Effects of Waste Composition and Decomposition on the Shear Strength of Municipal Solid Waste
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 138, Issue 10
Abstract
The objective of this study was to evaluate the effects of waste composition and decomposition on the shear strength of municipal solid waste. Waste was collected from two sources (an operating landfill and a transfer station) and degraded in laboratory anaerobic reactors to prepare wastes with different degrees of decomposition. Shear strength was measured in a 280-mm-diameter direct shear ring on nine wastes with normal stress ranging between 12 and 90 kPa. The Mohr-Coulomb failure criterion was used to determine shear strength parameters ( = friction angle and = cohesion intercept) of the wastes, and shear strength was selected at a horizontal displacement of 56 mm (i.e., 20% of the specimen diameter). A composite failure envelope regressed through shear strength versus normal stress data from all wastes was statistically significant, with and . A comparison between tests conducted in this study and in the literature indicates that larger are obtained for waste with a greater fraction of soil-like, gravel, and inert constituents, whereas lower are coincident with higher fractions of paper and cardboard or plastic. This effect of waste composition on is applicable when fibrous particles are primarily parallel with the shear plane, which is the common particle orientation in direct shear. Tests conducted in this study also indicate increases with decreasing volatile solids or the ratio of cellulose + hemicellulose to lignin (i.e., increasing decomposition). Contrasting correlations have been reported in the literature, attributed to the initial waste composition, which influences the effect of decomposition on . No correspondence was found between and waste composition or the degree of waste decomposition.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Financial support for this study was provided by the University of Wisconsin–North Carolina State University bioreactor partnership (www.bioreactorpartnership.org), which was sponsored by the U.S. National Science Foundation (Grant No. EEC-0538500) and a consortium of industry partners (CH2Mhill, Geosyntec Consultants, Republic Services, Veolia Environmental Services, Waste Connections Inc., and Waste Management) through the National Science Foundation’s Partnerships for Innovation Program. Additional thanks are extended to Nima Sefidmazgi for assistance with the direct shear tests.
References
ASTM. (2007). “Standard test method for laboratory compaction characteristics of soil using modified effort.” D1557, West Conshohocken, PA.
Bareither, C. A. (2010). “Compression behavior of solid waste.” Ph.D. dissertation, Univ. of Wisconsin–Madison, Madison, WI.
Bareither, C. A., Benson, C. H., Barlaz, M. A., and Edil, T. B. (2012a). “Abiotic and biotic mechanisms of municipal solid waste settlement.” J. Geotech. Geoenviron. Eng., in press.
Bareither, C. A., Benson, C. H., and Edil, T. B. (2012b). “Compression behavior of municipal solid waste: Immediate compression.” J. Geotech. Geoenviron. Eng., in press.
Bareither, C. A., Breitmeyer, R. J., Benson, C. H., Barlaz, M. A., and Edil, T. B. (2012c). “Deer track bioreactor experiment: A field-scale evaluation of municipal solid waste bioreactor performance.” J. Geotech. Geoenviron. Eng., 138(6), 658–670.
Bareither, C. A., Breitmeyer, R. J., Meyer, L. L., Benson, C. H., Edil, T. B., and Barlaz, M. A. (2010). “Physical, chemical, and biological characterization of solid waste samples.” Proc., 2nd Global Waste Management Symp. Penton Media, New York, 1–9.
Bareither, C. A., Edil, T. B., Benson, C. H., and Mickelson, D. M. (2008). “Geological and physical factors affecting the friction angle of compacted sands.” J. Geotech. Geoenviron. Eng., 134(10), 1476–1489.
Barlaz, M. A. (1997). Microbial studies of landfills and anaerobic refuse decomposition, manual for environmental microbiology, American Society of Microbiology, Washington, DC, 541–557.
Benson, C. H., and Khire, M. V. (1994). “Reinforcing sand with strips of reclaimed high-density polyethylene.” J. Geotech. Eng., 120(5), 838–855.
Borgatto, A. V. A., Mahler, C. F., and Izzo, R. L. S. (2009). “Influence of soft plastic on MSW geomechanical behaviour.” 3rd Int. Workshop on Hydro-Physico-Mechanics of Landfills, Braunschweig, Germany, 1–10.
