DEM Analysis of Stresses and Deformations of Geogrid-Reinforced Embankments over Piles
Publication: International Journal of Geomechanics
Volume 12, Issue 4
Abstract
The geosynthetic-reinforced pile-supported embankment is one of the favorable ground improvement techniques used in the construction of earth structures over a compressible soil when limited construction time is available and limited deformation is permissible. Various methods are available for the design of the geosynthetic-reinforced platform based on various load transfer mechanisms from the embankment to the piles and the compressible soil. The existence of the geosynthetic layer makes the mechanisms more complex. This study focuses on the behavior of geogrid-reinforced embankments over piles compared with the behavior of unreinforced embankments. The numerical simulations of the unreinforced and reinforced pile-supported embankments were conducted using the discrete element method (DEM). The embankment fill was simulated using unbonded graded aggregates of diameters ranging from 9.2 to 20.8 mm and the geogrid was simulated using bonded particles. This study investigated the changes of vertical and horizontal stresses and porosities, the vertical displacements within the embankment fill, and the deflection and tension in the geogrid. The simulation results showed that the coefficient of lateral earth pressure in the embankment fill changed from an initial at rest condition to a passive condition at certain locations after the compression of the compressible soil. The embankment fill dilated during the development of soil arching. The embankment load was transferred to the piles owing to the reorientation of the principal stresses. The results also showed that the geogrid reinforcement significantly reduced the total and differential settlements at the top of the embankment.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was jointly supported by the University of Kansas, General Research Fund Allocation No. 2301323, and the Geosynthetic Institute under its GSI Fellowship Program.
References
Bathurst, R. J., and Rothenburg, L. (1990). “Observations on stress-force-fabric relationships in idealized granular materials.” Mech. Mater., 9(1), 65–80.MSMSD3
Bhandari, A., and Han, J. (2010). “Investigation of geotextile–soil interaction under a cyclic vertical load using the discrete element method.” Geotext. Geomembr., 28(1), 33–43.
Bhandari, A., Han, J., and Wang, F. (2009). “Micromechanical analysis of soil arching in geosynthetic-reinforced pile-supported embankments.” Proc., GeoHunan Int. Conf. on Challenges and Recent Advances in Pavement Technologies and Transportation Geotechnics, ASCE Geotechnical Special Publication No. 189, Zhang, X., Yu, X., Fu, H. and Zhang, J., eds., ASCE, Hunan, China, Reston, VA, 47–52.
British Standards Institution (BSI). (1995). “Code of practice for strengthened/reinforced soils and other fills.” BS8006, BSI, London.
Chareyre, B., and Villard, P. (2002). “Discrete element modeling of curved geosynthetic anchorages with known macro-properties.” Numerical modeling in micromechanics via particle methods, Koneitzky, K., ed., Taylor and Francis, Gelsenkirchen, Germany, 197–203.
Chareyre, B., and Villard, P. (2005). “Dynamic spar elements and discrete element methods in two dimensions for the modeling of soil-inclusion problems.” J. Eng. Mech.JENMDT, 131(7), 689–698.
Chen, Y.-M., Cao, W.-P., and Chen, R.-P. (2008). “An experimental investigation of soil arching within basal reinforced and unreinforced piled embankments.” Geotext. Geomembr., 26(2), 164–174.
Costa, Y. D., Zornberg, J. G., Bueno, B. S., and Costa, C. L. (2009). “Failure mechanisms in sand over a deep active trapdoor.” J. Geotech. Geoenviron. Eng., 135(11), 1741–1753.JGGEFK
Cundall, P. A., and Strack, O. D. L. (1979). “A discrete numerical model for granular assemblies.” Geotechnique, 29(1), 47–65.GTNQA8
Giroud, J. P., Bonaparte, R., Beech, J. F., and Gross, B. A. (1990). “Design of soil layer-geosynthetic systems overlying voids.” Geotext. Geomembr., 9(1), 11–50.
Han, J., and Bhandari, A. (2009). “Evaluation of geogrid-reinforced pile-supported embankments under cyclic loading using discrete element method.” Proc., U.S.–China Workshop on Ground Improvement Technologies, ASCE Geotechnical Special Publication No. 188, Han, J., Zheng, G., Schaefer, V. R. and Huang, M., eds., ASCE, Orlando, FL, Reston, VA, 73–82.
