Variations of Stratification and Cooling Energy Performance According to Diffuser Condition in UFAD System
Publication: Journal of Energy Engineering
Volume 146, Issue 4
Abstract
The underfloor air distribution (UFAD) system, which is a building energy-saving technology, is an air-conditioning system that enables maintenance of the indoor temperature with a relatively low supply air flow rate. UFAD has advantages compared to the conventional overhead system, which improves occupants’ comfort, health, and work efficiency, decreases life cycle cost, and improves indoor air quality, ventilation efficiency, and lay-out flexibility related to building services. Also, the floor height is reduced because a duct is unnecessary. The stratification of the UFAD system is a key factor to the system, which refers to the inconsistent vertical temperature distribution from the floor to the ceiling due to the buoyant effect of air. It plays a critical role in determining the thermal, ventilation, and energy performance. However, based on the comprehensive literature review, study on the stratification of UFAD is insufficient due to lack of understanding and actual measurement facilities related to UFAD. Therefore, this study, by using the EnergyPlus simulation and phi-gamma formula, aims to assess the stratification according to the variation of a diffuser condition. As a result, stratification of the perimeter zone was improved by diffuser condition but the energy savings was not noticeable. The floor area of the interior zone accounts for 75% of the total floor area but stratification of the interior zone was not nearly changed by diffuser condition. Also, as the stratification was improved, the wall convection heat gain increased in the interior zone. Therefore, it is considered that the cooling load was increased and the decrease of energy consumption is insignificant.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code generated or used during the study are available from the corresponding author by request.
Acknowledgments
This study was supported by a Korea University Grant and supported by the Human Resources Development of the Korea Institute of Energy Technology Evaluation and Planning (KETEP) grant funded by the Korea Government Ministry of Trade, Industry, and Energy (No. 20184030201900). This study was supported by a Korea University Grant (No. K1909671).
References
Alajmi, A. F., F. A. Baddar, and R. I. Bourisli. 2014. “Thermal comfort assessment of an office building served by under-floor air distribution (UFAD) system—A case study.” Build. Environ. 85 (Feb): 153–159. https://doi.org/10.1016/j.buildenv.2014.11.027.
ASHRAE (American Society of Heating, Refrigerating, and Air-Conditioning Engineers). 2004. Energy standard for buildings except low rise residential buildings. ASHRAE Standard 90.1. Atlanta: ASHRAE.
Bauman, F. 2003. Underfloor air distribution (UFAD) design guide. Atlanta: American Society of Heating, Refrigerating, and Air-Conditioning Engineers.
Jang, H. I., S. H. Yoon, H. S. Lee, and S. J. Suh. 2012. “Comparison on the energy performance of underfloor air distribution system according to modeling method using EnergyPlus.” J. Soc. Air-Conditioning Refrigerating Eng. Korea 24 (10): 718–723. https://doi.org/10.6110/KJACR.2012.24.10.718.
Kim, M. J., B. M. Seo, J. M. Lee, J. M. Choi, and K. H. Lee. 2018. “Operational behavior characteristics and energy saving potential of vertical closed loop ground source heat pump system combined with storage tank in an office building.” Energy Build. 179 (Nov): 239–252. https://doi.org/10.1016/j.enbuild.2018.09.025.
Kim, Y. S., E. T. Lee, and S. U. Ha. 2002. “Characteristics on the air velocity and temperature distribution from the diffuser that generates rotational and directional air flow for the underfloor air-conditioning system.” J. Archit. Inst. Korea 18 (3): 145–151.
Kwon, Y. I. 2019. “A study on thermal characteristics affected by air distribution system installed in indoor ice rink arena.” Int. J. Air-Cond. Ref. 27 (1): 1950007. https://doi.org/10.1142/S201013251950007X.
Lee, J. H. 2008. “Underfloor air distribution system in R&D center of Samsung electronics Co., Ltd.” Mag. Soc. Air-Conditioning Refrigerating Eng. Korea 37 (10): 38–42.
Lee, K. H., S. Schiavon, F. Bauman, and T. Webster. 2012. “Thermal decay in underfloor air distribution (UFAD) systems: Fundamentals and influence on system performance.” Appl. Energy 91 (1): 197–207. https://doi.org/10.1016/j.apenergy.2011.09.011.