Bray, J. D., Zekkos, D., Kavazanjian, E., Jr., Athanasopoulos, G. A., and Riemer, M. F. (2009). “Shear strength of municipal solid waste.” J. Geotech. Geoenviron. Eng., 135(6), 709–722.
Colberg, P. J. (1988). “Anaerobic microbial degradation of cellulose, lignin, oligolignols, and monoaromatic lignin derivatives.” Biology of anaerobic microorganisms, A. J. B. Zehnder, ed., Wiley-Liss, New York, 333–372.
Dixon, N., Langer, U., and Gotteland, P. (2008). “Classification and mechanical behavior relationships for municipal solid waste: Study using synthetic wastes.” J. Geotech. Geoenviron. Eng., 134(1), 79–90.
Edincliler, A., Benson, C. H., and Edil, T. B. (1996). “Shear strength of municipal solid waste, Interim Report—Year 1.” Environmental Geotechnics Report 96-2, Dept. of Civil and Environmental Engineering, Univ. of Wisconsin-Madison, Madison, WI.
Eid, H. T., Stark, T. D., Douglas, W. D., and Sherry, P. E. (2000). “Municipal solid waste slope failure. I: Waste and foundation properties.” J. Geotech. Geoenviron. Eng., 126(5), 397–407.
Eleazer, W. E., Odle, W. S., Wang, Y.-S., and Barlaz, M. A. (1997). “Biodegradability of municipal solid waste components in laboratory-scale landfills.” Environ. Sci. Technol., 31(3), 911–917.
Gabr, M. A., Hossain, M. S., and Barlaz, M. A. (2007). “Shear strength parameters of municipal solid waste with leachate recirculation.” J. Geotech. Geoenviron. Eng., 133(4), 478–484.
Gabr, M. A., and Valero, S. N. (1995). “Geotechnical properties of municipal solid waste.” Geotechnical Testing J., 18(2), 241–251.
Hanson, J. L., Yesiller, N., Von Stockhausen, S. A., and Wong, W. A. (2010). “Compaction characteristics of municipal solid waste.” J. Geotech. Geoenviron. Eng., 136(8), 1095–1102.
Haque, M. A. (2007). “Dynamic characteristics and stability analyses of municipal solid waste in bioreactor landfills.” Ph.D. dissertation, Univ. of Texas at Arlington, Arlington, TX.
Harris, J. M., Shafer, A. L., DeGroff, W., Hater, G. R., Gabr, M., and Barlaz, M. A. (2006). “Shear strength of degraded reconstituted municipal solid waste.” Geotechnical Testing J., 29(2), 141–148.
Hossain, M. D. S., and Haque, M. A. (2009). “The effects of daily cover soils on shear strength of municipal solid waste in bioreactor landfills.” Waste Manag., 29(5), 1568–1576.
Hull, R. M., Krogmann, U., and Strom, P. F. (2005). “Composition and characteristics of excavation materials from a New Jersey landfill.” J. Environ. Eng., 131(3), 478–490.
Kavazanjian, E., Jr. (2001). “Mechanical properties of municipal solid waste.” Proc., Sardinia 2001, 8th Int. Waste Management and Landfill Symp., CISA, Environmental Sanitary Engineering Centre, Cagliari, Italy, 415–424.
Kavazanjian, E., Jr., Matasovic, N., and Bachus, R. C. (1999). “Large-diameter static and cyclic laboratory testing of municipal solid waste.” Proc., 7th Int. Waste Management and Landfill Symp., CISA, Environmental Sanitary Engineering Centre, Cagliari, Italy, 437–444.
Kavazanjian, E., Matasovic, N., Bonaparte, R., and Schmertmann, G. R. (1995). “Evaluation of MSW properties for seismic analysis,” Proc., Geoenvironment 2000, Geotechnical Special Publication No. 46, Vol. 2, ASCE, New York, 1126–1141.
Landva, A. O., and Clark, J. I. (1990). “Geotechnics of waste fill. Theory and practice.” Special Technical Publication No. 1070, A. Landva and G. O. Knowles, eds., ASTM, Philadelphia, PA, 86–103.
