Quality Assessment and Quality Control of Deep Soil Mixing Construction for Stabilizing Expansive Subsoils
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 136, Issue 1
Abstract
This paper presents the process and results of a quality management program performed during and immediately after the construction of two deep soil mixing (DSM) test sections. The quality management program consisted of laboratory, in situ, and mineralogical tests to address the effectiveness of the treatment during and after construction. In situ investigations including the down-hole seismic and spectral analysis of surface waves (SASW) test methods were performed to evaluate the degree of improvement achieved through the measurement of compression and shear-wave velocities of the columns and surrounding soils. Scanning electron microscopy and electron dispersive x-ray analysis were performed on raw, laboratory treated and field-treated specimens for qualitative understanding of the degree of mixing achieved in the field and the compounds formed at particle level during stabilization, respectively. Laboratory tests results on field cores indicated that both field stiffness and strength are about 20 to 40% less than the corresponding laboratory prepared soil samples. The down-hole seismic and SASW tests showed considerable improvement in stiffness in and around the DSM columns. Mineralogical studies indicated the formation of silica and alumina hydrates along with interwoven structure of lime-cement treated clay particles in both laboratory and field specimens, suggesting adequate mixing of the soil and binder in both environments.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This project was conducted in cooperation with Texas Department of Transportation (TxDOT) and Federal Highway Administration (FHWA). The writers acknowledge Mr. David Head, P.E.; Mr. Richard Williammee, P.E., Project Director; Dr. German Claros, P.E.; Mr. Stanley Yin, P.E.; and Dr. Zhiming Si, P.E., TxDOT for their support of this study. The writers acknowledge the assistance of the TxDOT Fort Worth District personnel for their help in the construction of test sections. Writers thank Mr. Christopher Shirey and Mr. Benjamin Anderson for their assistance during field monitoring and data collection.
References
Ahnberg, H., Holm, G., Holmqvist, L., and Ljungcrantz, C. (1994). “The use of different additives in deep stabilization of soft soils.” Proc. Int. Conf. Soil Mech. Found. Eng., 13(3), 1191–1194.
Al-Tabba, A., Ayotamuno, M. J., and Martin, R. J. (1999). “Soil mixing of stratified contaminated sands.” J. Hazard. Mater., 71(1), 53–75.
Babasaki, R. M., Terashi, T., Suzuki, A., Maekaea, M., Kawamura, E., and Fukazawa, E. (1996). “JGS TC report: Factors influencing the strength of improved soil.” Proc., 2nd Int. Conf. on Ground Improvement Geosystems, Grouting and Deep Mixing, Vol. 2, Balkema, Tokyo, 913–918.
Bergado, D. T., and Lorenzo, G. A. (2005). “Economical mixing method for cement deep mixing.” Geo-Frontiers 2005, 130–142, 1787–1796.
Bhadriraju, V., Puppala, A. J., Madhyannapu, R. S., and Williammee, R. (2008). “Laboratory procedure to obtain well-mixed soil binder samples of medium stiff to stiff expansive clayey soil for deep soil mixing simulation.” Geotech. Test. J., 31(3), 225–238.
Bruce, D. (2001). “An introduction to the deep mixing methods as used in geotechnical applications, volume 3, the verification and properties of treated ground.” Rep. No. FHWA-RD-99-167, U.S. Department of Transportation, Federal Highway Administration, Washington, D.C.
Coastal Development Institute of Technology (CDIT). (2002). The deep mixing method-principle, design and construction, Balkema, Rotterdam, The Netherlands.
Enami, A., and Hibino, S. (1991). “Improvement of foundation ground using a deep mixing blender with free blades.” J. Japanese Soc. Soil Mech. Found. Eng., 39(10), 37–42.
EuroSoilStab. (2002). “Development of design and construction methods to stabilize soft organic soils: Design guide soft soil stabilization.” CT97-0351, European Project No.: BE 96-3177.
Hird, C. C., and Chan, C. M. (2005). “Correlation of shear wave velocity with unconfined compressive strength of cement-stabilized clay.” Proc., Int. Conf. on Deep Mixing Best Practice and Recent Advances, Swedish Deep Stabilization Research Centre, Stockholm, Sweden, 79–85.
Jacobson, J. R., Filz, G. M., and Mitchell, J. K. (2003). “Factors affecting strength gain in lime-cement columns and development of a laboratory testing procedure.” Report No. VTRC 03-CR16, Virginia Transportation Research Council, Charlottesville, Va.
