Effects of Clay Creep on Long-Term Load-Carrying Behaviors of Bored Piles: Aiming at Reusing Existing Bored Piles
Publication: International Journal of Geomechanics
Volume 20, Issue 8
Abstract
An analytical procedure is presented for assessing the long-term load-carrying behavior of bored piles in clay, where the plastic volumetric strain of surrounding clay caused by creep is estimated by an advanced elasto-viscoplastic constitutive model. Two key soil parameters, the undrained shear strength and the shear modulus, which govern the load-carrying behavior of bored piles in clay, are determined from the definition of the quasi-overconsolidation ratio and the concept of the critical state theory-based Cam-clay model. The long-term load-carrying capacity of bored piles is evaluated based on the total stress method. Hyperbolic load-transfer models are developed with proper incorporation of the two developed soil parameters to predict the long-term load–settlement behaviors of the bored pile. The proposed framework is validated by predicting a pile field test on an existing bored pile (about 30 years) in clay, which was recently performed by the authors in Pudong New Area, Shanghai, and field static load tests on two single bored piles conducted by other researchers. Comprehensive parametric studies are conducted to explore the effects of secondary compression index and in situ soil properties on long-term load-carrying behavior of bored piles. The proposed procedure is expected to provide useful guidance for estimating the load-carrying behavior of existing bored piles in clay and take the ultimate aim of reusing them in practice.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was financially supported by the National Natural Science Foundation of China (Grant No. 41772290).
References
Ashour, M., G. M. Norris, S. Elfass, and A. Z. Al-Hamdan. 2010. “Mobilized side and tip resistances of piles in clay.” Comput. Geotech. 37 (7–8): 858–866. https://doi.org/10.1016/j.compgeo.2010.07.005.
Augustesen, A. 2006. “The effects of time on soil behaviour and pile capacity.” Ph.D. thesis, Dept. of Civil Engineering, Aalborg Univ.
Augustesen, A., M. Liingaard, and P. V. Lade. 2004. “Evaluation of time-dependent behavior of soils.” Int. J. Geomech. 4 (3): 137–156. https://doi.org/10.1061/(ASCE)1532-3641(2004)4:3(137).
Basu, P., M. Prezzi, R. Salgado, and T. Chakraborty. 2014. “Shaft resistance and setup factors for piles jacked in clay.” J. Geotech. Geoenviron. Eng. 140 (3): 0401302. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001018.
Bjerrum, L. 1967. “Engineering geology of Norwegian normally-consolidated marine clays as related to settlements of buildings.” Géotechnique 17 (2): 83–118. https://doi.org/10.1680/geot.1967.17.2.83.
Bullock, P. J., J. H. Schmertmann, M. C. McVay, and F. C. Townsend. 2005a. “Side shear setup. I: Test piles driven in Florida.” J. Geotech. Geoenviron. Eng. 131 (3): 292–300. https://doi.org/10.1061/(ASCE)1090-0241(2005)131:3(292).
Bullock, P. J., J. H. Schmertmann, M. C. McVay, and F. C. Townsend. 2005b. “Side shear setup. II: Results from Florida test piles.” J. Geotech. Geoenviron. Eng. 131 (3): 301–310. https://doi.org/10.1061/(ASCE)1090-0241(2005)131:3(301).
Cao, L. F., C. I. Teh, and M. F. Chang. 2001. “Undrained cavity expansion in modified Cam clay I: Theoretical analysis.” Geotechnique 51 (4): 323–334.
Dai, G., R. Salgado, W. Gong, and Y. Zhang. 2012. “Load tests on full-scale bored pile groups.” Can. Geotech. J. 49 (11): 1293–1308. https://doi.org/10.1139/t2012-087.
Flaate, K. 1972. “Effects of pile driving in clays.” Can. Geotech. J. 9 (1): 81–88. https://doi.org/10.1139/t72-006.
Guo, W. D. 2000. “Visco-elastic consolidation subsequent to pile installation.” Comput. Geotech. 26 (2): 113–144. https://doi.org/10.1016/S0266-352X(99)00028-2.
Lam, C., and S. A. Jefferis. 2011. “Critical assessment of pile modulus determination methods.” Can. Geotech. J. 48 (10): 1433–1448. https://doi.org/10.1139/t11-050.
Li, L., J. Li, D. A. Sun, and W. Gong. 2017a. “Analysis of time-dependent bearing capacity of a driven pile in clayey soils by total stress method.” Int. J. Geomech. 17 (7): 04016156. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000860.