Lin, Y. J. P. 2005. “A model for an underfloor air distribution system.” Energy Build. 37 (4): 399–409. https://doi.org/10.1016/j.enbuild.2004.07.011.
Lin, Y. J. P., and T. Y. Tsai. 2014. “An experimental study on a full-scale indoor thermal environment using an under-floor air distribution system.” Energy Build. 80 (Sep): 321–330. https://doi.org/10.1016/j.enbuild.2014.05.028.
Linden, P. F., J. K. Yu, T. Webster, F. Bauman, K. H. Lee, and S. Schiavon. 2009. Simulation of energy performance of underfloor air distribution (UFAD) systems. San Diego: Univ. of California.
Ning, M., and M. Zaheeruddin. 2019. “Neural network model-based adaptive control of a VAV-HVAC&R system.” Int. J. Air-Cond. Ref. 27 (1): 1950006. https://doi.org/10.1142/S2010132519500068.
Schiavon, S., T. Webster, D. Dickerhoff, and B. Fred. 2014. “Stratification prediction model for perimeter zone UFAD diffusers based on laboratory testing with solar simulator.” Energy Build. 82 (Sep): 786–794. https://doi.org/10.1016/j.enbuild.2014.07.056.
Seo, B. M., and K. H. Lee. 2016. “Detailed analysis on part load ratio characteristics and cooling energy saving of chiller staging in an office building.” Energy Build. 119 (May): 309–322. https://doi.org/10.1016/j.enbuild.2016.03.067.
Son, J. E., and K. H. Lee. 2016a. “Cooling energy performance analysis depending on the economizer cycle control methods in an office building.” Energy Build. 120 (May): 45–57. https://doi.org/10.1016/j.enbuild.2016.03.073.
Son, J. E., and K. H. Lee. 2016b. “Energy performance assessment according to thermal stratification in underfloor air distribution system.” In Proc., Summer Conf. of Society of Air-Conditioning and Refrigerating Engineers of Korea, 735–738. Seoul: Society of Air-Conditioning and Refrigerating Engineers of Korea.
Tsai, T. Y., R. H. Liou, and Y. J. P. Lin. 2014. “An experimental study on the indoor environment using underfloor air distribution system.” Procedia Eng. 79 (Jan): 263–266. https://doi.org/10.1016/j.proeng.2014.06.341.
USDOE. 2010a. EnergyPlus engineering reference. Washington, DC: USDOE.
USDOE. 2010b. “EnergyPlus input output reference.” In The encyclopedic reference to EnergyPlus input and output. Washington, DC: USDOE.
Webster, T., F. Bauman, K. Lee, S. Schiavon, A. Daly, and T. Hoyt. 2013. CBE EnergyPlus modeling methods for UFAD systems. Berkeley, CA: Univ. of California at Berkeley.
Xue, Y., and Q. Chen. 2014. “Influence of floor plenum on energy performance of buildings with UFAD systems.” Energy Build. 79 (Aug): 74–83. https://doi.org/10.1016/j.enbuild.2014.04.049.
Yeon, S. H., and K. H. Lee. 2018. “Analysis of stratification levels in underfloor air distribution systems according to diffuser conditions.” J. Soc. Air-Conditioning Refrigerating Eng. Korea 30 (6): 245–257. https://doi.org/10.6110/KJACR.2018.30.6.245.
Yoon, S. H., H. I. Jang, K. A. Kim, K. H. Yu, and S. J. Suh. 2013. “An energy performance evaluation of UFAD system under the various conditions of thermal load.” J. Soc. Air-Conditioning Refrigerating Eng. Korea 25 (1): 14–19. https://doi.org/10.6110/KJACR.2013.25.1.014.
Yu, K. H., D. W. Cho, Y. J. Yu, J. Y. Lee, and S. Y. Lee. 2004. “Comparative evaluation of indoor environment of office buildings with an underfloor air distribution system and a ceiling based air conditioning system.” J. Archit. Inst. Korea 20 (5): 185–192.
Information & Authors
Information
Published In
Journal of Energy Engineering
Volume 146 • Issue 4 • August 2020
Copyright
©2020 American Society of Civil Engineers.
History
Received: Jun 3, 2019
Accepted: Nov 27, 2019
Published online: Apr 18, 2020
Published in print: Aug 1, 2020
Discussion open until: Sep 18, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.