Han, J., and Gabr, M. A. (2002). “Numerical analysis of geosynthetic-reinforced and pile-supported earth platforms over soft soil.” J. Geotech. Geoenviron. Eng., 128(1), 44–53.JGGEFK
Hewlett, W. J., and Randolph, M. F. (1988). “Analysis of piled embankments.” Ground Eng., 21(3), 12–18.GRENDB
Huang, J., Han, J., and Oztoprak, S. (2009). “Coupled mechanical nd hydraulic modeling of geosynthetic-reinforced column-supported embankments.” J. Geotech. Geoenviron. Eng., 135(8), 1011–1021.JGGEFK
Itasca Consulting Group, Inc. (Itasca). (2004). Particle flow code in two dimensions (PFC2D), Itasca, Minneapolis.
Jenck, O., Dias, D., and Kastner, R. (2007). “Two-dimensional physical and numerical modeling of a pile-supported earth platform over soft soil.” J. Geotech. Geoenviron. Eng., 133(3), 295–305.JGGEFK
Jenck, O., Dias, D., and Kastner, R. (2009). “Discrete element modelling of a granular platform supported by piles in soft soil—validation on a small scale model test and comparison to a numerical analysis in a continuum.” Comput. Geotech., 36(6), 917–927.CGEOEU
Le Hello, B., and Villard, P. (2009). “Embankments reinforced by piles and geosynthetics-numerical and experimental studies dealing with the transfer of load on the soil embankment.” Eng. Geol., 106(1–2), 78–91.EGGOAO
Low, B. K., Tang, S. K., and Choa, V. (1994). “Arching in piled embankments.” J. Geotech. Eng., 120(11), 1917–1938.JGENDZ
Lu, M., and McDowell, G. R. (2007). “The importance of modelling ballast particle shape in the discrete element method.” Granular Matter, 9(1–2), 69–80.GRMAFE
Masson, S., and Martinez, J. (2000). “Multiscale simulations of the mechanical behaviour of an ensiled granular material.” Mech. Cohes.-Frict. MaterMCFMFA, 5(6), 425–442.
McKelvey, J. A. III (1994). “Anatomy of soil arching.” Geotext. Geomembr., 13(5), 317–329.
O’Sullivan, C., Cui, L., and O’Neill, S. C. (2008). “Discrete element analysis of the response of granular materials during cyclic loading.” Soils Found., 48(4), 511–530.SOIFBE
Potyondy, D. O., and Cundall, P. A. (2004). “A bonded-particle model for rock.” Int. J. Rock Mech. Min. Sci., 41(8), 1329–1364.IJRMA2
Rothenburg, L., and Bathurst, R. J. (1989). “Analytical study of induced anisotropy in idealized granular materials.” Geotechnique, 39(4), 601–614.GTNQA8
Rothenburg, L., and Bathurst, R. J. (1992). “Micromechanical features of granular assemblies with planar elliptical particles.” Geotechnique, 42(1), 79–95.GTNQA8
Rothenburg, L., and Bathurst, R. J. (1993). “Influence of particle eccentricity on micromechanical behavior of granular materials.” Mech. Mater., 16(1–2), 141–152.MSMSD3
Smith, M., and Filz, G. (2007). “Axisymmetric numerical modeling of a unit cell in geosynthetic-reinforced, column-supported embankments.” Geosynth. Int.GINTFD, 14(1), 13–22.
Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.
Villard, P., Chevalier, B., Le Hello, B., and Combe, G. (2009). “Coupling between finite and discrete element methods for the modelling of earth structures reinforced by geosynthetic.” Comput. Geotech., 36(5), 709–717.CGEOEU
Walters, D. L., Allen, T. M., and Bathurst, R. J. (2002). “Conversion of geosynthetic strain to load using reinforcement stiffness.” Geosynth. Int.GINTFD, 9(5–6), 483–523.
Wang, F., Han, J., Miao, L.-C., and Bhandari, A. (2009). “Numerical analysis of geosynthetic-bridged and drilled shaft-supported embankments over large sinkholes.” Geosynth. Int.GINTFD, 16(6), 408–419.
Zhang, L., and Thornton, C. (2007). “A numerical examination of the direct shear test.” Geotechnique, 57(4), 343–354.GTNQA8
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 12 • Issue 4 • August 2012
Pages: 340 - 350
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Nov 14, 2009
Accepted: Apr 29, 2011
Published online: May 2, 2011
Published in print: Aug 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.