Seismic Response Analysis of Renusagar Pond Ash Embankment in Northern India
Publication: International Journal of Geomechanics
Volume 17, Issue 6
Abstract
Utilization of fly ash as a suitable and economic alternative to natural soil for construction of embankments is becoming common, particularly in countries such as India, where thermal power plants are still a major source of power. However, while using this material in a seismic zone, its dynamic properties may play a crucial role during an earthquake event. Of particular concern is the vulnerability of the material to liquefaction-induced failure, because pond ash mainly consists of noncohesive fine sand and silt. The present work focuses on dynamic response analysis of a 52-m-high pond ash embankment situated in Renusagar, northern India, using a fully coupled nonlinear finite-element analysis. Constitutive material models of the pond ash material were calibrated using cyclic triaxial experiment data performed on pond ash samples collected from the aforementioned embankment. A significant amplification in the acceleration response was observed between the base and crest of the embankment ranging from 1.43 to 4.2 (mean, 2.9). The mean amplification profile is consistent with the observation from the literature. A large amplification in the horizontal as well as vertical displacement is also observed with values up to 17.3 and 45 cm, respectively. The pond ash embankment is found to be susceptible to liquefaction for the majority of the earthquake motions considered in the study.
Get full access to this article
View all available purchase options and get full access to this article.
References
Boominathan, A., and Hari, S. (2002). “Liquefaction strength of fly ash reinforced with randomly distributed fibers.” Soil Dyn. Earthquake Eng., 22(9–12), 1027–1033.
Chopra, A. K. (2006). Dynamics of structures: Theory and application to earthquake engineering, Prentice Hall, Englewood Cliffs, NJ.
COSMOS (Consortium of Organizations for Strong Motion Observation Systems). (2010). “COSMOS strong-motion virtual data center: Update to the cosmos converter tool.” 〈http://www.cosmos-eq.org/VDC/index.html〉.
Dakoulas, P., and Gazetas, G. (1985). “A class of inhomogeneous shear models for seismic response of dams and embankments.” Soil Dyn. Earthquake Eng., 4(4), 166–182.
Das, S. K., and Yudhbir. (2005). “Geotechnical characterization of some Indian fly ashes.” J. Mater. Civ. Eng., 544–552.
Elia, G., Amorosi, A., Chan, A. H. C., and Kavvadas, M. J. (2011). “Numerical prediction of the dynamic behavior of two earth dams in Italy using a fully coupled nonlinear approach.” Int. J. Geomech., 504–518.
Elia, G., and Rouainia, M. (2013). “Seismic performance of earth embankment using simple and advanced numerical approaches.” J. Geotech. Geoenviron. Eng., 1115–1129.
FEMA. (2003). “Federal Emergency Management Act, prestandard and commentary for the seismic rehabilitation of buildings.” FEMA 440, Washington, DC.
Gandhi, S. R., Dey, A. K., and Selvam, S. (1999). “Densification of pond ash by blasting.” J. Geotech. Geoenviron. Eng., 889–899.
Gazetas, G. (1987). “Seismic response of earth dams: some recent developments.” Soil Dyn. Earthquake Eng., 6(1), 3–47.
Idriss, I. M., and Boulanger, R. W. (2008). “Soil liquefaction during earthquakes.” Monograph MNO-12, Earthquake Engineering Research Institute, Oakland, CA.
Idriss, I. M., and Boulanger, R. W. (2010). “SPT-based liquefaction triggering procedures.” Rep. No. UCD/CGM-10/0, Center for Geotechnical Modeling, Dept. of Civil & Environmental Engineering, Univ. of California, Davis, CA.
Indian Standard Code. (2002). IS 1893 (part 1), criteria for earthquake resistant design of structures, Bureau of Indian Standards, New Delhi, India.
Jakka, R. S., Datta, M., and Ramana, G. V. (2010). “Liquefaction behaviour of loose and compacted pond ash.” Soil Dyn. Earthquake Eng., 30(7), 580–590.
Jakka, R. S., Ramana, G. V., and Datta, M. (2011). “Seismic slope stability of embankments constructed with pond ash.” Geotech. Geol. Eng., 29(5), 821–835.
Kramer, S. L. (1996). Geotechnical earthquake engineering, Prentice Hall, Upper Saddle River, NJ.
Lysmer, J., and Kuhlemeyer, R. L. (1969). “Finite dynamic model for infinite media.” J. Eng. Mech. Div., 95(4), 859–878.
Martin, J. P., Collins, R. A., Browning, J. S., and Biehl, F. J. (1990). “Properties and use of fly ashes for embankments.” J. Energy Eng., 71–86.
Mohanty, B., Patra, N. R., and Chandra, S. (2010). “Cyclic triaxial behavior of pond ash.” GeoFlorida 2010: Advances in Analysis, Modeling & Design, Geotechnical Special Publication 199, ASCE, Reston, VA.
Mohanty, S. (2014). “Dynamic characterization and analysis of pond ash embankments from Talcher, Panki and Panipat sites of India.” Ph.D. dissertation, Indian Institute of Technology, Kanpur, India.
Mohanty, S., and Patra, N. R. (2014). “Cyclic behavior and liquefaction potential of Indian pond ash located in seismic zones III and IV.” J. Mater. Civ. Eng., 1–5.
NEHRP (National Earthquake Hazards Reduction Program). (2003). Recommended provisions for seismic regulations for new buildings, Building Seismic Safety Council, Washington, DC.
OpenSees [Computer software]. Univ. of California, Berkeley, CA.
Rampello, S., Cascone, E., and Grosso, N. (2009). “Valuation of the seismic response of a homogeneous earth dam.” Soil Dyn. Earthquake Eng., 29(5), 782–798.
Seed, H. B., and Idriss, I. M. (1982). Soil liquefaction during earthquakes, Engineering Monograph, Earthquake Engineering and Research Institute (EERI), Oakland, CA.
SHAKE [Computer software]. Earthquake Engineering Research Center, Univ. of California, Berkeley, CA.
Vijayasri, T., Patra, N. R., and Raychowdhury, P. (2016). “Cyclic behavior and liquefaction potential of Renusagar pond ash reinforced with geotextiles.” J. Mater. Civ. Eng., 04016125.
Yadav, V. (2011). “1-D ground response analyses of some Indian pond ash located in seismic Zone II, III, and IV.” M.Tech. dissertation, Indian Institute of Technology, Kanpur, India.
Yang, Z., Elgamal, A., and Parra, E. (2003). “A computational model for cyclic mobility and associated shear deformation.” J. Geotech. Geoenviron. Eng., 1119–1127.
Zerwer, A., Cascante, G., and Hutchinson, J. (2002). “Parameter estimation in finite element simulations of Rayleigh waves.” J. Geotech. Geoenviron. Eng., 250–261.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Nov 25, 2015
Accepted: Sep 8, 2016
Published online: Nov 16, 2016
Discussion open until: Apr 16, 2017
Published in print: Jun 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.