., and Baecher, G. B. (1999). “Point estimate method as numerical quadrature.” J. Geotech. Geoenviron. Eng., 125(9), 779–786.
Clough, G. W., and O’Rourke, T. D. (1990). “Construction induced movements of in situ walls.”, Geotechnical Special Publication.” Proc., Design and Performance of Earth Retaining Structure, Vol. 25, ASCE, New York, 439–470.
Corder, G. W., and Foreman, D. I. (2009). Nonparametric statistics for non-statisticians: A step-by-step approach, Wiley, Hoboken, NJ.
Ditlevsen, O., and Madsen, H. (1996). Structural reliability methods, Wiley, New York.
Efron, B. (1979). “Bootstrap methods: Another look at the jackknife.” Ann. Stat., 7(1), 1–26.
Efron, B., and Tibshirani, R. J. (1993). An introduction to the bootstrap, Monographs on statistics and applied probability, Vol. 57, Chapman & Hall, New York.
Fenton, G. A., and Griffiths, D. V. (2008). Risk assessment in geotechnical engineering, Wiley, New York.
Harr, M. E. (1987). Probability-based design in civil engineering, Dover, Mineola, NY.
Hsiao, E. C. L., Schuster, M., Juang, C. H., and Kung, T. C. (2008). “Reliability analysis of excavation-induced ground settlement for building serviceability evaluation.” J. Geotech. Geoenviron. Eng., 134(10), 1448–1458.
Johnson, R. W. (2001). “An introduction to the bootstrap.” Teach. Stat., 23(2), 49–54.
Kung, T. C. (2003). “Surface settlement induced by excavation with consideration of small strain behavior of Taipei silty clay.” Ph.D. thesis, Dept. of Construction Engineering, National Taiwan Univ. of Science and Technology, Taipei, Taiwan.
Kung, T. C., Juang, C. H., Hsiao, C. L., and Hashash, Y. (2007). “Simplified model for wall deflection and ground surface settlement caused by braced excavation in clays.” J. Geotech. Geoenviron. Eng., 133(6), 731–747.
Möller, B., and Beer, M. (2004). Fuzzy randomness—Uncertainty in civil engineering and computational mechanics, Springer, New York.
Most, T. (2011). “Efficient structural reliability methods considering incomplete knowledge of random variable distributions.” Probab. Eng. Mech., 26(2), 380–386.
Most, T., and Knabe, T. (2010). “Reliability analysis of bearing failure problem considering uncertain stochastic parameters.” Comput. Geotech., 37(3), 299–310.
Ou, C. Y. (2006). Deep excavation—Theory and practice, Taylor & Francis, London.
Ou, C. Y., Liao, J. T., and Lin, H. D. (1998). “Performance of diaphragm wall constructed using top-down method.” J. Geotech. Geoenviron. Eng., 124(9), 798–808.
Phoon, K.-K., and Kulhawy, F. H. (1999). “Evaluation of geotechnical property variability.” Can. Geotech. J., 36(4), 625–639.
Professional Standards Compilation Group (PSCG). (2000). Specification for excavation in Shanghai metro construction, PSCG, Shanghai, China (in Chinese).
Quenouille, M. H. (1956). “Notes on bias in estimation.” Biometrika, 43(3–4), 353–360.
Rosenblueth, E. (1975). “Point estimates for probability moments.” Proc. Natl. Acad. Sci. U.S.A., 72(10), 3812–3814.
Schweiger, H. F., and Peschl, G. M. (2005). “Reliability analysis in geotechnics with the random set finite method.” Comput. Geotech., 32(6), 422–435.
Wisz, M. S., Hijmans, R. J., Li, J., Peterson, A. T., Graham, C. H., and Guisan, A. (2008). “Effects of sample size on the performance of species distribution models.” Divers. Distrib., 14(5), 763–773.
Yen, D. L., and Chang, G. S. (1991). “A study of allowable settlement of buildings.” Sino-Geotech., 22, 5–27.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 139 • Issue 1 • January 2013
Pages: 13 - 23
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Aug 17, 2011
Accepted: Mar 19, 2012
Published online: Mar 21, 2012
Published in print: Jan 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.