Morphological Characteristics of Chars Obtained from Low-Temperature Pyrolysis of Pulverized Lignite
Publication: Journal of Energy Engineering
Volume 144, Issue 3
Abstract
Staged coal conversion, with pyrolysis as its foundation, is one clean and effective coal usage technology. In this study, the structural and morphological characteristics of Ximeng lignite chars obtained from low-temperature pyrolysis during preheating in staged coal conversion are studied. The pulverized lignite was pyrolyzed under in a temperature range of 300–700°C. Sieve analysis was used to investigate changes in char particle size. adsorption/desorption, and a scanning electron microscope (SEM) and Fourier transform infrared (FTIR) spectroscopy were used to investigate changes in pore structure, surface morphology, and chemical structure of the char particles. The mechanisms of changes in particle size are discussed. Results suggest that the char particles have the trend of being smaller with increasing pyrolysis temperature. Changes in particle size, pore structure, and chemical structure at temperatures above 500°C are more significant than those below 500°C as a result of greater extent of pyrolysis and more vigorous condensation reactions at high temperatures. Specific surface area and pore volume increase with increasing pyrolysis temperature. More micropores are developed, and the number of mesopores with an average size smaller than 10 nm decreases as the temperature ranges up to 500°C. Moreover, when the pyrolysis temperature increases above 500°C, the specific surface area and pore volume increase sharply as a result of large number of pores and wide pore-size distribution. FTIR analysis shows that the aromaticity of char increases oxygen-containing functional groups, and aliphatic structures decrease as the pyrolysis temperature increases.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Natural Science Foundation of China (CN) (51776185).
References
Arenillas, A., et al. (2003). “Thermal behaviour during the pyrolysis of low rank perhydrous coals.” J. Aanl. Appl. Pyrolysis, 68(3), 371–385.
Arenillas, A., Rubiera, F., Pevida, C., and Pis, J. (2001). “A comparison of different methods for predicting coal devolatilisation kinetics.” J. Anal. Appl. Pyrolysis, 58(2), 685–701.
Arenillas, A., Rubiera, F., Pis, J., Jones, J. M., and Williams, A. (1999). “The effect of the textural properties of bituminous coal chars on NO emissions.” Fuel, 78(14), 1779–1785.
Bend, S. L., Edwards, I. A., and Marsh, H. (1992). “The influence of rank upon char morphology and combustion.” Fuel, 71(5), 493–501.
Bhattacharya, S., Kabir, K. B., and Hein, K. (2013). “Dimethyl ether synthesis from Victorian brown coal through gasification-Current status, and research and development needs.” Prog. Energy Combust., 39(6), 577–605.
Cen, J., Fang, M., Wang, Q., Luo, Z., and Cen, K. (2011). “Development and prospect of coal staged conversion poly-generation technology.” Chem. Ind. Eng. Prog., 30(1), 88–94.
Cheng, J., Wang, X., Si, T., Zhou, F., Zhou, J., and Cen, K. (2016). “Pore fractal structures and combustion dynamics of cokes derived from the pyrolysis of typical Chinese power coals.” Fuel Process. Technol., 149, 49–54.
Everson, R. C., Neomagus, H. W., Kaitano, R., Falcon, R., van Alphen, C., and du Cann, V. M. (2008). “Properties of high ash char particles derived from inertinite-rich coal. 1: Chemical, structural and petrographic characteristics.” Fuel, 87(13), 3082–3090.
Fu, Z., Guo, Z., Yuan, Z., and Wang, Z. (2007). “Swelling and shrinkage behavior of raw and processed coals during pyrolysis.” Fuel, 86(3), 418–425.
Griffin, T. P., Howard, J. B., and Peters, W. A. (1994). “Pressure and temperature effects in bituminous coal pyrolysis: Experimental observations and a transient lumped-parameter model.” Fuel, 73(4), 591–601.
Groen, J. C., Peffer, L. A., and Pérez-Ramírez, J. (2003). “Pore size determination in modified micro-and mesoporous materials. Pitfalls and limitations in gas adsorption data analysis.” Micropor. Mesopor. Mat., 60(1), 1–17.
