Small Stone-Column Groups: Mechanisms of Deformation at Serviceability Limit State
Publication: International Journal of Geomechanics
Volume 17, Issue 5
Abstract
Stone columns are a popular form of ground improvement that can be applied to a variety of foundation solutions involving soft soil deposits. Many design methods are based on an assumption that columns with a length-to-diameter ratio greater than 4 bulge uniformly along their length. This mode of deformation is not valid for small groups of columns in which interaction between individual columns and the footing gives rise to more complex behavior. The deformational behavior of stone columns at serviceability limit state is of utmost importance, because settlement rather than bearing capacity criteria are generally more onerous in soft soils. The results of some high-quality laboratory studies have been informative in this respect, but the extrapolation of results from small-scale tests comes with the caveats associated with single-gravity laboratory testing. The FEM, in combination with advanced constitutive models, can provide a link between the deformational behavior and settlement performance of discrete column groups at working stress levels. A series of analyses was conducted to examine the influence of key design parameters such as column length, spacing, and the number of columns. The influence of a stiff crust was also examined, because the reference soil profile adopted for these analyses was that of the well-characterized Bothkennar test site. The following three modes of deformation were identified by examining the distribution of stress and strain within columns and the surrounding soil: individual punching, block punching, and bulging. Individual and block punching developed in short or closely spaced columns, whereas block punching was more prevalent in larger groups. Bulging develops in long, widely spaced columns and generally occurs at the point of lowest lateral restraint. In addition, novel parameters referred to as compression and punching ratios were developed to validate the in-depth analysis and identify the principal design parameters that influence the behavior of small groups of stone columns. The results indicate that the mode of deformation is governed by column spacing and length rather than the number of columns. This finding is important, because it indicates that settlement design methods that are developed for large groups of columns are applicable to discrete groups at similar spacings and lengths. It was also observed that the influence of the stiff crust forces bulging to occur deeper and might have led authors in the past to suggest the existence of a critical length.
Get full access to this article
View all available purchase options and get full access to this article.
References
Allman, M. A., and Atkinson, J. H. (1992). “Mechanical properties of reconstituted Bothkennar soil.” Géotechnique, 42(2), 289–301.
Balaam, N. P., and Booker, J. R. (1981). “Analysis of rigid rafts supported by granular piles.” Int. J. Numer. Anal. Methods Geomech., 5(4), 379–403.
Barksdale, R. D., and Bachus, R. C. (1983). “Design and construction of stone columns.” Rep. No. FHWA/RD-83/026, National Information Service, Springfield, VA.
Black, J. A., Sivakumar, V., and Bell, A. (2011). “The settlement performance of stone column foundations.” Géotechnique, 61(11), 909–922.
Brinkgreve, R. B. J., and Broere, W. (2006). PLAXIS 3D Foundation manual, version 2, PLAXIS BV, Delft, Netherlands.
Castro, J., and Sagaseta, C. (2009). “Consolidation around stone columns: Influence of column deformation.” Int. J. Numer. Anal. Methods Geomech., 33(7), 851–877.
Castro, J., and Sagaseta, C. (2011). “Consolidation and deformation around stone columns: Numerical evaluation of analytical solutions.” Comput. Geotech., 38(3), 354–362.
Domingues, T. S., Borges, J. L., and Cardoso, A. S. (2007). “Parametric study of stone columns in embankments on soft soils by finite element method.” Applications of Computational Mechanics in Geotechnical Engineering V: Proc., 5th Int. Workshop, CRC Press, Boca Raton, FL, 281–291.
Duncan, J. M., and Chang, C. Y. (1970). “Nonlinear analysis of stress and strain in soil.” J. Soil Mech. Found. Div., 96(5), 1629–1653.
Elshazly, H. A., Hafez, D. H., and Mossaad, M. E. (2008). “Reliability of conventional settlement evaluation for circular foundations on stone columns.” J. Geotech. Geol. Eng., 26(3), 323–334.
Gäb, M., Schweiger, H. F., Kamrat-Pietraszewska, D., and Karstunen, M. (2008). “Numerical analysis of a floating stone column foundation using different constitutive models.” Proc., 2nd Int. Workshop on Geotechnics of Soft Soils, 137–142.
Greenwood, D. A. (1991). “Load tests on stone columns.” STP 1089: Deep foundation improvements: Design, construction and testing, ASTM, West Conshohocken, PA, 141–171.
Hanna, A. M., Etezad, M., and Ayadat, T. (2013). “Mode of failure of a group of stone columns in soft soil.” Int. J. Geomech., 87–96.
Herle, I., Hentschel, M., Wehr, W., and Bohac J. (2006). “Role of density on the behaviour of vibrated stone columns in soft soils.” Proc., Int. Symp. on Vibratory Pile Driving & Deep Soil Vibratory Compaction, Laboratoire Central des Ponts et Chaussées, Paris, 141–146.
