Stability of Footings Adjacent to Pile Walls
Publication: International Journal of Geomechanics
Volume 15, Issue 6
Abstract
The stability of a footing may be destabilized near a retaining wall because of increased lateral displacement and decreased soil confining pressure. The stability of footing within this footing–soil–wall system is complex and not predicted using the classical solutions utilized for a semi-infinite footing–soil system. In this study, the bearing capacity of a concrete footing placed near a wall of spaced driven concrete piles using three-dimensional finite-element (FE) analysis with ANSYS 13.0 is investigated. All system materials are idealized as nonlinear, elastic–perfectly plastic, and rate independent using the upper bound function of the Drucker–Prager yield criterion. Three different soil deposits are studied: kaolin, silty clay, and kaolin–sand. A total of 144 unique FE analysis runs are executed. The footing bearing capacity is computed from the output footing pressure–settlement curve using several well-known postprocessing linearization criteria from which the lowest value is chosen. Soil yielding patterns and failure mechanisms are also studied and presented. Empirical equations capable of predicting the footing bearing capacity and the footing–pile distance without the effect of destabilizing factors are developed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The first author thanks Ms. Niki Contreras for providing assistance in editing this paper. Also, the authors extend their deepest thanks to the reviewers and editor for their valuable advice.
References
Ahmed, F. (2004). “Stability of strip footings adjacent to concrete sheetpile walls.” D.Eng. thesis, Lamar Univ., Beaumont, TX.
Altuntas, C., Persaud, D., and Poeppel, A. (2009). “Secant pile wall design and construction in Manhattan, New York.” Contemporary Topics in Ground Modification, Problem Soils, and Geo-Support, M. Iskander, D. F. Laefer, and M. H. Hussein, eds., ASCE, Reston, VA, 105–112.
ANSYS 13.0. (2010). Help system // mechanical APDL, SAS IP, Inc., Canonsburg, PA.
Azam, G. (1988). “Performance of strip footing on two-layer soil deposit with void.” M.S. thesis, Pennsylvania State Univ., State College, PA.
Azam, G. (1990). “Stability of shallow continuous footings supported by two-layer soil deposits with an underground void.” Ph.D. thesis, Pennsylvania State Univ., State College, PA.
Azam, G., Hsieh, C. W., and Wang, M. C. (1991). “Performance of strip footing on stratified soil deposit with void.” J. Geotech. Eng., 753–772.
Badie, A. (1983). “Stability of spread footing supported by clay soil with an underground void.” Ph.D. thesis, Pennsylvania State Univ., State College, PA.
Badie, A., and Wang, M. C. (1984). “Stability of spread footing above void in clay.” J. Geotech. Eng., 1591–1605.
Baus, R. L. (1980). “The stability of shallow continuous footings located above voids.” Ph.D. thesis, Pennsylvania State Univ., State College, PA.
Baus, R. L., and Wang, M. C. (1983). “Bearing capacity of strip footing above void.” J. Geotech. Eng., 1–14.
Blackburn, J., and Finno, R. (2007). “Three-dimensional responses observed in an internally braced excavation in soft clay.” J. Geotech. Geoenviron. Eng., 1364–1373.
Bowles, J. (1996). Foundation analysis and design, 5th Ed., McGraw-Hill, New York.
Coduto, D. P. (2001). Foundation design: Principles and practices, 2nd Ed., Prentice-Hall, Upper Saddle River, NJ.
Das, B. (2007). Principles of foundation engineering, 6th Ed., Brooks/Cole Publishing Company, Belmont, CA.
DeBeer, E. (1965). “Bearing capacity and settlement of shallow foundations on sand.” Proc., Symp. on Bearing Capacity and Settlement of Foundations, Duke Univ., Durham, NC, 15–34.
DeBeer, E. (1970). “Experimental determination of the shape factors and the bearing capacity factors of sand.” J. Géotechnique, 20(4), 387–411.
Dempsey, J., and Li, H. (1989). “A rigid rectangular footing on an elastic layer.” J. Géotechnique, 39(1), 147–152.
Desai, C., and Christian, J. (1977). Numerical methods in geotechnical engineering, McGraw-Hill, New York.
Drucker, D., and Prager, W. (1952). “Soil mechanics and plastic analysis in limit design.” J. Q. Appl. Math., 10(2), 157–165.
El Sawwaf, M. (2005). “Strip footing behavior on pile and sheet pile-stabilized sand slope.” J. Geotech. Geoenviron. Eng., 705–715.
Esser, A., and Dingeldein, J. (2007). “Failure of tieback wall anchors due to corrosion.” Case Studies in Earth Retaining Structures, H. Deaton, and Y. Hashash, eds., ASCE, Reston, VA, 1–10.
