Mode of Failure of a Group of Stone Columns in Soft Soil
Publication: International Journal of Geomechanics
Volume 13, Issue 1
Abstract
The design of stone columns is currently based on theories developed for a single column, ignoring the group interaction and therefore the group efficiency. Whereas single stone columns mainly fail by bulging, a group of stone columns may fail by bulging or shear of the entire soil/columns mass. A numerical model was developed to simulate the case of a single stone column and a group of stone columns installed in soft clay. The model establishes the level of interaction between individual columns and therefore determines the mode of failure of a given geometry, soil, and loading condition. The model was validated with the available experimental data in the literature and used to generate data for a potential mode of failure. This parametric study is conducted to examine the effect of the parameters believed to govern the mode of failure and includes modulus of elasticity of the stone column material and the clay, column diameter, and the spacing and angle of shearing resistance of the column material. The design procedure is presented to assist the designer in establishing the mode failure of a group of stone columns (bulging, general, local, or punching shear).
Get full access to this article
View all available purchase options and get full access to this article.
References
Ambily, A. P., and Gandhi, S. R. (2007). “Behavior of stone columns based on experimental and FEM analysis.” J. Geotech. Geoenviron. Eng., 133(4), 405–415.
Bae, W. S., Bang, W. S., and Byung, C. A. (2002). “Behavior of foundation system improved with stone columns.” Proc., 12th Int. Offshore and Polar Engineering Conf., Int. Society of Offshore and Polar Engineers, Cupertino, CA, 675–678.
Balaam, N. P., and Booker, J. R. (1981). “Analysis of rigid raft supported by granular piles.” Int. J. Numer. Anal. Methods Geomech., 5(4), 379–403.
Barksdale, R. D., and Bachus, R. C. (1983). “Design and construction of stone columns, Volume 1.” Rep. No. FHWA/RD-83/026, Federal Highway Administration, Washington, DC.
Bolton, M. D. (1986). “The strength and dilatancy of sands.” Geotechnique, 36(1), 65–78.
Bouassida, M., Jellali, B., and Porbaha, A. (2009). “Limit analysis of rigid foundations on floating columns.” Int. J. Geomech., 9(3), 89–101.
Castro, J., and Karstunen, M. (2010). “Numerical simulation of stone column installation.” Can. Geotech. J., 47(10), 1127–1138.
Clark, J. I. (1998). “The settlement and bearing capacity of very large foundations on strong soils: 1996 R. M. Hardy keynote address.” Can. Geotech. J., 35(1), 131–145.
Deb, K., Basudhar, P. K., and Chandra, S. (2007). “Generalized model for geosynthetic-reinforced granular fill-soft soil with stone columns.” Int. J. Geomech., 7(4), 266–276.
Goughnour, R. R., and Bayuk, A. A. (1979a). “Analysis of stone column–soil matrix interaction under vertical load.” Proc., Int. Conf. on Soil Reinforcement: Reinforced Earth and Other Techniques, Vol. 1, Ecole Nationale des Ponts et Chaussees, Paris, 271–278.
Goughnour, R. R., and Bayuk, A. A. (1979b) “Field study of long term settlements of loads supported by stone columns in soft ground.” Proc., Int. Conf. on Soil Reinforcement: Reinforced Earth and Other Techniques, Ecole Nationale des Ponts et Chaussees, Paris, 279–285.
Han, J., and Ye, S. L. (2002). “A theoretical solution for consolidation rates of stone column-reinforced foundations accounting for smear and well resistance effects.” Int. J. Geomech., 2(2), 135–151.
Hu, W. (1995). “Physical modeling of group behavior of stone column foundations.” Ph.D. dissertation, Univ. of Glasgow, U.K.
Hu, W., Wood, D. M., and Stewart, W. (1997). “Ground improvement using stone column foundations: Result of model tests.” Int. Conf. on Ground Improvement Techniques, CI-Premier, Singapore, 247–256.
Hughes, J. M. O., and Withers, N. J. (1974). “Reinforcing of soft cohesive soils with stone columns.” Ground Eng., 7(3), 42–49.
McCabe, B. A., Nimmons, G. J., and Egan, D. (2010). “A review of field performance of stone columns in soft soils.” Geotech. Eng., 162(GE6), 323–334.
Mitchell, J. K., and Huber, T. R. (1985). “Performance of a stone column foundation.” J. Geotech. Eng., 111(2), 205–223.
PLAXIS 8 [Computer software]. DUT, Delft, Netherlands.
Poorooshasb, H. B., and Meyerhof, G. G. (1997). “Analysis of behavior of stone columns and lime columns.” Comput. Geotech., 20(1), 47–70.
Priebe, H. J. (1976). “Abschätzung des Setzungsverhaltens eines durch Stopfverdichtung verbesserten Baugrundes.” Bautechnik, 53(H.5), 160–162 (in German).
Vesic, A. S. (1973). “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. Found. Div., 99(1), 45–73.
Weber, T. M., Plotze, M., Laue, J., Peschke, G., and Springman, S. M. (2010). “Smear zone identification and soil properties around stone columns constructed in-flight in certrifuge model tests.” Geotechnique, 60(3), 197–206.
Wehr, W. (1999). “Schottersäulen—Das verhalten von einzelnen säulen und säulengruppen.” Geotechnik, 22(1), 40–47 (in German).
Wood, D. M., Hu, W., and Nash, D. F. T. (2000). “Group effects in stone column foundations: Model tests.” Geotechnique, 50(6), 689–698.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 13 • Issue 1 • February 2013
Pages: 87 - 96
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jan 24, 2010
Accepted: Aug 25, 2011
Published online: Jan 15, 2013
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.