Mechanical Characterization of Pavement Granular Materials Using Hardening Soil Model
Publication: International Journal of Geomechanics
Volume 18, Issue 12
Abstract
Various testing methods, such as the static triaxial test, cyclic resilient modulus test, repeated-load static triaxial test, repeated-load California Bearing Ratio (CBR) test, and repeated-load oedometer test, were explored to characterize pavement granular materials. Using such methods, an experimental data set of the stress–strain response of a typical granular material was collected. The modulus values as obtained from the cyclic triaxial tests and the various repeated-load tests were compared. The feasibility of predicting the behavior of the granular material using the hardening soil model was analyzed. Hardening soil model parameters were calibrated using simple static triaxial test data. The effectiveness of the model in predicting the material behavior was then verified by predicting the other experimental results using the hardening soil model with a finite-element implementation. The stress–strain behavior as predicted by the model matched well with the experimentally measured stress–strain values; hence the validity of the hardening soil model was ascertained.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. 2017. Determining the resilient modulus of soils and aggregate materials. AASHTO: T307-99. Washington, DC: AASHTO.
Araya, A. A., A. Molenaar, and L. Houben. 2010. “Characterization of unbound granular materials using repeated load CBR and triaxial testing.” In Proc., GeoShanghai Int. Conf., 3–5. Reston, VA: ASCE.
Arnold, G. K. 2004. “Rutting of granular pavements.” Ph.D. dissertation, Univ. of Nottingham.
ASTM. 2007. Standard test methods for laboratory compaction characteristics of soil using standard effort. ASTM D698. West Conshohocken: ASTM International.
Barden, L., and A. J. Khayatt. 1966. “Incremental strain rate ratios and strength of sand in the triaxial test.” Géotechnique 16 (4): 338–357. https://doi.org/10.1680/geot.1966.16.4.338.
Barksdale, R. D. 1972. “Laboratory evaluation of rutting in base course materials. ” In Proc., 3rd Int. Conf. on Structural Design of Asphalt Pavements, 161–174. London: Cushing-Malloy.
BIS (Bureau of Indian Standards). 2006. Method of test for soils. IS 2720. New Delhi, India: BIS.
Brown, S. F. 1996. “Soil mechanics in pavement engineering.” Géotechnique 46 (3): 383–425. https://doi.org/10.1680/geot.1996.46.3.383.
Chen, C., L. Ge, and J. S. Zhang. 2010. “Modeling permanent deformation of unbound granular materials under repeated loads.” Int. J. Geomech. 10 (6): 236–241. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000025.
Collins, I. F., and P. F. Cliffe. 1987. “Shakedown in frictional materials under moving surface loads.” Int. J. Numer. Anal. Methods Geomech. 11 (4): 409–420. https://doi.org/10.1002/nag.1610110408.
Dawson, T. A., G. Y. Baladi, C. P. Sessions, and S. W. Haider. 2009. “Back calculated and laboratory-measured resilient modulus values.” Transp. Res. Rec. 2094 (1): 71–78. https://doi.org/10.3141/2094-08.
Duncan, J. M., and C. Y. Chang. 1970. “Nonlinear analysis of stress and strain in soil.” J. Soil Mech. Found. Eng. 96 (5): 1629–1653.
Han, Z., and S. K. Vanapalli. 2016. “State-of-the-art: Prediction of resilient modulus of unsaturated subgrade soils.” Int. J. Geomech. 16 (4): 04015104. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000631.
Hjelmstad, K. D., and E. Taciroglu. 2000. “Analysis and implementation of resilient modulus models for granular solids.” J. Eng. Mech. 126 (8): 821–830. https://doi.org/10.1061/(ASCE)0733-9399(2000)126:8(821).
Hveem, F. N., and H. E. Davis. 1950. “Some concepts concerning triaxial compression testing of asphaltic paving mixtures and subgrade materials.” In Compilation of Papers Presented at the First Pacific Area National Meeting, San Francisco and Fifty-Third Annual Meeting, Atlantic City, 25–54. West Conshohocken, PA: ASTM.
Khoury, N., R. Brooks, C. Khoury, and D. Yada. 2012. “Modeling resilient modulus hysteretic behavior with moisture variation.” Int. J. Geomech. 12 (5): 519–527. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000140.
Kim, A. U., D. S. Kweon, and G. C. Lee. 2001. “Alternative method of determining resilient modulus of subgrade soils using a static triaxial test.” Can. Geotech. J. 38 (1): 107–116. https://doi.org/10.1139/t00-077.
Kim, M., and E. Tutumluer. 2006. “Modeling nonlinear, stress-dependent pavement foundation behavior using a general-purpose finite element program.” In Vol. 154 of Proc., GeoShanghai Int. Conf., 29–36. Reston, VA: ASCE.
