Critical-State Shear Strength and Pore Pressure of Granular Materials
Publication: International Journal of Geomechanics
Volume 21, Issue 12
Abstract
The plane-strain critical-state friction angle is an important soil parameter in the design of geotechnical projects. The static angle of repose, which is the same as the plane-strain critical-state friction angle for normally consolidated cohesionless soil, was measured in the laboratory in this investigation. The experimental results were used to validate the relationship between the static angle of repose and the interparticle sliding friction. This relationship accounts for the dilatancy developed in the plane-strain critical state and its corresponding pore pressure coefficient at constant volume. In order to develop this relationship, the law of conservation of energy and the limit-equilibrium analysis were employed in a bidimensional plane-strain micromechanical model for the granular media in the critical state. The framework described in this paper accounts for the evolution of shearing resistance with porosity and establishes theoretical porosity thresholds for the contractive, dilative, and collapsible behavior. The results produced by the theory developed herein compared well with the present experimental results and those available in the literature.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Financial support from the Natural Sciences and Engineering Research Council of Canada (NSERC) and Concordia University is gratefully acknowledged.
Notation
The following symbols are used in this paper:
- Acs,ps
- pore pressure coefficient of plane-strain critical-state shear failure;
- Acv,ps
- steady or intrinsic coefficient of pore pressure, known to be 1/3 according to Skempton (1954);
- Ap,ps
- pore pressure coefficient of critical-state failure due to geometrical interference;
- n
- porosity;
- nf
- porosity at plane-strain critical-state failure (also known as nc);
- ns
- porosity associated with a change of internal structure;
- critical porosity associated with soil collapsibility potential;
- α
- auxiliary angle defined herein in the particle-scale model of a pile standing at rest;
- β
- static angle of repose;
- external finally developed plane-strain critical-state friction angle;
- internal initially available plane-strain constant-volume friction angle;
- angle of grain crushing;
- angle of dilation/contraction normal to the shear plane;
- angle of geometrical interference ;
- angle of pushing or rearrangement; and
- interparticle sliding friction angle.
References
Alharthi, Y. M. 2018. “Shaft resistance of driven piles in overconsolidated cohesionless soils.” Ph.D. thesis, Concordia Univ.
ASTM. 2007. Test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method. ASTM D4918-97 (withdrawn 2010). West Conshohocken, PA: ASTM.
Atkinson, J. H. 2017. The mechanics of soils and foundations. 2nd ed. Abingdon, UK: CRC Press.
Bishop, A. W. 1954. “Correspondence on shear characteristics of a saturated silt, measured in triaxial compression.” Géotechnique 4 (1): 43–45. https://doi.org/10.1680/geot.1954.4.1.43.
Bjerrum, L., S. Kringstad, and O. Kummeneje. 1961. “The shear strength of a fine sand.” In Vol. 1 of Proc., 5th Int. Conf. Soil Mech., 29–37. Paris, France: Dunod.
Bolton, M. D. 1986. “The strength and dilatancy of sands.” Géotechnique 36 (1): 65–78. https://doi.org/10.1680/geot.1986.36.1.65.
Bolton, M. D. 1987. “Discussion: The strength and dilatancy of sands.” Géotechnique 37 (2): 219–226. https://doi.org/10.1680/geot.1987.37.2.219.
Caquot, A. I. 1934. Équilibre Des Massifs à Frottement Interne: Stabilité Des Terres, Pulvérulentes Ou Cohérentes. Paris: Gauthier-Villars.
Cornforth, D. H. 1973. “Prediction of drained strength of sands from relative density measurements.” In Evaluation of relative density and its role in geotechnical projects involving cohesionless soils, edited by E. Selig and R. Ladd, 281–303. West Conshohocken, PA: ASTM.
Horne, M. R. 1969. “The behaviour of an assembly of rotund, rigid, cohesionless particles. III.” Proc. R. Soc. A-Math. Phys. 310 (1500): 21–34. http://www.jstor.org/stable/2416296.
Jamiolkowski, M., D. C. F. Lo Presti, and M. Manassero. 2012. “Evaluation of relative density and shear strength of sands from CPT and DMT.” In Soil behavior and soft ground construction, Geotechnical Special Publication, edited by J. T. Germaine, T. C. Sheahan, and R. V. Whitman, 201–238. Reston, VA: ASCE.
Khosravi, M. H., T. Pipatpongsa, and J. Takemura. 2013. “Experimental analysis of earth pressure against rigid retaining walls under translation mode.” Géotechnique 63 (12): 1020–1028. https://doi.org/10.1680/geot.12.P.021.
Lambe, T. W., and R. V. Whitman. 1969. Soil mechanics. New York: Wiley.
Lings, M. L., and M. S. Dietz. 2004. “An improved direct shear apparatus for sand.” Géotechnique 54 (4), 245–256. https://doi.org/10.1680/geot.2004.54.4.245.
McGaw, R. 1967. Systematic packing from the standpoint of the primitive cell. CRREL Rep. 201. Hanover, NH: U.S. Army Cold Regions Research and Engineering Laboratory.
Rowe, P. W. 1962. “The stress–dilatancy relation for static equilibrium of an assembly of particles in contact.” Proc. R. Soc. London, Ser. A 269: 500–527. https://doi.org/10.1098/rspa.1962.0193.
Rowe, P. W. 1969. “The relation between the shear strength of sands in triaxial compression, plane strain and direct shear.” Géotechnique 19 (1): 75–86. https://doi.org/10.1680/geot.1969.19.1.75.
Sadrekarimi, A., and S. M. Olson. 2011. “Critical state friction angle of sands.” Géotechnique 61 (9): 771–783. https://doi.org/10.1680/geot.9.P.090.
Santamarina, J. C., and G. C. Cho. 2001. “Determination of critical state parameters in sandy soils-simple procedure.” Geotech. Test. J. 24 (2): 185–192. https://doi.org/10.1520/GTJ11338J.
Skempton, A. W. 1954. “The pore-pressure coefficients A and B.” Géotechnique 4 (4): 143–147. https://doi.org/10.1680/geot.1954.4.4.143.
Szypcio, Z. 2017. “Stress–dilatancy for soils. Part III: Experimental validation for the biaxial condition.” Studia Geotech. Mech. 39 (1): 73–80. https://doi.org/10.1515/sgem-2017-0007.
Tatsuoka, F., M. Sakamoto, T. Kawamura, and T.B.S. Fukushima. 1986. “Strength and deformation characteristics of sand in plane strain compression at extremely low pressures.” Soils Found. 26 (1): 65–84. https://doi.org/10.3208/sandf1972.26.65.
Terzaghi, K., R. B. Peck, and G. Mesri. 1996. Soil mechanics in engineering practice. New York: Wiley.
Vosler, G. 2006. “Coefficient of static friction (slide angle) of packaging and packaging materials (including shipping sack papers, corrugated and solid fiberboard; inclined plane method).” TAPPI Website. Accessed July 22, 2020. http://www.tappi.org/content/sarg/t815.pdf.
Wu, A., and Y. Sun. 2008. Granular dynamic theory and its applications. 1st ed. Beijing: Springer.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Feb 23, 2021
Accepted: Aug 19, 2021
Published online: Sep 30, 2021
Published in print: Dec 1, 2021
Discussion open until: Mar 1, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Abdulmuttalip Ari, Suat Akbulut, Effect of particle size and shape on shear strength of sand–rubber granule mixtures, Granular Matter, 10.1007/s10035-022-01287-7, 24, 4, (2022).