International Energy Agency. (2016). “World energy outlook 2016.” Paris.
Kister, J., Guiliano, M., Largeau, C., Derenne, S., and Casadevall, E. (1990). “Characterization of chemical structure, degree of maturation and oil potential of Torbanites (type I kerogens) by quantitative FT-IR spectroscopy.” Fuel, 69(11), 1356–1361.
Liu, L., Cao, Y., and Liu, Q. C. (2015). “Kinetics studies and structure characteristics of coal char under pressurized CO2 gasification conditions.” Fuel, 146, 103–110.
Lu, L., Kong, C., Sahajwalla, V., and Harris, D. (2002). “Char structural ordering during pyrolysis and combustion and its influence on char reactivity.” Fuel, 81(9), 1215–1225.
Lu, L., Sahajwalla, V., and Harris, D. (2000). “Characteristics of chars prepared from various pulverized coals at different temperatures using drop-tube furnace.” Energy Fuel, 14(4), 869–876.
Matsuoka, K., Akahane, T., Aso, H., Sharma, A., and Tomita, A. (2008). “The size of polyaromatic layer of coal char estimated from elemental analysis data.” Fuel, 87(4), 539–545.
Menéndez, R., Vleeskens, J. M., and Marsh, H. (1993). “The use of scanning electron microscopy for classification of coal chars during combustion.” Fuel, 72(5), 611–617.
Miura, K., Mae, K., Li, W., Kusakawa, T., Morozumi, F., and Kumano, A. (2001). “Estimation of hydrogen bond distribution in coal through the analysis of OH stretching bands in diffuse reflectance infrared spectrum measured by in-situ technique.” Energy Fuel, 15(3), 599–610.
Morgan, T. J., and Kandiyoti, R. (2013). “Pyrolysis of coals and biomass: Analysis of thermal breakdown and its products.” Chem. Rev., 114(3), 1547–1607.
Rosenberg, P., Petersen, H. I., and Thomsen, E. (1996). “Combustion char morphology related to combustion temperature and coal petrography.” Fuel, 75(9), 1071–1082.
Sadhukhan, A. K., Gupta, P., and Saha, R. K. (2009). “Characterization of porous structure of coal char from a single devolatilized coal particle: Coal combustion in a fluidized bed.” Fuel Process. Technol., 90(5), 692–700.
Saxena, S. (1990). “Devolatilization and combustion characteristics of coal particles.” Prog. Energy Combust., 16(1), 55–94.
Sheng, C. (2007). “Char structure characterised by Raman spectroscopy and its correlations with combustion reactivity.” Fuel, 86(15), 2316–2324.
Simons, G. A. (1983). “The role of pore structure in coal pyrolysis and gasification.” Prog. Energy Combust., 9(4), 269–290.
Solomon, P., Fletcher, T., and Pugmire, R. (1993). “Progress in coal pyrolysis.” Fuel, 72(5), 587–597.
Solomon, P. R., Serio, M. A., and Suuberg, E. M. (1992). “Coal pyrolysis: Experiments, kinetic rates and mechanisms.” Prog. Energy Combust., 18(2), 133–220.
Wall, T. F., et al. (2002). “The effects of pressure on coal reactions during pulverised coal combustion and gasification.” Prog. Energy Combust., 28(5), 405–433.
Wu, H., Bryant, G., and Wall, T. (2000). “The effect of pressure on ash formation during pulverized coal combustion.” Energy Fuel, 14(4), 745–750.
Yu, J., Harris, D., Lucas, J., Roberts, D., Wu, H., and Wall, T. (2004). “Effect of pressure on char formation during pyrolysis of pulverized coal.” Energy Fuel, 18(5), 1346–1353.
Information & Authors
Information
Published In
Journal of Energy Engineering
Volume 144 • Issue 3 • June 2018
Copyright
©2018 American Society of Civil Engineers.
History
Received: May 23, 2017
Accepted: Oct 2, 2017
Published online: Mar 9, 2018
Published in print: Jun 1, 2018
Discussion open until: Aug 9, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.