Control of Ground Uplift Based on Flow-Field Regularity during Grouting in Fracture with Flowing Groundwater
Publication: International Journal of Geomechanics
Volume 20, Issue 3
Abstract
Controlling rock mass uplifting is of great importance when grouting in large opening fracture with flowing groundwater. This paper investigated the basic mechanism of overburden stratum uplift. The ideal fluid assumption was used to analyze the flowing regularity of the grout spreading against flowing groundwater and fluid pressure distribution in a single flat fracture grouting work. The calculated fluid pressure was modified according to the results of single flat fracture grouting simulation test in a prior work to estimate the actual uplift force acting on fracture walls induced by grout pressure. Results showed that the deviation from the actual value induced by ideal fluid assumption can be omitted in the calculation of grout velocity and spreading distance. On the other hand, the deviation for pressure distribution is rather large, and should be modified according to the real-time monitoring of the injection pressure in the actual grouting project. According to the requirement for sealing groundwater, the maximum grouting pressure is determined, and a criterion for risk assessment on overburden stratum uplifting is established.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was financially supported by the General Program of National Natural Science Foundation of China (51779133), the National Key R&D Plan of China (2016YFC0801604), and the Joint Fund of the National Natural Science Foundation of China (U1706223). The authors thank the editors and two anonymous reviewers for their careful work and thoughtful suggestions.
References
Brantberger, M., H. Stille, and M. Eriksson. 2000. “Controlling grout spreading in tunnel grouting—Analyses and developments of the GIN-method.” Tunnelling Underground Space Technol. 15 (4): 343–352. https://doi.org/10.1016/S0886-7798(01)00003-7.
Fransson, Å., C. F. Tsang, J. Rutqvist, and G. Gustafson. 2010. “Estimation of deformation and stiffness of fractures close to tunnels using data from single-hole hydraulic testing and grouting.” Int. J. Rock Mech. Min. Sci. 47 (6): 887–893. https://doi.org/10.1016/j.ijrmms.2010.05.007.
Gothäll, R., and H. Stille. 2009. “Fracture dilation during grouting.” Tunnelling Underground Space Technol. 24 (2): 126–135. https://doi.org/10.1016/j.tust.2008.05.004.
Harr, M. E. 1963. “Groundwater and seepage.” Soil Sci. 95 (4): 289. https://doi.org/10.1097/00010694-196304000-00040.
Hopkins, D. L. 2000. “The implications of joint deformation in analyzing the properties and behavior of fractured rock masses, underground excavations, and faults.” Int. J. Rock Mech. Min. Sci. 37 (1): 175–202. https://doi.org/10.1016/S1365-1609(99)00100-8.
Kumara, C., and B. Indraratna. 2017. “Normal deformation and formation of contacts in rough rock fractures and their influence on fluid flow.” Int. J. Geomech. 17 (1): 04016022. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000641.
Littlejohn, G. S. 1975. “Rock anchors—State of the art. Part 1: Design.” Ground Eng. 8 (5): 25–32.
Liu, R. T. 2012. “Study on spreading and plugging mechanism of quick setting cement based slurry in underground dynamic water grouting and its application.” Ph.D. dissertation, Geotechnical and Structural Engineering Research Center, Shandong Univ.
Liu, X. X., S. L. Shen, A. N. Zhou, and Y. S. Xu. 2019. “Evaluation of foam conditioning effect on groundwater inflow at tunnel cutting face.” Int. J. Numer. Anal. Methods Geomech. 43 (2): 463–481. https://doi.org/10.1002/nag.2871.
Lombardi, G., and D. Deere. 1993. “Grouting design and control using the GIN principle.” Int. Water Power Dam Constr. 45 (6): 15–22.
Rafi, J. Y., and H. Stille. 2014. “Control of rock jacking considering spread of grout and grouting pressure.” Tunnelling Underground Space Technol. 40 (2): 1–15. https://doi.org/10.1016/j.tust.2013.09.005.
Salimzadeh, S., and N. Khalili. 2016. “Fully coupled XFEM model for flow and deformation in fractured porous media with explicit fracture flow.” Int. J. Geomech. 16 (4): 04015091. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000623.
Stille, H., and L. Hassler. 2012. “Application of new theories and technology for grouting of dams and foundations on rock.” Geotech. Geol. Eng. 30 (3): 603–624. https://doi.org/10.1007/s10706-012-9512-7.
Toraldo, C., G. Modoni, M. Ochmanski, and P. Croce. 2018. “The characteristic strength of jet-grouted material.” Geotechnique 68 (3): 262–279. https://doi.org/10.1680/jgeot.16.P.320.
Yap, L. P., and A. A. Rodger. 1984. “A study of the behavior of vertical rock anchors using the finite element method.” Int. J. Rock Mech. Min. Sci. Geomech. Abstr. 21 (2): 47–61. https://doi.org/10.1016/0148-9062(84)91173-2.
Zhang, X. 2011. “Study on mechanism of slurry spreading and sealing at the process of underground engineering moving water grouting and its application.” Ph.D. dissertation, Geotechnical and Structural Engineering Research Center, Shandong Univ.
Zhi-Feng, W., J. S. Shen, and C. Wen-Chieh. 2018. “Simple method to predict ground displacements caused by installing horizontal jet-grouting columns.” Math, Prob. Eng.: 1–11. https://doi.org/10.1155/2018/1897394.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: Mar 24, 2018
Accepted: Aug 26, 2019
Published online: Jan 13, 2020
Published in print: Mar 1, 2020
Discussion open until: Jun 13, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.