Stress Dilatancy of Natural Soft Clay under an Undrained Creep Condition
Publication: International Journal of Geomechanics
Volume 15, Issue 5
Abstract
The stress–dilatancy relationship is a key point to capture the evolution of both strains and excess pore pressure during an undrained creep of natural soft clay. This paper focuses on investigating the stress dilatancy of natural soft clay during an undrained creep. Undrained triaxial creep tests are performed on -consolidated and isotropically consolidated samples of a typical Chinese soft marine clay with different stress levels. A unique stress–dilatancy curve is obtained from all test results. Several typical stress–dilatancy relations for soils are discussed, comparing them with experimental results. A common modification method for the stress dilatancy of sand is adopted and discussed for clay. All comparisons demonstrate that modified dilatancy equations can describe the stress–dilatancy relationship during an undrained creep. The modified dilatancy equation with the inclination of a potential surface seems to better describe the whole trend, and is suitable for natural soft clay.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was financially supported by the National Natural Science Foundation of China (grant Nos. 41240024 and 41372285), the Research on Key Technology of Large-Span Municipal Tunnel Construction and Operation under Complicated Environment Project by the Research Fund for the Doctoral Program of Higher Education of China (grant No. 20110073120012), the Shanghai Pujiang Talent plan (grant No. 11PJ1405700), and the European project CREEP (grant No. PIAPP-GA-2011-286397). This support is greatly appreciated. In addition, the authors thank the first author’s former Ph.D. student, Mr. Hanbo Dan, for carrying out laboratory tests.
References
Adachi, T., and Oka, F. (1982). “Constitutive equations for normally consolidated clay based on elasto-viscoplasticity.” Soils Found., 22(4), 57–70.
Asaoka, A., Noda, T., Yamada, E., Kaneda, K., and Nakano, M. (2002). “An elasto-plastic description of two distinct volume change mechanisms of soils.” Soils Found., 42(5), 47–57.
Casagrande, A., and Wilson, S. (1951). “Effect of rate of loading on strength of clays and shales at constant water content.” Geotechnique, 2(3), 251–263.
Dafalias, Y. F. (1987). “Anisotropic critical state clay plasticity model.” Proc., 2nd Int. Conf. on Constitutive Laws for Engineering Materials, Vol. 1, Elsevier, New York, 513–521.
Desai, C. S, Sane, S., and Jenson, J. (2011). “Constitutive modeling including creep- and rate-dependent behavior and testing of glacial tills for prediction of motion of glaciers.” Int. J. Geomech., 465–476.
Gajo, A., and Muir Wood, D. (1999). “Severn-Trent sand: A kinematic hardening constitutive model: The formulation.” Geotechnique, 49(5), 595–614.
Hashiguchi, K., and Chen, Z.-P. (1998). “Elastoplastic constitutive equations of soils with the subloading surface and the rotational hardening.” Int. J. Numer. Anal. Methods Geomech., 22(3), 197–227.
Hinchberger, S. D., and Rowe, R. K. (2005). “Evaluation of the predictive ability of two elastic-viscoplastic constitutive models.” Can. Geotech. J., 42(6), 1675–1694.
Holzer, T. L., Hoeg, K., and Arulanandan, K. (1973). “Excess pore pressures during undrained clay creep.” Can. Geotech. J., 10(1), 12–24.
Jefferies, M. G. (1993). “Nor-Sand: A simple critical state model for sand.” Geotechnique, 43(1), 91–103.
Ling, H. I., Yue, D., Kaliakin, V. N., and Themelis, N. J. (2002). “Anisotropic elastoplastic bounding surface model for cohesive soils.” J. Eng. Mech., 748–758.
Reynolds, O. (1885). “On the dilatancy of media composed of rigid particles in contact. With experimental illustrations.” Philos. Mag., 20(127), 469–481.
Roscoe, K. H., and Burland, J. B. (1968). “On the generalized stress-strain behavior of ‘wet’ clay.” Engineering plasticity, Cambridge University Press, Cambridge, MA, 553–609.
Roscoe, K. H., Schofield, A. N., and Thurairajah, A. (1963). “Yielding of clays in states wetter than critical.” Geotechnique, 13(3), 211–240.
Rowe, P. W. (1962). “The stress-dilatancy relations for static equilibrium of an assembly of particles in contact.” Proc. R. Soc. Lond. A, 269(1339), 500–527.
Schofield, A. N., and Wroth, C. P. (1968). Critical state soil mechanics, McGraw Hill, Maidenhead, U.K.
Taechakumthorn, C., and Rowe, R. K. (2012). “Performance of reinforced embankments on rate-sensitive soils under working conditions considering effect of reinforcement viscosity.” Int. J. Geomech., 381–390.
Vaid, Y. P., and Campanella, R. G. (1977). “Time-dependent behavior of undisturbed clay.” J. Geotech. Engrg. Div., 103(7), 693–709.
Walker, L. K. (1969). “Undrained creep in a sensitive clay.” Geotechnique, 19(4), 515–529.
Wheeler, S. J., Naatanen, A., Karstunen, M., and Lojander, M. (2003). “An anisotropic elastoplastic model for soft clays.” Can. Geotech. J., 40(2), 403–418.
Yin, J.-H., Zhu, J.-G., and Graham, J. (2002). “A new elastic viscoplastic model for time-dependent behaviour of normally and overconsolidated clays: Theory and verification.” Can. Geotech. J., 39(1), 157–173.
Yin, Z.-Y., and Chang, C. S. (2012). “Stress-dilatancy behavior for sand under loading and unloading conditions.” Int. J. Numer. Anal. Meth.Geomech., 37(8), 855–870.
Yin, Z.-Y., Chang, C. S., and Hicher, P.-Y. (2010a). “Micromechanical modelling for effect of inherent anisotropy on cyclic behaviour of sand.” Int. J. Solids Struct., 47(14–15), 1933–1951.
Yin, Z.-Y., Chang, C. S., Karstunen, M., and Hicher, P.-Y. (2010b). “An anisotropic elastic-viscoplastic model for soft soils.” Int. J. Solids Struct., 47(5), 665–677.
Yin, Z.-Y., and Hicher, P.-Y. (2008). “Identifying parameters controlling soil delayed behaviour from laboratory and in situ pressuremeter testing.” Int. J. Numer. Anal. Methods Geomech., 32(12), 1515–1535.
Yin, Z.-Y., and Karstunen, M. (2011). “Modelling strain-rate-dependency of natural soft clays combined with anisotropy and destructuration.” Acta Mech. Solida Sin., 24(3), 216–230.
Yin, Z.-Y., Karstunen, M., Chang, C. S., Koskinen, M., and Lojander, M. (2011). “Modeling time-dependent behavior of soft sensitive clay.” J. Geotech. Geoenviron. Eng., 1103–1113.
Yin, Z.-Y., Karstunen, M., and Hicher, P.-Y. (2010c). “Evaluation of the influence of elasto-viscoplastic scaling functions on modelling time-dependent behaviour of natural clays.” Soils Found., 50(2), 203–214.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: May 22, 2012
Accepted: Nov 6, 2012
Published online: Nov 8, 2012
Published in print: Oct 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.