Langer, U. (2005). “Shear and compression behaviour of undegraded municipal solid waste.” Ph.D. dissertation, Loughborough Univ., Leicestershire, U.K.
Matasovic, N., and Kavazanjian, E., Jr. (1998). “Cyclic characterization of OII landfill solid waste.” J. Geotech. Geoenviron. Eng., 124(3), 197–210.
Mehta, R., Barlaz, M. A., Yazdani, R., Augenstein, D., Bryars, M., and Sinderson, L. (2002). “Refuse decomposition in the presence and absence of leachate recirculation.” J. Environ. Eng., 128(3), 228–236.
Owens, J. M., and Chynoweth, D. P. (1993). “Biochemical methane potential of municipal solid waste (MSW) components.” Water Sci. Technol., 27(2), 1–14.
Pelkey, S. A., Valsangkar, A. J., and Landva, A. (2001). “Shear displacement dependent strength of municipal solid waste and its major constituents.” Geotechnical Testing J., 24(4), 381–390.
Reddy, K. R., Gangathulasi, J., Parakalla, N. S., Hettiarachchi, H., Bogner, J., and Lagier, T. (2009b). “Compressibility and shear strength of municipal solid waste under short-term leachate recirculation operations.” Waste Manag. Res., 27(6), 578–587.
Reddy, K. R., Hettiarachchi, H., Gangathulasi, J., Bogner, J. E., and Lagier, T. (2009c). “Geotechnical properties of synthetic municipal solid waste.” Int. J. Geotech. Eng., 3(3), 429–438.
Reddy, K. R., Hettiarachchi, H., Parakalla, N. S., Gangathulasi, J., and Bogner, J. E. (2009a). “Geotechnical properties of fresh municipal solid waste at Orchard Hills landfill, USA.” Waste Manag., 29(2), 952–959.
Sadek, S., El-Fadel, M., Manasseh, C., and Abou-Ibrahim, A. (1999). “Geotechnical properties of decomposed solid waste materials.” Proc., Int. Conf. on Solid Waste Technology and Management, Widener Univ., School of Engineering, Chester, PA, 350–357.
Singh, M. K., Sharma, J. S., and Fleming, I. R. (2009). “Shear strength testing of intact and recompacted samples of municipal solid waste.” Can. Geotech. J., 46(10), 1133–1145.
Staley, B. F., and Barlaz, M. A. (2009). “Composition of municipal solid waste in the U.S. and implications for carbon sequestration and methane yield.” J. Environ. Eng., 135(10), 901–909.
Stark, T. D., Huvaj-Sarihan, N., and Li, G. (2009). “Shear strength of municipal solid waste for stability analyses.” Environ. Geol., 57(8), 1911–1923.
Thomas, S., et al. (1999). “An in-situ waste mechanical experiment on a French landfill.” Proc., Sardina 99’, 7th Int. Waste Management and Landfill Symp., CISA, Environmental Sanitary Engineering Centre, Cagliari, Italy, 445–452.
USEPA. (2008). Municipal solid waste generation, recycling, and disposal in the United States: Facts and figures for 2008, U.S. Environmental Protection Agency, Washington, DC.
Van Impe, W. F. (1998). “Environmental geotechnics: ITC 5 activities. State of the art.” Proc., 3rd Int. Congress on Environmental Geotechnics, Balkema, Rotterdam, Netherlands, 1163–1187.
Vilar, O. M., and Carvalho, M. F. (2004). “Mechanical properties of municipal solid waste.” J. Test. Eval., 32(6), 438–449.
Zhan, T. L. T., Chen, Y. M., and Ling, W. A. (2008). “Shear strength characterization of municipal solid waste at the Suzhou landfill, China.” Eng. Geol., 97(3–4), 97–111.
Zekkos, D., et al. (2006). “Unit weight of municipal solid waste.” J. Geotech. Geoenviron. Eng., 132(10), 1250–1261.
Zekkos, D., Athanasopoulos, G. A., Bray, J. D., Grizi, A., and Theodoratos, A. (2010). “Large-scale direct shear testing of municipal solid waste.” Waste Manag., 30(8–9), 1544–1555.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Jul 20, 2011
Accepted: Jan 25, 2012
Published online: Jan 28, 2012
Published in print: Oct 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.