Hight, D. W., Bond, A. J., and Legge, J. D. (1992). “Characterization of the Bothkennaar clay: An overview.” Géotechnique, 42(2), 303–347.
Hughes, J. M., and Withers, N. J. (1974). “Reinforcing of soft cohesive soils with stone columns.” Ground Eng., 7(3), 42–49.
Institution of Civil Engineers. (1992). “Bothkennar soft clay test site: Characterization and lessons learned.” Géotechnique, 42(2), 161–378.
Jardine, R. J., Lehane, B. M., Smith, P. R., and Gildea, P. A. (1995). “Vertical loading experiments on rigid pad foundations at Bothkennar.” Géotechnique, 45(4), 573–597.
Killeen, M. M. (2012). “Numerical modelling of small groups of stone columns.” Ph.D. thesis, National Univ. of Ireland, Galway, Ireland.
Killeen, M. M., and McCabe, B. A. (2014). “Settlement performance of pad footings on soft clay supported by stone columns: A numerical study.” Soils Found., 54(4), 760–776.
Kirsch, F. (2008). “Evaluation of ground improvement by groups of vibro stone columns using field measurements and numerical analysis.” Proc., 2nd Int. Workshop on the Geotechnics of Soft Soils, CRC Press, Boca Raton, FL, 241–248.
McCabe, B. A., Nimmons, G. J., and Egan, D. (2009). “A review of field performance of stone columns in soft soils.” Proc. Inst. Civ. Eng. Geotech. Eng., 162(6), 323–334.
McKelvey, D., Sivakumar, V., Bell, A. L., and Graham, J. (2004). “Modelling vibrated stone columns in soft clay.” Proc. Inst. Civ. Eng. Geotech. Eng., 157(3), 137–149.
Mitchell, J. K., and Huber, T. R. (1985). “Performance of a stone column foundation.” J. Geotech. Eng., 205–223.
Muir Wood, D., Hu, W., and Nash, D. F. T. (2000). “Group effects in stone column foundations: Model tests.” Géotechnique, 50(6), 689–698.
Nash, D. F. T., Powell, J. J. M., and Lloyd, I. M. (1992a). “Initial investigations of the soft clay test site at Bothkennar.” Géotechnique, 42(2), 163–181.
Nash, D. F. T., Sills, G. C., and Davison, L. R. (1992b). “One-dimensional consolidation testing of the soft clay from Bothkennar.” Géotechnique, 42(2), 241–256.
Paul, M. A., Peacock, J. D., and Wood, B. F. (1992). “The engineering geology of the Came clay of the national soft clay research site, Bothkennar.” Géotechnique, 42(2), 183–198.
Priebe, H. J. (1976). “Evaluation of the settlement reduction of a foundation improved by vibro-replacement.” Bautechnik, 5, 160–162 (in German).
Priebe, H. J. (1995). “The design of vibro replacement.” Ground Eng., 28(10), 31–37.
Pulko, B., Majes, B., and Logar, J. (2011). “Geosynthetic-encased stone columns: Analytical calculation model.” Geotext. Geomembr., 29(1), 29–39.
Rowe, P. W. (1962). “The stress-dilatancy relation for static equilibrium of an assembly of particles in contact.” Proc. R. Soc. London, Ser. A, 269(1339), 500–527.
Schanz, T. (1998). “Zur modellierung des mechanischen verhaltens von reibungsmaterialien.” Thesis, Institut für Geotechnik, Univ. of Stuttgart, Stuttgart, Germany (in German).
Schanz, T., Vermeer, P. A., and Bonnier, P. G. (1999). “The hardening-soil model: Formulation and verification.” Beyond 2000 in Computational Geotechnics: 10 Years of PLAXIS International, R. B. J. Brinkgreve, ed., A. A. Balkema, Rotterdam, Netherlands, 281–290.
Serridge, C. J., and Sarsby, R. W. (2008). “A review of field trials investigating the performance of partial depth vibro stone columns in a deep soft clay deposit.” Proc., 2nd Int. Workshop on Geotechnics of Soft Soils, CRC Press, Boca Raton, FL, 293–298.
Shahu, J. T., and Reddy, Y. R. (2011). “Clayey soil reinforced with stone column group: Model tests and analyses.” J. Geotech. Eng., 1265–1274.
Wehr, W. (2004). “Stone columns: Single columns and group behavior.” Proc., 5th Int. Conf. on Ground Improvement Techniques, CI-Premier Pte Limited, Singapore, 329–340.
Wehr, W. (2006). “Stone columnsÖGroup behaviour and influence of footing flexibility.” Proc., 6th European Conf. on Numerical Methods in Geotechnical Engineering, Taylor & Francis, London, 767–772.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 17 • Issue 5 • May 2017
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Dec 2, 2014
Accepted: Mar 23, 2016
Published online: Oct 5, 2016
Discussion open until: Mar 5, 2017
Published in print: May 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.