Li, L., J. Li, D. A. Sun, and W. Gong. 2017b. “Semi-analytical approach for time-dependent load–settlement response of a jacked pile in clay strata.” Can. Geotech. J. 54 (12): 1682–1692. https://doi.org/10.1139/cgj-2016-0561.
Li, L., J. Li, D. A. Sun, and L. Zhang. 2017c. “Time-dependent bearing capacity of a jacked pile: An analytical approach based on effective stress method.” Ocean Eng. 143: 177–185. https://doi.org/10.1016/j.oceaneng.2017.08.010.
Matsuoka, H., and D. Sun. 2006. The SMP concept-based 3D constitutive models for geomaterials. Leiden, Netherlands: Taylor & Francis.
Matsuoka, H., Y.-P. Yao, and D. Sun. 1999. “The Cam-clay models revised by the SMP criterion.” Soils Found. 39 (1): 81–95. https://doi.org/10.3208/sandf.39.81.
Mayne, P. W., and F. H. Kulhawy. 1982. “K0–OCR relationship in soil.” J. Geotech. Eng. Div. 108 (6): 851–872.
O’Neil, M. W., and L. C. Reese. 1999. Drilled shafts: Construction procedures and design methods. FHA Publication No. FHWA-IF-99-025. Washington, DC: US Department of Transportation.
Randolph, M. F., and C. P. Wroth. 1979a. “An analytical solution for the consolidation around a driven pile.” Int. J. Numer. Anal. Methods Geomech. 3 (3): 217–229. https://doi.org/10.1002/nag.1610030302.
Randolph, M. F., and C. P. Wroth. 1979b. “An analysis of the vertical deformation of pile groups.” Géotechnique 29 (4): 423–439. https://doi.org/10.1680/geot.1979.29.4.423.
Randolph, M. F., and C. P. Wroth. 1981. “Application of the failure state in undrained simple shear to the shaft capacity of driven piles.” Géotechnique 31 (1): 143–157. https://doi.org/10.1680/geot.1981.31.1.143.
Roy, M., and M. Lemieux. 1986. “Long-term behaviour of reconsolidated clay around a driven pile.” Can. Geotech. J. 23 (1): 23–29. https://doi.org/10.1139/t86-004.
Schmertmann, J. H. 1991. “The mechanical aging of soils.” J. Geotech. Eng. 117 (9): 1288–1330. https://doi.org/10.1061/(ASCE)0733-9410(1991)117:9(1288).
Sekiguchi, H. 1984. “Theory of undrained creep rupture of normally consolidated clay based on elasto-viscoplasticity.” Soils Found. 24 (1): 129–147. https://doi.org/10.3208/sandf1972.24.129.
Tavenas, F., and R. Audy. 1972. “Limitations of the driving formulas for predicting the bearing capacities of piles in sand.” Can. Geotech. J. 9 (1): 47–62. https://doi.org/10.1139/t72-004.
Wardle, I. F., G. Price, and J. Freeman. 1992. “Effect of time and maintained load on the ultimate capacity of pile in stiff clay.” In Proc., Piling: European Practice and Worldwide Trends, 92–99. London: The Institution of Civil Engineers.
Wood, D. M. 1990. Soil behaviour and critical state soil mechanics. Cambridge, UK: Cambridge University Press.
Xia, Z., and J. Zou. 2017. “Simplified approach for settlement analysis of vertically loaded pile.” J. Eng. Mech. 143 (11): 04017124. https://doi.org/10.1061/(ASCE)EM.1943-7889.0001334.
Yao, Y. P., W. Hou, and A. N. Zhou. 2009. “UH model: Three-dimensional unified hardening model for overconsolidated clays.” Géotechnique 59 (5): 451–469. https://doi.org/10.1680/geot.2007.00029.
Zhang, Q., and Z. Zhang. 2012. “Simplified calculation approach for settlement of single pile and pile groups.” J. Comput. Civ. Eng. 26 (6): 750–758. https://doi.org/10.1061/(ASCE)CP.1943-5487.0000167.
Zhao, C. F., J. Lu, Q. C. Sun, T. Zhu, and S. F. Li. 2009. “Experimental study of load transmission property of large-diameter bored cast-in-situ deep and long pile in different soil layers.” [In Chinese.] Chin. J. Rock Mech. Eng. 28 (5): 1020–1026.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Feb 15, 2019
Accepted: Mar 24, 2020
Published online: Jun 8, 2020
Published in print: Aug 1, 2020
Discussion open until: Nov 8, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.