Kolisoja, P. 1998. “Resilient deformation characteristics of granular materials.” Ph.D. thesis, Tampere Univ. Technology.
Kondner, R. L. 1963. “Hyperbolic stress-strain response: Cohesive soils.” J. Soil Mech. Found. Div. 89 (1): 115–143.
Kumar, P., S. Chandra, and R. Vishal. 2006. “Comparative study of different subbase materials.” J. Mater. Civ. Eng. 18 (4): 576–578. https://doi.org/10.1061/(ASCE)0899-1561(2006)18:4(576).
Lekarp, F., and A. Dawson. 1998. “Modelling permanent deformation behaviour of unbound granular materials.” Constr. Build. Mater. 12 (1): 9–18. https://doi.org/10.1016/S0950-0618(97)00078-0.
Lekarp, F., U. Isacsson, and A. Dawson. 2000a. “State of the art. I: Resilient response of unbound aggregates.” J. Transp. Eng. 126 (1): 66–75. https://doi.org/10.1061/(ASCE)0733-947X(2000)126:1(66).
Lekarp, F., U. Isacsson, and A. Dawson. 2000b. “State of the art. II: Permanent strain response of unbound aggregates.” J. Transp. Eng. 126 (1): 76–83. https://doi.org/10.1061/(ASCE)0733-947X(2000)126:1(76).
LTPP (Long-Term Pavement Performance Protocol). 1996. “P46: Resilient modulus of unbound granular base/subbase materials and subgrade soils.” Washington, DC: United States Dept. of Transportation, Federal Highway Administration. Accessed August 22, 2018. https://www.fhwa.dot.gov/publications/research/infrastructure/pavements/ltpp/p46/p46.pdf.
Morgan, J. R. 1966. “The response of granular materials to repeated loading.” In Proc., 3rd Conf. Australian Road Research Board, 1178–1192.Sydney, Australia: Australian Road Research Board (ARRB).
MoRTH (Ministry of Road Transport and Highways). 2013. Specifications for road and bridge works. Technical Rep. New Delhi, India: Indian Roads Congress.
Okada, K., and G. S. Ghataora. 2002. “Use of cyclic penetration test to estimate the stiffness of railway subgrade.” NDT & E Int. 35 (2): 65–74. https://doi.org/10.1016/S0963-8695(01)00036-6.
Opiyo, T. O. 1995. “A mechanistic approach to laterite-based pavements.” M.Sc. thesis, International Institute for Infrastructure, Hydraulic and Environment Engineering (IHE).
Plaxis. 2014. PLAXIS 2D reference manual. Delft, Netherlands: Plaxis. Accessed August 22, 2018. http://www.plaxis.nl/plaxis2d/manuals/.
Rahim, A. M., and K. P. George. 2005. “Models to estimate subgrade resilient modulus for pavement design.” Int. J. Pavement Eng. 6 (2): 89–96. https://doi.org/10.1080/10298430500131973.
Shaqlaih, A., L. White, and M. Zaman. 2013. “Resilient modulus modeling with information theory approach.” Int. J. Geomech. 13 (4): 384–389. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000221.
Thom, N. H., and S. F. Brown. 1989. “The mechanical properties of unbound aggregates from various sources.” In Unbound aggregates in roads: Proc. of the 5th Int. Symp. on Unbound Aggregates in Roads, 130–142. Nottingham, UK: Butterworth-Heinemann. https://doi.org/10.1016/B978-0-408-04355-7.50024-8.
Vermeer, P. A., T. Schanz, and P. G. Bonnier. 1999. “PLAXIS: The hardening soil model: Formulation and verification.” In Beyond 2000 in computational geotechnics: 10 years of Plaxis. Rotterdam, Netherlands: Balkema.
Werkmeister, S. 2003. “Permanent deformation behaviour of unbound granular materials in pavement constructions.” Ph.D. dissertation, Dresden Univ. of Technology.
Yan, K. Z., H. B. Xu, and G. H. Shen. 2014. “Novel approach to resilient modulus using routine subgrade soil properties.” Int. J. Geomech. 14 (6): 04014025. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000369.
Yang, S., W. Huang, and Y. Tai. 2005. “Variation of resilient modulus with soil suction for compacted subgrade soils.” Transp. Res. Rec. 1913: 99–106. https://doi.org/10.3141/1913-10.
Zaman, M., P. Solanki, A. Ebrahimi, and L. White. 2010. “Neural network modeling of resilient modulus using routine subgrade soil properties.” Int. J. Geomech. 10 (1): 1–12. https://doi.org/10.1061/(ASCE)1532-3641(2010)10:1(1).
Information & Authors
Information
Published In
Copyright
© 2018 American Society of Civil Engineers.
History
Received: Oct 19, 2017
Accepted: May 21, 2018
Published online: Sep 19, 2018
Published in print: Dec 1, 2018
Discussion open until: Feb 19, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.