Stability Analyses and Charts for Undrained Slopes with Linearly Increasing Strength and an External Water Surface
Publication: International Journal of Geomechanics
Volume 22, Issue 8
Abstract
This paper will present stability analyses and charts to estimate the factor of safety (FS) for partially submerged undrained slopes with linearly increasing strength with depth and unlimited foundation depth. The problem has been tackled previously by ignoring the free standing water when the soil below and above the external water level, buoyant (γ′), and saturated unit weight (γsat), respectively, were assigned. This could then be combined with a simple unit weight averaging formula. In this paper, an analytical method that is based on optimization analyses will be proposed and charts will be presented that deliver an equivalent homogeneous unit weight as a function of slope angle (β), water depth (dw), and γsat. This equivalent unit weight (γequiv) will then be assigned to the entire slope and used in conjunction with the stability charts Hunter and Schuster proposed in 1968. The analyses will use an optimization approach that assumes circular failure mechanisms, which will be validated using finite-element (FE) strength reduction. In almost all cases, the charts that are presented in this paper led to a lower and more conservative FS than those obtained that used the simple weighted average approach. Some cases where the charts might lead to unconservative solutions when compared with FE solutions will be identified and discussed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study received financial support from the Open Fund Projects of State Key Laboratory of Geohazard Prevention and Geoenvironment Protection, China (Grants SKLGP2018K025). This support is gratefully acknowledged.
References
Baker, R. 2003. “A second look at Taylor’s stability chart.” J. Geotech. Geoenviron. Eng. 129: 1102–1108. https://doi.org/10.1061/(ASCE)1090-0241(2003)129:12(1102).
Baker, R., R. Shukha, and D. Leshchinsky. 2005. “Stability of cohesionless partially submerged slopes.” Int. J. Numer. Anal. Methods Geomech. 29 (12): 1157–1170. https://doi.org/10.1002/nag.449.
Duncan, J. M. 1996. “Soil slope stability analysis.” Chap. 13 in Landslides: Investigation and mitigation, Transportation Research Board Special Rep. 247, edited By A. K. Turner and R. L. Schuster, 337–371. Washington, DC: National Academy Press.
Duncan, J. M., and A. L. Buchignani. 1975. An engineering manual for slope stability studies. Berkeley, CA: Dept. of Civil Engineering, Univ. of California.
Duncan, J. M., A. L. Buchignani, and M. De Wet. 1987. “Slope stability charts.” Chap. in Engineering manual for slope stability studies, edited by C. E. Via, 25–46. Blacksburg, VA: Dept. of Civil Engineering, Virginia Polytechnic Institute and State Univ.
Duncan, J. M., and S. G. Wright. 2005. “Slope stability charts.” Appendix in Soil strength and slope stability, 265–280. New York: Wiley.
Eid, H. T. 2014. “Stability charts for uniform slopes in soils with nonlinear failure envelopes.” Eng. Geol. 168: 38–45. https://doi.org/10.1016/j.enggeo.2013.10.021.
Gibson, R. E., and N. Morgenstern. 1962. “A note on the stability of cuttings in normally consolidated clay.” Géotechnique 12: 212–216. https://doi.org/ 10.1680/geot.1962.12.3.212.
Griffiths, D. V., and P. A. Lane. 1999. “Slope stability analysis by finite elements.” Géotechnique 49 (3): 387–403. https://doi.org/10.1680/geot.1999.49.3.387.
Griffiths, D. V., and X. Yu. 2015. “Another look at the stability of slopes with linearly increasing undrained strength.” Géotechnique 65: 824–830. https://doi.org/l0.1680/geot.14.T.030.
Hunter, J. H., and R. L. Schuster. 1968. “Stability of simple cuttings in normally consolidated clay.” Géotechnique 18: 372–378. https://doi.org/10.1680/geot.1968.18.3.372.
Li, P., Q. Zhang, X. K. Hou, and T. L. Li. 2016. “Stability analysis of an undrained soil slope against the linearly increasing shear strength.” [In Chinese.] Hydrogeol. Eng. Geol. 43 (3): 59–65.
Michalowski, R. L. 2010. “Limit analysis and stability charts for 3D slope failures.” J. Geotech. Geoenviron. Eng. 136 (4): 583–593. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000251.
Sahoo, P. P., and S. K. Shukla. 2019. “Taylor’s slope stability chart for combined effects of horizontal and vertical seismic coefficients.” Géotechnique 69 (4): 344–354. https://doi.org/10.1680/jgeot.17.P.222.
Steward, T., N. Sivakugan, S. K. Shukla, and B. M. Das. 2011. “Taylor’s slope stability charts revisited.” Int. J. Geomech. 11 (4): 348–352. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000093.
Tang, G. P., L. H. Zhao, L. Li, and F. Yang. 2015. “Stability charts of slopes under typical conditions developed by upper bound limit analysis.” Comput. Geotech. 65: 233–240. https://doi.org/10.1016/j.compgeo.2014.12.008.
Taylor, D. W. 1937. “Stability of earth slopes.” J. Boston Soc. Civ. Eng. 24 (3): 197–246.
USACE. 2003. “Chart solutions for embankment slopes.” Appendix E in Slope stability (Engineer manual). Washington, DC: USACE. EM1110-2-1902:E-15-E-16. E-1-E-26.
Vo, T., and A. R. Russell. 2020. “Contours of saturated and unsaturated overhanging slopes at limiting equilibrium condition.” Int. J. Numer. Anal. Methods Geomech. 44: 93–116. https://doi.org/10.1002/nag.3008.
Wang, W., and D. V. Griffiths. 2020. “Analysis of the critical pool level of partially submerged slopes.” Int. J. Numer. Anal. Methods Geomech. 44 (3): 405–417. https://doi.org/10.1002/nag.3022.
Zhang, F., D. Leshchinsky, R. Baker, Y. F. Gao, and B. Leshchinsky. 2016. “Implications of variationally derived 3D failure mechanism.” Int. J. Numer. Anal. Methods Geomech. 40: 2514–2531. https://doi.org/10.1002/nag.2543.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 22 • Issue 8 • August 2022
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Sep 22, 2021
Accepted: Feb 22, 2022
Published online: Jun 9, 2022
Published in print: Aug 1, 2022
Discussion open until: Nov 9, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.