Lorenzo, G. A., and Bergado, D. T. (2004). “Fundamental parameters of cement admixed clay–New approach.” JGGE, 130(10), 1042–1050.
Madhyannapu, R. S. (2007). “Deep mixing technology for mitigation of swell-shrink behavior of expansive soils of moderate to deep active depths.” Ph.D. thesis, Univ. of Texas at Arlington, Arlington, Tex.
Mattson, H., Larsson, R., Holm, G., Dannewitz, N., and Eriksson, H. (2005). “Downhole technique improves quality control on dry mix columns.” Proc., Int. Conf. on Deep Mixing Best Practice and Recent Advances, Swedish Deep Stabilization Research Centre, Stockholm, Sweden, 581–592.
Miura, N., Bergado, D. T., Sakai, A., and Nakamura, R. (1987). “Improvements of soft marine clays by special admixtures using dry and wet jet mixing methods.” Proc., 9th Southeast Asian Geotechnical Conf., Bangkok, Thailand, 8–35.
Nazarian, S., and Stokoe, K. H. II. (1986). “In situ determination of elastic moduli of pavement systems by spectral-analysis-of-surface-waves method.” Rep. No. 1123-1, Center for Transportation Research, Univ. of Texas at Austin, Austin, Tex., 161.
Nazarian, S., Yuan, D., and Baker, M. R. (1994). “Automation of spectral analysis surface waves method.” Proc., Symp. on Dynamic Geotechnical Testing II, R. J. Ebelhar, V. P. Drnevich, and B. L. Kutter, eds., ASTM Special Technical Publication, No. 1213, Philadelphia, 88–100.
Pathivada, S. (2005). “Effects of water-cement ratio on deep mixing treated expansive clay characteristics.” MS thesis, Univ. of Texas at Arlington, Arlington, Tex.
Porbaha, A. (1998). “State-of-the-art in deep mixing technology. Part I: Basic concepts and overview of technology.” Ground Improv., 2(2), 81–92.
Porbaha, A. (2002). “State of the art in quality assessment of deep mixing technology.” Ground Improv., 6(3), 95–120.
Puppala, A. J., Bhadriraju, V., and Porbaha, A. (2005). “Quality assurance practices and protocols for in-situ testing of deep mixed columns.” Proc., Int. Conf. on Deep Mixing: Best Practice And Recent Advances, Swedish Deep Stabilization Research Centre, Stockholm, Sweden, 613–619.
Puppala, A. J., and Porbaha, A. (2004). International perspectives on quality assessment of deep mixing. Drilled shafts, micropiling, deep mixing, remedial methods, and specialty foundation systems, geo-support 2004, J. P. Turner and P. W. Mayne, eds., ASCE, Orlando, GSP No. 124.
Rathmayer, H. (1996). “Deep mixing methods for soft subsoil improvement in the Nordic Countries.” Proc., 2nd Int. Conf. on Ground Improvement Geosystems, IS-Tokyo ’96, Balkema, Rotterdam, The Netherlands, 869–878.
Shen, S. L., Miura, N., and Koga, H. (2003). “Interaction mechanism between deep mixing column and surrounding clay during installation.” Can. Geotech. J., 40, 293–307.
Taki, O., and Yang, D. S. (1991). “Soil-cement mixed wall technique.” Geotechnical Engineering Congress, ASCE, Reston, Va., 298–309.
Terashi, M. (2003). “The state of practice in deep mixing method.” Grouting and ground treatment, Vol. 1, L. F. Johnsen, D. A. Bruce, and M. J. Byle, eds., ASCE, Reston, Va., 25–49.
Usui, H. (2005). “Quality control of cement deep mixing method (wet mixing method) in Japan.” Proc., Int. Conf. on Deep Mixing Best Practice and Recent Advances, Swedish Deep Stabilization Research Centre, Stockholm, Sweden, 635–638.
Van Impe, W. F., Verástegui Flores, R. D., Mengé, P., and Van den Broeck, M. (2005). “Considerations on laboratory test results of cement stabilised sludge.” Proc., Deep Mixing 05, Int. Conf. on Deep Mixing Best Practice and Advances, Swedish Deep Stabilization Research Centre, Stockholm, Sweden, 163–168.
Yuan, D., and Nazarian, S. (1993). “Automated surface wave method: Inversion process.” J. Geotech. Engrg., 119(7), 1112–1126.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Nov 17, 2008
Accepted: Jun 23, 2009
Published online: Jul 1, 2009
Published in print: Jan 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.