Gourvenec, S., Randolph, M., and Kingsnorth, O. (2006). “Undrained bearing capacity of square and rectangular footings.” Int. J. Geomech., 147–157.
Hanna, A. M., Etezad, M., and Ayadat, T. (2013). “Mode of failure of a group of stone columns in soft soil.” Int. J. Geomech., 87–96.
Hansen, J. (1970). “A revised and extended formula for bearing capacity.” Dan. Geotech. Inst., 28(28), 5–11.
Hon, R., and Demcsak, M. (2010). “Design and construction of an underpinning and earth-retaining system for Lehigh Valley Hospital building.” Earth Retention Conf. 3, R. Finno, Y. M. A. Hashash, and P. Arduino, eds., ASCE, Reston, VA, 342–351.
Ip, K. W. (2005). “Bearing capacity of foundation near slope.” M.S. thesis, Concordia Univ., Montreal, QC.
Jao, M., Ahmed, F., Muninarayana, G., and Wang, M. (2008). “Stability of eccentrically loaded footings on slopes.” Int. J. Geomech. Geoeng., 3(2), 107–111.
Jao, M., and Wang, M. (1998). “Stability of strip footings above concrete-lined soft ground tunnels.” Tunn. Undergr. Space Technol., 13(4), 427–434.
Jao, M., and Wang, M. (2000). “Behavior of soft ground tunnel under strip footing.” Trends in Rock Mechanics, J. F. Labuz, S. D. Glaser, and E. Dawson, eds., ASCE, Reston, VA, 78–92.
Li, J.-P., Chen, L.-Y., and Liang, F.-Y. (2009). “Effects of footing shape on bearing capacity of rectangular footings.” Contemporary Topics in Ground Modification, Problem Soils, and Geo-Support, M. Iskander, D. F. Laefer, and M. H. Hussein, eds., ASCE, Reston, VA, 481–487.
Meyerhof, G. (1957). “The ultimate bearing capacity of foundations on slopes.” Proc., 4th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 1, London, 384–386.
Meyerhof, G. (1963). “Some recent research on the bearing capacity of foundations.” J. Can. Geotech., 1(1), 16–26.
Michalowski, R., and Dawson, E. (2002). “Three-dimensional analysis of limit loads on Mohr-Coulomb soil.” Found. Civ. Environ. Eng., 1(1), 137–147.
Minitab 16.0. (2010). Help manual, Minitab, State College, PA.
Montgomery, D., Runger, G., and Hubele, N. (2011). Engineering statistics, Wiley, New York.
Niehoff, J. (2008). “Downtown redevelopment with complex site constraints.” Geo-Velopment: The Role of Geological and Geotechnical Engineering in New and Redevelopment Projects, C. M. Goss, R. L. Wiltshire, J. C. Malama, and M. L. Parekh, eds., ASCE, Reston, VA, 1–8.
Puzakov, V., Drescher, A., and Michalowski, R. (2009). “Shape factor for shallow footings.” J. Geomech. Eng., 1(2), 113–120.
Schultze, E. (1961). “Distribution of stress beneath a rigid foundation.” Proc., 5th Int. Conf. on Soil Mechanics and Foundation Engineering, Dunod, Paris, 807–813.
Skempton, A. (1951). “The bearing capacity of clays.” Proc. Building Research Congress London, 3(1), 180–189.
Som, N., and Das, S. (2003). Theory and practice of foundation design, Prentice-Hall of India, New Delhi.
Son, M., and Cording, E. (2011). “Responses of buildings with different structural types to excavation-induced ground settlements.” J. Geotech. Geoenviron. Eng., 323–333.
Sudani, G. A. (2013). “Stability of footings adjacent to spaced pile-row.” D.Eng. dissertation, Lamar Univ., Beaumont, TX.
Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.
Tomlinson, M., and Woodward, J. (2008). Pile design and construction practice, 5th Ed., Taylor & Francis Group, New York.
Vesic, A. (1963). “Bearing capacity of deep foundations in sand.” Highway Research Board Record No. 39, National Academy of Science, National Research Council, Washington, DC, 112–153.
Vesic, A. (1973). “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. Found. Div., 99(1), 45–73.
Zhu, M., and Michalowski, R. (2005). “Shape factors for limit loads on square and rectangular footings.” J. Geotech. Geoenviron. Eng., 223–231.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Feb 4, 2014
Accepted: Dec 5, 2014
Published online: Apr 14, 2015
Discussion open until: Sep 14, 2015
Published in print: Dec 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.